A box measuring 50 cm x 50 cm × 50 cm is filled to the top with dry coarse aggregate of mass 187.5 kg. The water absorption and specific gravity of the 2.5, 0.5% and aggregate respectively. The maximum quantity of water (in kg, round off to 2 decimal places required completely) is are to fill the box

A box measuring 50 cm x 50 cm × 50 cm is filled to the top with dry coarse aggregate of mass 187.5 kg. The water absorption and specific gravity of the 2.5, 0.5% and aggregate respectively. The maximum quantity of water (in kg, round off to 2 decimal places required completely) is are to fill the box

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Moving to another question will Sav estion 14 There are two sources of aggregates (A, B). A sample has been taken from both sources and measured their mass as shown in table b Aggregate A 500 Aggregate B 600 564 480 Measurement Wet mass (9) Oven-dry mass (g) (a) Determine the total moisture content for the samples from both aggregate sources, respectively. (b) Determine the total moisture content for an aggregate blend with 30% of aggregate A and 70% of aggregate B. Attach File Browse Local Files Browse Content Collection
CapsL 8 A Determine the range of final gradation of selected aggregates to prepare the job mix formula for binder course of a mixing plant according to data indicated in table below? Use the following tolerances: ± 6 % for 4.75 mm and above aggregate sizes, ± 4% for 2.36 and 0.30 mm aggregate sizes, and ± 2 % for 0.075 mm aggregate size. Note: use first try with 30%, 35%, 30% and 5% for groups A, B, C and D, respectively. Sieve Size 25 19 12.5 9.5 4.75 2.36 0.3 0.075 A (30%) Coarse Aggregate 100 99 56 31 4 0 0 0 % Passing B (35%) Natural Sand 100 100 100 100 100 89 15 4.2 C (30%) Crushed Sand 100 100 100 100 92 56 9 5 D (5%) Filler 100 100 100 100 100 100 97 88 Specification 100 90-100 76-90 56-80 35-65 23-49 5 19 39 Job Mix Formula Job Mix Formula Limitation 13.6
4-33. Following are results of gradation tests on three aggregates: Aggregate A 100% 92% 41% 19% 7% 4% 2% 1% Passing 25 mm (1 in.) 19 mm (3/4 in.) 9.5 mm (3/8 in.) 4.75 mm (No. 4) 2.36 mm (No. 8) 600 μm (No. 30) 300 μm (No. 50) 75 μm (No. 200) Aggregate B 100% 77% 60% 42% 36% 28% Aggregate C 100% 96% 79% 40% 16% 3% Combine these to give a gradation falling approximately in the center of the specification given in Section 4-5.1.
pls answer soon
Aggregate from three sources having bulk specific gravities of 2.90, 2.70, and 2.60 was blended at a ratio of 60:30:10 by weight, respectively. What is the bulk specific gravity of the aggregate bled? Select one: O a. 2.87 O b. 2.81 O c. 2.75 O d. 2.65
Making concrete cylinder at cement cubes What are the possible discussion in this result attached photo?
2) Two aggregates (Al and A2) were obtained from the field. They were brought to the oven dry condition (OD) and weighed. Data for each of the aggregates is presented in the table below. (Density of water=1g/cm') Table 1. Absorption capacity and moisture content data. A1 A2 Field Weight 600 g 600 g 598.3 g Oven Dry Weight Absorption Capacity (%) 0.6 % 595.3 g 0.7% a) Describe the field moisture state of each aggregate, Al and A2 (i.e. wet, SSD, or air dry). For each sample would you add water or dry the sample to bring it to SSD state? Determine the expected mass of each sample in the SSD state. b) If the bulk volume Al oven dry is 220 cm and the bulk volume of A2 oven dry is 250 cm2, determine the bulk oven dry specific gravity for each aggregate, Al and A2. MONSTER E12 PRT SC PAUSE う

For a natural raw water containing the following water quality in the table. Check lecture 05 slides on page 52 to determine how much slaked lime is needed remove all hardness. Atomic weight or molecular Concentration weight (g/mol) 120 mg/L 100 mg/L as CaCO3 25 meg/L Ca2+ 40 Mg2+ HCO3 24 61 O A. 5 meq/L О В. 700 mg-СаСОЗ/L O C. 15 meq/L O D. No lime is needed.
if total sample mass of aggregate is 164.9 grams, then the percent passing from sieve size #30 only is equal to ………………
A box measuring 50 cm x 50 cm x 50 cm is filled to the top with dry coarse aggregate of mass 187.5 kg. The water absorption and specific gravity of the aggregate are 0.5% and 2.5, respectively. The maximum quantity of water (in kg, round off to 2 decimal places) required to fill the box completely is bris
Given: w0=2140g, w1=2350g, w2=1105g. What is the absorption of the given coarse aggregate?
A box measuring 50 cmx50 cmx50 cm is filled to the top with dry coarse aggregate of mass187.5 kg. The water absorption and specific gravity of the aggregate are 0.5 % 2.5, respectively. The maximum quantity of water (in kg. round off to 2 decimal places) required to fill the box completely is