A centre-tap full-wave rectifier (CT-FWR) is operated from a (60 Hz), (110 V,ms) line voltage through a transformer with turn ratio of = 2). It has a (2 k 2) load resistance. Assume Si diodes. 1. What minimum value of capacitance is required if the ripple must be no greater than 1%? 2. If the filter capacitor is changed to a (470 µF), what is the required load resistance to give the same ripple of 1%. 3. Determine the DC voltage on the load side. 4. What is the power dissipated and minimum PIV of each diode? 5. Draw the circuit diagram with output voltage waveform.

A centre-tap full-wave rectifier (CT-FWR) is operated from a (60 Hz), (110 V,ms) line voltage through a transformer with turn ratio of = 2). It has a (2 k 2) load resistance. Assume Si diodes. 1. What minimum value of capacitance is required if the ripple must be no greater than 1%? 2. If the filter capacitor is changed to a (470 µF), what is the required load resistance to give the same ripple of 1%. 3. Determine the DC voltage on the load side. 4. What is the power dissipated and minimum PIV of each diode? 5. Draw the circuit diagram with output voltage waveform.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q10
Difference Between derivatives differential differe vatiation
Define and differentiate HPLC and Reverse Phase LC
jwt -jwt dt e CS Scanned with CamScanner
1
What is the accuracy of Glass Thermometer? O a. ± 0.1% O b. ± 1% C. ± 2% O d. ± 0.01%
If the load resistance is increased by 25%, the noise voltage will: Select your answer. increased by 12% decreased by 88% increased by 88% decreased by 12%
7. How many users are supported in IS-95 for each 1.25 MHz? a) Eight b) Sixty four c) Sixteen d) Twenty five
If Iab is equal to 292.717∠52 and Ib is 169∠262, Ic should be please answer using electromagnetics phasor with 3 dec finals ans
DDD A
An available channel for FM transmission is 64 kHz wide. The maximum allowable modulating signal frequency is 3.5 kHz. What should be the deviation ratio? Round the final answer to two decimal places
Note: Please don't write by handwriting.