A balanced 3 phase star connected load draws power from a 420 V supply. Two wattmeter's indicate 8200 W and 3900 W respectively, when connected to measure the input power of the load, the reverse switch being operated on the meter indicating the 3900 W reading. Find the following: The Input power, P = The power factor, coso = The line current, IL =

A balanced 3 phase star connected load draws power from a 420 V supply. Two wattmeter's indicate 8200 W and 3900 W respectively, when connected to measure the input power of the load, the reverse switch being operated on the meter indicating the 3900 W reading. Find the following: The Input power, P = The power factor, coso = The line current, IL =

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Given the test circuit below, the wattmeter reads: 2400 watts, the ammeter reads: 14.0 ARMS, and the voltmeter reads: 45.0 VRMS. Determine the following: a) The value of R in ohms b) The value of the source voltage (Vs) in Volts RMS Wattmeter A 12 2 V. -js Q R her online re
The Line Current of a Three phase alternator connected in Delta is 6 Amperes. The Phase current will be (Do not enter the Units write only the numerical Value) Phase Current
B5
In a two-wattmeter method of measuring power in a balanced 3 phase circuit the ratio of the Watt meter reading is 1:2 the circuit power factor is?
The input power to a three-phase motor was measured by two wattmeter method. The readings were 85 KW and – 12 KW and the voltage was 436 V. - Calculate (a) the total power and (a) the power factor. total power 97000 One possible correct answer is: 73 Power factor 0.044 One possible correct answer is: 0.39850866345116
1. Which of the following applies to the instantaneous power in a single-phase ac circuit? A. Constant component B. Time varying component O C. Frequency of time varying component is twice the voltage or current D. All of these
O decreases Clear my choice The Line Voltage of a star connected three phase alternator is 245 Volts. The Phase Voltage will be coil is connected in parallel. In wattmeter, Windows Lu IG 40) ^ hp 19 f10 f11 AA fg fs 10 米 & 7 V 8 3 A
B. Each phase of a star-connected load shown in Figure 1 consists of a resistance of 50 Q in parallel with an inductor of 0.2 H. Calculate the line current, power absorbed, the total kVA and the power factor of the load when connected to a 400-V, 3-phase, 4-wire, 50-Hz supply. RI LI RJ L3
In the two-wattmeter method of power measurement for a three-phase load, the readings of the wattmeter are 2000 W and 1000 W. What is the power factor of the load?
i need the answer quickly
An alternator is connected in star. If the phase voltage is 110 V, the line voltage is *