Q45. A river discharges 2500 cumecs. The rugositycoefficient of the river bed is 0.028. If a modelof the river is made adopting a horizontalscale ratio 1:1000 and a vertical scale ratio1:75, calculate the discharge in model and therugosity coefficient of its bed.

Answered: Image /qna-images/answer/5d9b7e68-65f7-4baa-ab29-da230553a89a.jpg

Q45. A river discharges 2500 cumecs. The rugosity coefficient of the river bed is 0.028. If a mode of the river is made adopting a horizonta scale ratio 1:1000 and a vertical scale ratic 1:75, calculate the discharge in model and the rugosity coefficient of its bed.

Q45. A river discharges 2500 cumecs. The rugosity coefficient of the river bed is 0.028. If a mode of the river is made adopting a horizonta scale ratio 1:1000 and a vertical scale ratic 1:75, calculate the discharge in model and the rugosity coefficient of its bed.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

4. A river stage is readily measured by reading a USGS stream gage placed in the riverbed. During a storm event, the stage can be measured directly. From this, a discharge hydrograph can be inferred.The following stage levels were measured during a storm event: Analysis of this river revealed adischarge-stage correlation of Q = 12.43h2.658, where Q = discharge (m3/s) and h = stage (m).Provide both a stage hydrograph and a discharge hydrograph for this storm event.Clearly mark all axes and give each graph a title.
3) You are assigned to determine the Manning's n coefficient for sagebrush. In eastern Oregon where sagebrush grows, you construct a long trapezoidal channel with a bottom width of 10 feet, 1:1 side slopes, and a 0.001 longitudinal slope. You plant sagebrush on the bottom of the channel. For a uniform flow of 13 cfs the water depth is 1 foot. What is Manning's n? Your result is dependent on several choices you made in setting up the experiment, list two independent ones. If you were to change these, the value you calculate would change. lo ft
(Use Gumbel method) A river has following character: Average Q = 10,000 m^3/sec Standard deviation S = 3,000 m^3/sec What is the annual probability for discharge exceeding 15,000 m^3/sec? 0.064 0.47 0.22 0.3 0.21 0.022
A weir installed at the end of a rectangular channel controls the flow of water. The rate of flow is 0.62 m^3/s. If the error in measuring the head is 0.018m, determine the percentage error in the measured flow if the weir is a suppressed rectangular with L = 4.5m. A) 16.98% B 15.58% (c) 12.21% (D) 14.32%
A concrete dam and the flow net are shown in the Figure below. The following parameter are-5 3 given as: Nd=12, Nf=3.8, k=2.6X10 m/sec, and Ɣsat=19.5 kN/m .a) Calculate the total quantity of water lost by seepage in m3/day.b) What is the water quantity for each flow channel?c) What is the reading of pizometer if its location 1.5 m above datum?d) What is the factor of safety against piping at the down stream?
Consider an impounding reservoir that is expected to provide for a constant draft of 448 million gallons per year. The following record of monthly mean inflow values is representative of the critical or design period .Find the storage requirement. • Mo= Month , I = Observed inflow Мо F A M J A N J F 54 90 10 7 8. 28 42 108 92 22 50 2. Σ 31
Q1: A hydraulic structure on a stream has been designed for return periods of 50 and ST 100 years. Maximum recorded floods in the stream are given below. Estimate the peak floods for the two return periods above, by using Gumble method. Year 1990 1991 1992 1993 1994 1995 1996 1997 1998 1999 2000 2001 Max. 115 128 142 99 79 71 85 102 145 flood, 153 78 50 m³/sec
Figure 4. Problem 4 Illustration. Problem 5. Bonus Question: Reynolds Transport Theorem. The rectangular channel shown is 1.5 m wide. What is the discharge in the channel? Vertical depth 1 m u = 3 m/s Water 30 Figure 5. Problem 5 Illustration.
use ripple diagram or cumulative mass curve ,estimate the active reservoir capacity to supply average flow on the hydrological data in the image
The annual peak flow data were recorded between 1980 and 2021 at a particular section of a river. Annual peak flows have been transformed into log values and the following statistics are obtained. Mean of log transformed peak annual flows = 3.525 Standard deviation of log transformed peak annual flows = 0.178 Skewness of log transformed peak annual flows = -0.235 a. Estimate the 2% AEP peak discharge by assuming that the annual peak flow data follows Log-Pearson type III distribution. b. Estimate the 2% AEP peak discharge by assuming the peak flow data are lognormally distributed. c. Compare the peak discharge obtained from two methods (l.e. Log-Pearson type III distribution and Lognormal distribution).
Route the following flood through a reach for which K = 22 h and x = 0.25. Plot the inflow and outflow hydrographs and determine the peak lag and attenuation. At t = 0 the outflow discharge is 40 m/s. 0 12 24 Time (h) Inflow (m³/s) 40 65 165 250 240 205 170 130 115 36 48 60 72 84 96 108 120 132 144 85 70 60 54
From the historical records of a river strearnflow, the mean daily discharge and related standard deviation are 3 78 m3 Is and 92 m3 Is, respectively. Also, the Jagone and Jag-two autocorrelation coefficients are 0.81 and 0. 70. Generate AR(l) and AR(2) models. For a recorded time series, the strearnflow values on day I and day 2 are 321 m3 /s and 385 m3 /s, respectively. Using the two models, determine the mean and standard deviation of predicted strearnflow on day 3.