A 70mm vane axial fan is running at 2000rpm delivers 7.5 cubic meter/sec of air against static pressure of 8cm water with input power of 12kW. If the fan wheel diameter is increased with the new power input of 18.1 kW, determine:   a. the new diameter of the fan in mm 67 74 76 b. the new static head in meter of water 8.4 9.4 10.4   c. the new discharge in cubic meter/sec 8.598 9.198 9.598

Q: B- A centrifugal fan connected to air duct system, the static losses in the duct is 100 N/m2 and the…

A:

Q: Problem 2. A garden hose with an attached nozzle is used to fill a container with water. The nozzle…

A:

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

A:

Q: A pump operates at 600 W, the mass flow rate of the liquid is 1 kg/s, at the inlet the fluid is…

A: Given data pump operates at 600 W, the mass flow rate of the liquid is 1 kg/s, at the inlet the…

Q: A hydraulic motor has a displacement of 165 cm³ and operates with a pressure of 98 bars and a speed…

A: Given data: Vd=165 cm3P=98 barsN=1725 rpmQA=0.0055 m3/sTA=210 N.m Need to determine the value of…

Q: 6. Steam enters a pressure reducing valve at a pressure of 2000 kPa, dry saturated. It is throttled…

A:

Q: Shown below is the water jet flow from a pressurized closed tank. The vertical distance between free…

A: Given data: h1=13 mh2=15 mg=9.81 m/s2γ=9.81 kN/m3 Need to determine the velocity at point 2.

Q: 7. A converging-diverging nozzle receives steam at a pressure of 380 psia with temperature of 480F…

A:

Q: Consider the two-tank liquid-level system shown below with cross-sectional areas, A₁ and A2,…

A: To Find:A. The differential equation model for the system behavior in terms of the liquid heights…

Q: B) The air flow to a four cylinder four-stroke engine is 2.15 m³/min. During a test on the engine-…

A: In four stroke engine, there are four strokes which competes the cycle.The four processes are:(i)…

Q: Water is supplied to a pump at a pressure of 200 kPa. The power transferred to the water is…

A: Given data:- Power supplied to pump =30 kW Initial pressure (P1) =200kPa final pressure (P2)=2200kPa…

Q: As shown in the picture blew, a pump can deliver volume flow rate of Q=3.6 × 10-³ m³/s of water…

A: Given data Flow rate = 3.6 ×10^(-3) m^3/sec h= 8.0 m hL= 1.0 m Find the power delivered by the pump.

Q: A pump has a displacement of 95 cm³/rev, rotates at 1160 rpm, and produces an outlet pressure of…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.