A beam has a combination ofa distributed and multiple concentrated 1oads as shown in the image below. For the entire hean, araw böth the shear bending moment di agrams. Addlitionaly what 18 nmaximum absolute value of both the shear t bendling moment? a016/1n ja516 A E 9in 12in 12in Tain

Q: Determine the equation of the influence line for the reaction at A in the continuous beam shown in…

A: By Muller Breslau method, As we have to find the reaction at end A, hence Support at A will be…

Q: 5.1 The recommended scales for use on technical drawings are specified in the following table.…

A: To find: Choose the suitable code for the given scales for use on technical drawings.

Q: Determine external as well as total indeterminacy

A: Given data : Number of External support reaction (R)=2+2=4Number of member (m)=6Number  of joint…

Q: Determine the centroid of the shaded area shown, which is bounded bythe X axis and the parabola y? =…

A:

Q: For the given structures, determine the degree of indeterminacy. 7. A 7

A:

Q: Write the IUPAC name for   compound.

A: International Union of Pure and Applied Chemistry (IUPAC)) is the naming pattern or nomenclature…

Q: Explain the formula of fs

A: From the original solution: Given: Width, b = 18 in Effective depth, d = 26.5+2.5=29 in. Height of…

Q: A clockwise couple M = 4.5 N m is resisted by the shaft of the electric motor. (Figure 1) Part A…

A: Given: The moment M is 4.5 N.m. Consider the figure,

Q: 6 in Gin Gin 9 in 3in

A: Schematic diagram of the given problem:

Q: XXXX W₂ W₁ Which of the following most nearly gives the external degree of indeterminacy? 2 4 O 1

A:

Q: continue the last part

A: Data for pump performance curve is given. We need to select which pump combination would work for…

Q: What is the Ix and Iy of the cross-section in mm4

A: Given: Required : Ix and Iy of the cross-section in mm4

Q: show the (c)

A:

Q: 1. Y 3" r= 3" 4" 1" 2"

A:

Q: Problem 12.16 Consider the building frame shown in (Eure) Suppose that My 2.6 k/ft and s8 k/ft.…

A:

Q: For the given structures, determine the degree of indeterminacy. 1. ♫

A: This question is related to the Structure analysis

Q: Q4: Convert the following into required: 1- An area 4.2 cm on amap with scale 1/5000 > Don , Olk,…

A:

Q: HI, KINDLY IDENTIFY WHERE IS THE ANSWER FOR LETTERS A TO G.

A:

Q: Determine external indeterminacy

A: Given data : Number of external support reaction (R)=2+1+1+2=6

Q: Draw shear force diagram

A:

Q: -0129 -077 R26

A:

Q: Find the centroid of X and Y in tabular form.

A: A centroid is a point on the body on which the mass of a body is uniformly distributed. If the body…

Q: The block of mass m1 = m0 is attached to a spring of elastic constant k = (m0g)/H and natural length…

A:

Q: * .I don't like this," said Ali“ Correct Incorrect

A: The correct punctuation marks for this be like this "I don't like this," said Ali.

Q: Define phreatic surface.

A: The term phreatic is used in hydrology and the earth sciences to refer to matters relating to ground…