Answered: A balanced three phase A- connected…

A balanced three phase A- connected load has a line voltage of 2500 <0°> Vrms , and absorbs an average power of 950.2 KW at unity power factor. The phase current at the load is:

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: nts ce The voltage and current of an ac circuit are as follows: e = 141. sin (377t + 10) V and i =…

Q: BASIC POWER ELECTRICAL ENGINEERING course.

Q: A voltage of 200 253"8' is applied across to impedances in parallel. The values of impedances are…

Q: 6. For the circuit shown, the real average power absorbed by load at phase A is...W. Take Van as…

Q: in the following circuit the complex power by each phase is 0.1+ j0.22 + (),1+ j0.22 480V rms b B…

A: Complex power/Apparent Power: The product of Voltage(v) and current(I) in the circuit is called as…

Q: In an alternator delivering lagging pf load, the excitation emf leads terminal voltage by the power…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a…

A: Given load impedance, ZL=40-j30° On comparing with ZL=R-jXC

Q: For the circuit show below, solve for the following: a. The complex power delivered to each passive…

Q: A 200 V single phase circuit has an apparent power of 5 kVA and a reactive power of 4 kVAr. Then…

A: We have Single phase Circuit with, Apparent Power(s) = 5 KVA Reactive Power (Q) = 4 KVAr And We…

Q: There is an installation with two equal three-phase loads of 150 kW each and a power factor of 0.9…

A: Voltage and current at different loads R-Load - There is no phase difference between voltage and…

Q: Two loads are connected in parallel to a source of emf whose voltage is (110 + j63.5). if the branch…

A: In this question, We need to determine the total current, equivalent impedance, total power and…

Q: Problem 6: Given the circuit below, find the total complex, average, and reactive power absorbed by…

A: In this question, We need to determine the total complex power, average power and reactive power.…

Q: Three Impedances each of (12 - j20)0 are connected in mesh across a three-phase 415V ac supply.…

Q: j4 2 -j2 0 Vx3 20 +. ZL +)4/0° V

A: In this question we need to find a Zl for maximum average power transfer to Zl

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load draws…

Q: 2) A A-connected balanced three-phase inductive load consumes 3.2 kW at a power factor of 0.5 and…

Q: In Problem # 3, V =120 V and I = e30" A. Plot v(t), i(t), and p(t). Calculate the average power P…

A: According to the question we have to, a) Plot v(t), i(t), and p(t). b)Calculate the average power P…

Q: Given: 1. 2 wye-connected loads per phase to a 3 phase power source 2. first load consists of a…

Q: Two balanced loads are connected to the a 240kVrms 60Hz line as shown in the figure below. Load 1…

Q: A SINGLE-PHASE 230 AC, 60 HZ POWER SUPPLY FEEDS A 2400 WATTS AIR CONDITIONING SYSTEM, WITH A POWER…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: L Fiad the RMS valof the llwing wavefoem 130

A: As per the guidelines of Bartley we supposed to answer first question only since remaining questions…

Q: 4. A single phase load draws a current of 30 / 35 deg A. The voltage across the load is 220/ 75 deg…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 30°, through a…

A: Given data : Load impedance ZL=40-30j Source Voltage Vs=100∠30° inductive reactance XL=60Ω

Q: A star connected reflector supplies a delta connected load. The impedance of the load branch is (8 +…

Q: A load of 120 + j 60 is connected to a source of 120 V with a phase angle of 300, through a…

A: Power factor: It tells how much active power is utilized by the circuit from the apparent power. The…

Q: A 11 KV source is connected to a 12 MVA load with a 0.83 lagging power factor. How much capacitive…

Q: Consider the circuit shown. Find the following: a. Total load impedance seen by the voltage source.…

A: The circuit diagram,

Q: Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of…

A: In delta connection line voltage is equal to phase voltage.

