A canal supplies water to an area growing wheat over 100 hectares. The duration between the first and last watering is 120 days, and the total depth of water required by the crop is 35 cm. The most intense watering is required over a period of 30 days and requires a total depth of water equal to 12 cm. Assuming precipitation to be negligible and neglecting all losses, the minimum discharge (in m³/s, rounded off to three decimal places) in the canal to satisfy the crop requirement is

A canal supplies water to an area growing wheat over 100 hectares. The duration between the first and last watering is 120 days, and the total depth of water required by the crop is 35 cm. The most intense watering is required over a period of 30 days and requires a total depth of water equal to 12 cm. Assuming precipitation to be negligible and neglecting all losses, the minimum discharge (in m³/s, rounded off to three decimal places) in the canal to satisfy the crop requirement is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

design a river intake given the winter flow is 30 mgd and the summer flow is 55 mgd and the depth durring summer is 8ft and the depth for winter is 15ft.
Q/ A small sewage pumping station with two identical pumps is to be selected for an average flow of 400 m/day. The minimum flow rate is one quarter the average and the maximum 150 percent of average. Determine the working volume required, the pump capacity, and the cycle time at maximum and average flow. The minimum cycle time is 5 min and the minimum running time 2 min.
NaOCI pumping rate, Qss = () L/s? (*No unit) Qin = 8000 GPM Cin = 0.0 mg/L Slip Stream Qss = ? L/s Css = 200 mg/L Main service line Qout = 8000 GPM Cout = 4.0 mg/L %3D
A storm of 0.5 in/hr falls on a watershed with three time area blocks: (A: Area =100 ac, time to gage 1 hr, B: Area = 200 ac, time to gage = 2 hours, and C: Area - 300, and time to gage = 3 hours), Determine the discharge at the end of the third hour using the time area method: O a. None of the above O b. 200 cfs O c. 300 cfs Od. 100 cfs
Q5) a - A tile drain caters an area of 25 hectares and has a drainage coefficient of 1.3cm. If the drain flows for five days at the design capacity, determine it's discharge and the quantity of water removed.
Solution needed explanation also
6. A company spilled a contaminant that got into the water distribution system of a small town, which has an average flow of 100,000 gpd. The contaminant infiltrated a pipe 1,500 ft from the storage tank, and the concentration at the infiltration point is 5 mg/L. The storage tank has a volume of 125,000 gallons and the first user is 500 ft from the storage tank. Assume velocity of 2.5 ft/s in pipes, and a rate constant of 3/day. What is the concentration at the first user?
2. Calculate the discharge (Q) of each Pire Dに1m O2=0.6 m D3=1.2 m fr =0.02 f3 =0.023 12om 1oom 1=1940 レ6o0 28m レ31845
Question 4 A 6-hour unit hydrograph is having triangular shape with peak ordinate of 30m³/sec and base width of 64 hours. The equilibrium discharge obtained by using this 6-hour unit hydrograph is A 185 m³/sec B 175 m³/sec
please Solve only III and IV
Wasterwater Engineering Civil engineering
Dechlorination contact tank (Wastewater Treatment) An activated sludge plant has a design flow (average daily flow) of 11 MGD. Determine dimensions of dechlorination tank. The design parameters: use 1 tank. detention time = 30 sec, depth = 10 ft, rectangular tank: L = 4 W. use maximum hourly flow (3 * Average design flow)