A block of mass m containing a net positive charge q is placed on a smooth horizontal table which terminates in a vertical wall as shown in figure. The distance of the block from the wall is d. A horizontal electric field E towards right is switched on. Assuming elastic collisions (if any) the time period of the resulting oscillatory motion is second. (Take m = 10-3 kg, d = 2m, q = 10- C, E = 1V/m) %3D %3D E

A block of mass m containing a net positive charge q is placed on a smooth horizontal table which terminates in a vertical wall as shown in figure. The distance of the block from the wall is d. A horizontal electric field E towards right is switched on. Assuming elastic collisions (if any) the time period of the resulting oscillatory motion is second. (Take m = 10-3 kg, d = 2m, q = 10- C, E = 1V/m) %3D %3D E

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A uranium nucleus is a sphere of radius 7.4x10^-15 m with a charge of 92r distributed uniformly in its volume.Calculate the electric field produced by this charge distribution at a) r=3x10^-15 m and b) r=8x10^-15 m
Two balls of charges q₁ and 42 initially have a velocity of the same magnitude and direction. After a uniform electric field has been applied for a certain time interval, the direction of first ball changes by 60° and the ve- locity magnitude is reduced by half. The direction of velocity of the second ball changes thereby 90°. In what ratio will the velocity of the second ball change? Determine the magnitude of the charge-to-mass ratio of the second ball if it is equal to a₁ for the first ball. Ignore the electrostatic interaction between the balls. 91 mi EA V EA 92 m2 Initial condition Fig. EA VV 560⁰ V 90° Final condition
Pls asap
A plastic rod 1.4 m long is rubbed all over with wool, and acquires a charge of -5e-08 coulombs. We choose the center of the rod to be the origin of our coordinate system, with the x-axis extending to the right, the y-axis extending up, and the z-axis out of the page. In order to calculate the electric field at location A = m, we divide the rod into 8 pieces, and approximate each piece as a point charge located at the center of the piece. h b d j zero magnitude (a) What is the length of one of these pieces? (b) What is the location of the center of piece number 2? m. (c) How much charge is on piece number 2? (Remember that the charge is negative.) coulombs (d) Approximating piece 2 as a point charge, what is the electric field at location A due only to piece 2? N/C (e) To get the net electric field at location A, we would need to calculate E due each of the 8 pieces, and add up these contributions. If we did that, which arrow above would best represent the direction of the net…
Three charges are placed at the corners of a square of side 40 cm with 1.0 μC at (0.00 m, 0.00 m), 1.0 μC at (0.00 m, 0.40 m) , and - 1.0 μC at (0.40 m, 0.00 m). Find the direction of the electric field at the fourth corner (0.40 m, 0.40 m) in degrees counter-clockwise from the +x-direction.
A ball with charge (1.200x10^1) µC hangs from a string in a horizontal electric field E=(1.47x10^2) N/C. If the string hangs at an angle θ=(3.3000x10^1)°, what is mass of the ball? Give your answer in grams to 3 sf.
A square insulating plate, 2 meters by 2 meters, lies flat on the floor. A total charge Q=8 x 10-8 C is distributed uniformly on the sheet. A pith ball (a small non-conducting ball made of a light spongy plant material called "pith"), also with charge Q = 8 x 10-8 C, is fixed 50 cm directly above the center of the plate. Point A is located 5 cm from the plate, directly below the pith ball, as shown. ++ Pith ball 0.050 m XA 0.50 m a) What is the electric field at A due to the plate (magnitude and direction)? b) What is the electric field at A due to the pith ball (magnitude and direction)? c) What is the net electric field at A (magnitude and direction)? d) What force (magnitude and direction) would an electron experience if it were located at point A?
To avoid covid-19 infection, a man was seen spraying disinfectant into the air. The man wipes then sprayed the table. A minute after, aerosol was seen floating above the surface of the table. Assuming that the aerosol and the table are identically charged (+) and the aerosol afloat 4.1 mm above the surface of the table due to repulsive force. Find the charge of both table and aerosol if the mass of the aerosol is estimated to be 7.4 nanogram.
A plastic rod 1.3 m long is rubbed all over with wool, and acquires a charge of -5e-08 coulombs. We choose the center of the rod to be the origin of our coordinate system, with the x-axis extending to the right, the y-axis extending up, and the z-axis out of the page. In order to calculate the electric field at location A = m, we divide the rod into 8 pieces, and approximate each piece as a point charge located at the center of the piece. 2 3 4 5 7 8 j zero magnitude physPad (a) What is the length of one of these pieces? l = 0.1625 Operations Symbols (b) What is the location of the center of piece number 3? Relations C X m. Sets Vectors In e (c) How much charge is on piece number 3? (Remember that the charge is negative.) Trig -6.25e-09 coulombs 10" log Greek Help (d) Approximating piece 3 as a point charge, what is the electric field at location A due only to piece 3? |미 o! X N/C (e) To get the net electric field at location A, we would need to calculate E due each of the 8 pieces,…
Problem: A physicist has a device which produces a steady stream of identical charged particles with a mass of 9.0×10-7kg and an unknown electrical charge. This beam is fired horizontally into a region of uniform electric field and the value of E is adjusted until the beam travels perfectly straight (does not deflect downwards because of gravity). The value at which this occurs is E=5000 N/C downwards. From this information, determine (a) the charge (magnitude and sign) of the particles and (b) describe what happens to the energy of the {particle, field} system as the particles move. draw a sketch show all mathematical equations evalutaiton of all steps
Silicon wafers are made to create the most groundbreaking invention of mankind - microprocessors. If two silicon wafers (assume dipoles), both with masses of 125 g, radii of 10 cm and thickness of 7 × 10-6 m are placed close to each other, separated by a distance of 3 cm, what is the electric field strength experienced by an electron placed on the surface of the negatively charged wafer? What is the final velocity of the electron upon reaching the positively charged plate? How much power is generated by the electron in its travel?
Please Asap