Two wattmeter's indicate 10 kW and 3 kW respectively when connected to measure the input power to a 3-phase balanced load. the reverse switch being operated on the meter indicating the 3 kW reading. Determine (a) the input power and (b) the load power factor BI 目

Q: Figure 4 shows a balanced Y-connected generator supplies to a balanced delta- connected AC load. The…

A:

Q: 10.21 For a uniform plane wave at 4 GHz, the intrinsic impedance and phase velocity of an unknown…

A:

Q: 9) In a 208 V 3-phase motor load, the current drawn by the motor is 22 A and the PF is 0.6. a) What…

A: Given- For three phase motor load- Voltage, V= 208 Volts Current, A= 22 A Power factor = 0.6 To…

Q: QUESTION 25 If the system base power is 50MVA and the base current is 1000 A, serving a load of 500…

A: 25) Z = impedanceZbase =( Vbase / Ibase ) Zbase = ( MVA rating / I2base ) Zbase = ( 50×106 / 10002 )…

Q: In a 208-V, three-phase motor load, the current drawn by the motor is 25 A, and the PF is 0.87. What…

A:

Q: The number of currents alternating at different time intervals in an alternating current circuit are…

A:

Q: Problem 223: EE Board March 1998 A load of 20 + j35 ohms is connected across a 220 volts source.…

A:

Q: 11.A resistor connected across an AC supply of 220 V. The power drawn is 1000 watts, if the diode…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Part A Find the average power delivered by the ideal current source. Express your answer to three…

A: In this question, we need to determine the average power delivered by the ideal current source.…

Q: A base load station having a capacity of 15 MW and a standby station having a capacity of 19 MW…

A:

Q: What is low power factor wattmeter and what is its use?

A: The instrument which measures the very low factor is known as the low power factor wattmeter (LPFW).…

Q: 4. Three coils are connected in delta across a 240 volt, three-phase supply. The line current is 20…

A: In this question We need to determine the unknown parameters of the given question.  We know In…

Q: 13. A rotary standard with a K, of % whr per revolution and a multiplier of 3 makes 42.4 revolutions…

A: Revolution testing:

Q: A single phase AC motor draws 4.5 A from 220 V electricity. Three various power of the motor from…

A: Given Data Single Phase AC motor I = 4.5 A V = 220 V P = 720 W

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.