A catchment area which is having a slope of 2.8% and a clay loam soil has four gauging stations. The distance of GS1 to GS4 is 450km, GS1 to GS2 is 242km, GS2 to GS3 is 235km, GS3 to GS4 is 486km, GS1 to GS3 is 750km, and GS4 to GS2 is 741km. The rainfall depths recorded per year in GS1. GS2, GS3, and GS4 are 245mm, 215mm, 178mm, and 150mm and the corresponding polygon areas of each gauging station is 50,845 hec, 480km2, 750km2, and 640km2. respectively. Determine the gross irrigation requirement in m if the crop factor on the area is 0.495 and the pan evaporation is 201mm, the konveyance efficiency is 34%

A catchment area which is having a slope of 2.8% and a clay loam soil has four gauging stations. The distance of GS1 to GS4 is 450km, GS1 to GS2 is 242km, GS2 to GS3 is 235km, GS3 to GS4 is 486km, GS1 to GS3 is 750km, and GS4 to GS2 is 741km. The rainfall depths recorded per year in GS1. GS2, GS3, and GS4 are 245mm, 215mm, 178mm, and 150mm and the corresponding polygon areas of each gauging station is 50,845 hec, 480km2, 750km2, and 640km2. respectively. Determine the gross irrigation requirement in m if the crop factor on the area is 0.495 and the pan evaporation is 201mm, the konveyance efficiency is 34%

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

#10
I need the correct answer
Question 14 Which usually has higher froude number? O deep channel with high velocity deep channel with low velocity shallow channel with high velocity shallow channel with low velocity
A hydrographic survey was conducted on a reservoir to determine its capacity by contour method. The depth of water at sounding point P1 was 10.50m and its elevation at the bottom was computed to be 210.30m. A sounding point P2 at a distance of 35.45m from P1 was observed to have a depth of 3.25m and its elevation at the bottom was determined to be 217.55m. If a subaqueous contour is to be drawn between P1 and P2 with a contour interval 0.50m, how many contours that can be drawn? Select the correct response: 9 15 10 17
C11 3 sig. figures pls:)
(b) Water samples were taken at point A along Sungai Berlian. The results of the analysis are shown below. Based on WQI values, find the class of the river. COD BODS AN pH DO Point A 11.2 3.4 2.7 65.8 6.6 2.5
6- Maximum annual rainfall depth data are fitted with a distribution that is positively skewed (i.e., it has a longer tail to the right). If the mean value for the distribution is 4.22 in, then the rainfall depth with return period 2 years will be (use the next page table): (5 p) (A) Strictly less than 4.22 in (B) Equal to 4.22 in (C) Strictly larger than 4.22 in (D) None of the above
92 25° 3.0m 9₁ = 300 kN/m 3.0m A 3.5m Ao₂
Question: The project flow rate determined according to the stream yield will be transmitted through a rectangular channel in the shape of Q = 10 m3 /s. The Manning coefficient was determined as n = 0.04 according to the covering material of the channel and the longitudinal base slope of the channel was determined as 10 = 0.0015 according to the topographic characteristics of the land. Determine the channel bottom width (B) and flow depth (h) with the concept of the most appropriate cross section. h В
The following depth-area data is available for Lake Youngs in the State of Washington: Depth (m) 14 28 31 Area (m?) 2,830,000 2,405,500 1,188,600 424,500 (a) Determine the volume of the lake when it is filled. (b) If the lake is vertically stratified into two layers at a depth of 10 m, determine the volume of the surface (epilimnion) and bottom (hypolimnion) layers.
A hydrographic survey was performed on Lake Chui. Upon processing the data it was found that the cross sectional area of the lake can be modelled as a function of the depth using equation:A=84.9+8.4h+4.0ℎ2a. Assume value of depth of water then calculate the capacity of the lake in ?3b. Calculate the increase in capacity of the lake if the heavy rainfall caused the depth to the rise by 2 meters of your assumed depth in ?3
a) Briefly list the steps in deriving a unit hydrograph using the measured wadi-flow and the gross rainfall. b) An approximate boundary of a watershed and the river network are shown in the following figure. A set of contour lines drawn based on elevation data is also given on the same figure. If the catchment averaged curve number is ( the 2-hr SCS-triangular unit hydrograph. 71.6125 - ), calculate the peak-flow (in cfs) of 600 m 550 m 500 m River Catchment boundary ----- Contours 450 m 400 m 2 4 6 km