Q: Find the total real power dissipation in a balanced delta-connected system. Phase voltage is 100V…

A: Given: A balanced delta connected system Phase voltage, Vph=100 V Load impedance, Zph=175 Ω Power…

Q: A voltage of 200 L 53°8' is applied across two impedances in parallel. The values of impedances are…

A: In the question, two parallel impedance are connected to voltage source V. Find the value of kVA,…

Q: A 200 V single phase circuit has an apparent power of 5 KVA and reactive power of 4 KVAr. Then find…

Q: The following loads are served by a balanced three-phase source: Load 1: 18 kVA at 0.8 pf lagging…

A: load 3

Q: A 200 ohm resistor is connected to a 5 millihenry inductor at 60HZ. Find the total impedance and the…

Q: A single phase circuit is supplying the two loads, Load1 draws a real power of 450 kW at a power…

A: From power triangle KVA S=Active power (P)power factor(cosθ). and KVA S =…

Q: A balanced Star connected three-phase load draws 150 A per phase with a leading power factor of 0.7…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The apparent power in a three-phase balanced circuit is 150 VA, and the active power is 100 W. What…

A: Given, Apparent power, S=150 VA Active power, P=100 W

Q: A single – phase load of 96 kW with PF of 0.6 lag is connected to a 4.16 kV single – phase network.…

A: In this question, we need to determine the magnitude of current of this load in ampere. We know,…

Q: + 120/45° V rms B

Q: 4. A single phase load draws a current of 30 / 35 deg A. The voltage across the load is 220 / 75 deg…

Q: 160 0.5 H Vo 312.5 µF 4 V R=16 0, L- 0,5 H, C= 312,5 µF Vs(t) - 4 V Vc(t) = Vo(t). Constant voltage…

Q: A single phase circuit is supplying the two loads, Load1 draws a real power of 350 kW at a unity…

A: Given: A single-phase circuit is supplying the two loads, Load 1 draws a real power of 350 kW at a…

Q: A Y-connected balanced three-phase source is connected to a three-phase balanced load through a…

A: In this question, 3 phase balance negative sequence generator supplied to 3 phase balance load via…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

A balanced three phase A-
connected load has a line voltage of
2500 <0°> Vrms , and absorbs an
average power of 950.2 KW at unity
power factor. The phase current at
the load is:
Select one:
a. 126.694<0°> Arms
b. None of these
O c. 219.94<0°> Arms
O d. 308.84<0°> Arms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. A Capacitor bank of a capacitive reactance of 120 ohms is connected in parallel to the load. The power factor at the load is: O A. 0.447 lagging O B. 0.707 leading O C. 0.447 leading O D. 0.707 lagging O E. None of choices are correct
A load of 240 +j 120 is connected to a source of 480 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. A Capacitor bank of a capacitive reactance of 120 ohms is connected in parallel to the load. Total reactive power supplied by the source is: O A. 5760 vars O B. None of choices are correct O C. 1920 vars O D. 1920 vars O E. 3840 vars
A 415 V, 55 Hz 3-phase supply is connected to a 3- phase star connected balanced R-L load each of resistance 14 ohm and impedance 82 ohm. Find the value of inductance in each phase. 41.00 80.80 0.23 8.25
If a three phase load consumes apparent power of 40KVA and active power of 30 KW, power factor of that load is... 0 0.75 1 1.33
A single phase circuit is supplying the two loads, Load1 draws a real power of 350 kW at a unity power factor and Load 2 draws reactive power of 15 kvar at a power factor of 0.74 leading. Find the Apparent power of the Load 1 and Load2.Apparent power of Load1 kVA?Answer for part 1 Apparent power of the load 2 kVA ?
A 415 V, 57 Hz 3-phase supply is connected to a 3-phase star connected balanced R-L load each of resistance 13.63 ohm and impedance 65.27 ohm. Find the value of inductance in each phase. O 63.83 O 0.18 O 32.63 O 7.19
Solve it please fast
Please Answer My Questions in 30 minutes i'm very needed... Please thank u...
2. For the following system shown in the figure, calculate: a. The current through each phase of the load. b. The total real and reactive power of the three-phase load. c. The power factor at the load side. A 220 V 20° 220VL-120° U8 vol 152 I 220 VI20° 9. M.
20) Two AC generators A and B are in Parallel. Each generator has an emf of 1000V per phase and in phase, the phase impedance are ZA = 0.1+j2 ohms, ZB = 0.2+j3.2 ohms respectively. If the common load has an impedance of (2+j1) ohms per phase, solve the voltage per phase at the load
A single phase circuit is supplying the two loads, Load1 draws a real power of 225 kW at a power factor of 0.66 lagging and Load 2 draws reactive power of 35 kvar at a power factor of 0.68 leading. Find the Apparent power of the Load 1 and Load 2. Apparent power of Load 1 kVA? Apparent power of the load 2 kVA?
PLEASE SHOW ALL THE STEPS AND THE WAY OF THE SOLUTION , BECAUSE I WANT TO LEARN HOW TO SOLVE, THANK YOU FOR YOUR UNDERSTANDING