A 7/8-in.-diameter bolt, having a diameter at the root of the threads of 0.731 in., is used to fasten two timbers together as shown in Fig. P-129. The nut is tightened to cause a tensile stress of 18 ksi in the bolt. Compute the shearing stress in the head of the bolt and in the threads. Also, determine the outside diameter of the washers if their inside diameter is 9/8 in. and the bearing stress is limited to 800 psi.

Q: For the given riveted connection shown, having the allowable stresses: Fy = 248 MPa Fy = 150 MPa…

A:

Q: 1-66 Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be, if the…

A: Force = 22.3 kN or 22300 NDiameter of shank, d = 12 mm Thickness (t) = 8mm

Q: The five-bolt connection shown must support an applied load of P = 400 N. The thickness of the axial…

A: P = 400 kN t = 1 mm b = 16 mm

Q: The area of the double angle shown is Ag = 5.6 in2. Each angle has a thickness t = 0.25 in. Given U…

A: Double Angle Tension Member Total Gross Area, Ag=5.6 in2 Thickness of angle, t=0.25 in Reduction…

Q: The following image shows a front and side view of the column connection. The bolts have a diameter…

A:

Q: 1-66 Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be, if the…

A:

Q: Six rivets are used in the connection shown in the figure. If both P=50kN, what is the minimum…

A:

Q: The steel shafts are connected together using a fillet weld as shown in the figure below. (Figure 1)…

A: T = 63 N. m

Q: Determine the shear Load that act on the fillet weld that joining two plates together if the working…

A: To find- Shear load

Q: Shear strength value τ = 200 MPa The contents associated with bolts are given. P = 70 kN required…

A: Given, P =70 kNτ = 200 MPa

Q: A bracket shown in the figure 6.9 carries an eccentric load of 30 kN at an eccentricity of 200 mm.…

A:

Q: Determine the required weld size necessary to carry the load P.

A: Solution Dead load(PDL)=360 kN Live load(PLL)=120 kN The centroid of the area is, x=1502=75…