A bicycle is lifted off the ground and placed on a stand so that maintenance can be performed. This allows the front wheel to spin freely along its axle. The wheel has a reflector (m1 = 40 g) located R1 = 25 cm radially outward from the center. There is also a pebble with mass m2 stuck in the tire treads and located R2 = 33 cm radially outward from the center. The wheel is rotated until it reaches a position of equilibrium; at this moment the reflector is located at the 5 o’clock position, and the pebble is located at the 9 o’clock position. What is the mass m2 of the pebble? please draw a representation too

A bicycle is lifted off the ground and placed on a stand so that maintenance can be performed. This allows the front wheel to spin freely along its axle. The wheel has a reflector (m1 = 40 g) located R1 = 25 cm radially outward from the center. There is also a pebble with mass m2 stuck in the tire treads and located R2 = 33 cm radially outward from the center. The wheel is rotated until it reaches a position of equilibrium; at this moment the reflector is located at the 5 o’clock position, and the pebble is located at the 9 o’clock position. What is the mass m2 of the pebble? please draw a representation too

Similar questions

A bar of length 3.00 m is hinged at one end and experiences a force of 8.00 N at the other end. The torque applied is 10.0N⋅m. What must be the angle between the line of force and the extended line of the bar ϕ?
(a) A person opens a 1.20 m wide door by pushing on it with a force of 57.5 N applied at the center of the door, at an angle perpendicular to the door's surface. What magnitude of torque (in N · m) is applied about an axis through the hinges? _________N · m (b) A man opens the same door, using the same force, again directed perpendicular to the surface, but now the force is applied at the edge of the door. What magnitude of torque (in N · m) is applied about the axis through the hinges now? _________N · m
An 80 cm long thin rod whose axis of rotation is in the center has a mass of 0.142 kg. A 2.5 N force is applied at one end perpendicularly, while a second 1.5 N force is applied 10 cm from the opposite end. Both forces are applied in the same direction. (a) Find the angular acceleration. (b) Determine the force needed for the rod to be in equilibrium, if the third force is applied at a 300 angle halfway between the 2.5 N and the axis of rotation. (72.6; -5.5)
The spool has a mass, m, and a radius of gyration, kG. An inextensible is wrapped around the inner diameter of the spool and is attached to the wall a point A. The coefficient of friction between the floor and the spool is mu. If the spool has the initial angular velocity given as omega naught, how far will the center, G, move before stopping?
A ladder leans against a wall at an angle 0 above the horizontal as shown in figure. The ladder is uniform with mass M and length L. Assume that the ladder is at rest due to friction between the ladder and ground. What i the torque exerted by gravity on the ladder about the axis of rotation shown (horizontal and parallel to the wal axis through its base)? (A) zero (B) Mg cos 0 (C) MgL (D) MgL cos 0 (E) MgL sin e (F) MgL G) Mg sin 0 H) One needs the coefficient of friction to answer this problem axis of
The flywheel of an engine has moment of inertia 1.60 kg . m2 about its rotation axis. What constant torque is required to bring it up to an angular speed of 400 rev>min in 8.00 s, starting from rest?
(a) A woman opens a 1.35 m wide door by pushing on it with a force of 44.5 N applied at the center of the door, at an angle perpendicular to the door's surface. What magnitude of torque (in N · m) is applied about an axis through the hinges? (b) A girl opens the same door, using the same force, again directed perpendicular to the surface, but now the force is applied at the edge of the door. What magnitude of torque (in N · m) is applied about the axis through the hinges now?
In an experiment a mass of 50.00gm is attached to string wrapped around the axle of flywheel and starting from rest, falls through a distance of 169.00cm in 3.12 seçonds. The diameter of the axle is 12.0cm. What is the acceleration of the falling mass? What is the angular acceleration of the flywheel? What is the tension in the string? What is the torque acting on the flywheel due to tension? What is the moment of inertia of the flywheel, neglect the friction?
Given, TT = TlT = Tlsin(0), at what angle ) will torque be maximized? O deg 30 deg 60 deg 90 deg
A bicycle with 41.60 cm diameter wheels is traveling at 22.40 km/hr. At what angular speed do the wheels turn? How long do they take to turn once around?
A uniform disc of mass 3.0 kg and radius 25 cm is mounted on a fixed horizontal axle. A block with mass 1.8 kg hangs from a light cord that is wrapped around the rim of the disc. What is the angular acceleration of the disc?
A person exerts a horizontal force of 30 N on the end of a door 92 cm wide. a) What is the magnitude of the torque if the force is exerted perpendicular to the door? b) What is the magnitude of the torque if the force is exerted at a 70.0 ∘ angle to the face of the door?