A beam is shown in the figure below, and the flexural stiffness of the beam section is constant EI: Use the conjugate beam method (Moment-area Method) to obtain the slope (Slope) after the deformation of point A and the vertical displacement (Deflection) of point C   *The correct answer is 24 kN-m2/EI clockwise and 58.7 kN-m3 /EI down, but I need to calculate steps, thanks

Q: For the cantilever steel beam [E = 200 GPa; l = 129 × 106 mm²] shown in Figure, use the double-…

A:

Q: For the cantilever steel beam [E = 220 GPa; I = 83 x 106 mm4), use the double-integration method to…

A:

Q: 5. Two hard rubber blocks are used in an anti-vibration mount to support a small machine as shown in…

A: Given Data : P = 150 lb Downward deflection = 0.25 in. a = 0.5 in., b = 1.0 in. and c = 2.5 in. To…

Q: Part 2: for the frame shown below, P=20 kN and a=2 m, Assume I=20000 in and E=30,000 ksi for all…

A: Given:P = 20 kNa = 2mI = 20000 in4E = 30000 ksiRequired:Vertical deflection of E

Q: For the beam and loading shown, use the double-integration method to determine (a) the equation of…

A: To find maximum deflection and it's location

Q: PROBLEM 03: Determine the shear modulus of the body shown in the figure if the top and bottom…

A: Given data  Width (B) = 150mm  Length (L) = 400 mm  Height (H) = 200 mm  Displacement (∆h) = 2.5mm…

Q: The part shown below is formed from 3-mm diameter steel wire with R = 40 cm. A force is applied with…

A: Given data in question  Load Dimensions  Diameter  Radius To find out  Horizontal deflection at C…

Q: A R₁ = 8.2 kips -8'- B + -8'- 15 kips C D RD = 9.5 kips -8'-

A:

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.