A 7.0 kg steel ball of radius 4.0 cm rolls without slipping from rest down a hill of height 3.0 m. The ball continues to roll without slipping on a horizontal surface for a certain distance before striking a spring whose spring constant, k, is 72 N/m. The spring is originally unstretched. The steel ball compresses the spring until it comes to a momentary stop. The ball does not slip on the surface while it compresses the spring. The surface of contact between the ball and the spring is frictionless. Find the maximum compression of the spring in metres.

Q: 6. A simple pendulum of length L = 100 cm is shown in Fig. P6.16. The angular dis- placement 0(t) in…

A: ) comparing with, angular amplitude=0.5 here n=frequency n=0.498 T=2 seconds b) time required…

Q: Consider the system in the figure, in which a small mass m = 1.95 kg is sliding off the top of a…

A:

Q: Engineers are designing a system by which a falling mass m imparts kinetic energy to a rotating…

A:

Q: applied force has a magnitude of 6.3x N, where x is how far the ball has rolled from its initial…

A: Given;-  Mass of the ball = 3.7 kg  velocity of the ball v= 10.5 m/s  Force F = 6.3x N, where x is…

Q: Sara is designing a new ramp for launching ping-pong balls. The ping-pong ball rolls without…

A:

Q: A turntable with a moment of inertia of 0.028 kg∗m^2 rotates freely at 3.3 rad/s. A circular disk of…

A: Given data The initial moment of inertia of the turntable is Ii_t = 0.028 kgm2 The initial angular…

Q: A thin, hollow sphere of mass 1.70 kg and radius 0.640 m is rolling on a horizontal surface with a…

A: Given data The mass of the sphere is m=1.70 kg The radius of the sphere is r=0.640 m The angular…

Q: turntable is initially at rest and is free to rotate about a frictionless, vertical axle through its…

A: given: mw=75 kgITT=750 kg m2r = 3.50 mvw=0.5 m/s

Q: A block is sliding (without friction) down a ramp. A ring, a disc and a solid sphere are rolling…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: f the mass of the bullet is 12.0 g, find (a) the initial speed of the bullet and (b) the energy…

A:

Q: A 750 g hollow ball (spherical shell) is rolling along a horizontal floor at 8 m/s for a distance of…

A: Consider the diagram for the position of the spherical shell, that is the hollow ball, on the…

Q: One end of a light spring with force constant k = 100 N/m is attached to a vertical wall. A light…

A: Given info: The force constant of a light spring is 100 N/m. The mass of pulley is M, the radius of…

Q: A 5 kg ball with a 0.4 meter radius is rolling on a horizontal surface at 3 m/s. The rotational…

A: This question is based on law of conservation of energy and pure rolling motion.

Q: A rotating flywheel has been proposed as a means of temporarily storing mechanical energy in an…

A:

Q: Review. A block of mass m1 = 2.00 kg and a block of mass m2 = 6.00 kg are connected by a massless…

A: Given data: The masses are, The radius of pulley is R=0.25 m. The inclination of wedge is θ=30°.…

Q: In the figure here, a solid brass ball of mass 0.382 g will roll smoothly along a loop-the-loop…

A: mass (m)=0.382 g=0.382×10-3 kgR=0.18 m

Q: A 650 g hollow ball (spherical shell) is rolling along a horizontal floor at 4 m/s for a distance of…

A:

Q: A 700 g hollow ball (spherical shell) is rolling along a horizontal floor at 4 m/s for a distance of…

A: Consider the diagram for the position of the spherical shell, that is the hollow ball, on the…

Q: A solid disk of moment of inertia 0.563 kg m² is spinning about its center of mass at a rate of 10.5…

A:

Q: smaller greater it has a smaller density more of its mass is closer to the rotation axis less…

A: Moment of inertia: The moment of inertia of an object about an axis can be defined as the product of…

Q: The coefficient of friction between mass m 1 and the surface is 0.15. The pulley is a disk and has a…

A:

Q: A simple pendulum is made of a 2 m- string and a bob of mass m. At t = 0, the pendulum is at its…

A:

Q: Consider a ball that rolls smoothly down a slope. The ball is released from rest at the top of the…

A:

Q: solid, uniform bowling ball, 12.7 cm in diameter, starts from rest and rolls down a 7.00 m high ramp…

A: Given Diameter of ball = 12.7 cm = 12.7 × 10-2 m Radius = 6.35 × 10-2 m Angle = 370

Q: *15. D The drawing shows a device that can be used to measure the speed of a bullet. The device…

A: Given data The distance between the two rotating disks is: d = 0.850 m The angular speed of the…

Q: The 25-lb slender rod has a length of 6 ft. Using a collar of negligible mass, its end A is confined…

A:

Q: A thin solid disk of mass 21.6 kg is rotating at 10.6 rad/s about an axis through its center and…

A:

Q: A cord is wrapped around a pulley that is shaped like a disk of mass m and radius r. The cord’s free…

A: Given:- A cord is wrapped around a pulley that is shaped like a disk of mass m and radius r. The…

Q: bowler uses a lane with a coefficient of kinetic friction of 0.156. The bowler releases her 5.30 kg…

A: Given values:- Coefficient of kinetic friction,(μk)=0.156 ----(1) Mass of the ball,(m)=5.30 kg…

Q: A solid ball with mass, M=2.5 kg and radius, R=0.2 meter is released from rest from the top of an…

A: m = 2.5 kg R = 0.2 m Initial velocity (u) = 0 m/s h = 3.5 m

Q: cylinder box 10m

A:

Q: A 3.7-kg sphere is suspended by a cord that passes over a 1.7-kg pulley of radius 3.4 cm. The cord…

A:

Q: A potter's wheel is rotating around a vertical axis through its center at a frequency of 1.8 rev/s .…

A: Given data: Initial frequency of the wheel (f) = 1.8 rev/s.Mass of the wheel (M) = 5.0 kg.Diameter…

Q: The ends of a 9-lb rod AB are constrained to move along slots cut in a vertical plate as shown. A…

A: Given: The spring constant k=3 lbin. The rod is released from θ=50∘.

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.