A 500 kg load on the hydraulic lift is to be raised by pouring oil of density 7800 kg/m3 into a thin tube as shown in figure. Determine value of 'h' in order to begin the raising o the weight (Take g = 10 m/s2) LOAD 500 kg d%31 cm Diameter D 1.2 m

Q: The basic elements of a hydraulic press are shown in the figure below. The plunger has an area of 1…

A: In the given problem a plunger and piston arrangement is shown, we have to find the load (F2) that…

Q: A dead-weight tester is used to calibrate a pressure transducer by the use of known weights placed…

A:

Q: The tank shown has one curved surface restraining a body of static fluid, with the following…

A: To determine the magnitude of the resultant force on the curved surface.   Given, Width of the tank…

Q: A beam-spring system is shown L = 5m EI-2.5 × 10³ kN-m² figure below. heee 000 k = 40 kN m-10 kN k=…

A: For given spring-beam system,Initial displacement of 5 mmInitial velocity: 135 mm/sto find the…

Q: During the construction of a dam, concrete was poured into a lift of approximately 1.8 m (yı = 1.8…

A: Given: Specific Weight, e=20 kN/m3 y1 =1.8m

Q: A pipe with a radius of R=0.6m flows partially full as shown. What is the approximate hydraulic…

A: Radius of pipe=R=0.6mhydraulic radius=?

Q: 1. A dam 15 m long retains 7 m of water, as shown in Figure. Find the total resultant force acting…

A: Total force can be calculated as the product of area of pressure diagram and length of dam. Center…

Q: A beam-spring system is shown in figure below. L = 5m EI-2.5× 10³ kN-m² 000 eee k = 40 kN m-10 kN…

A: For given spring-beam system,Initial displacement of 5 mmInitial velocity: 135 mm/sto find the…

Q: 180 kg M

A:

Q: Show step by step sol

A: P1= 981 PaV1 = 1.53 m/sExplanation:

Q: Determine the momeny of inertia of the wetted surface of the dam. the unit must be in ft^4

A:

Q: During the construction of a dam, concrete was poured into a lift of approximately 1.8 m (yı = 1.8…

A: Concrete dam: Concrete dams are known as gravity dams. Concrete dams are generally constructed to…

Q: The shovel load has a mass of 1.75 Mg and a center of gravity at G. All joints are pin connected.…

A: Given, Mass = 1.75 Mg or 1750 kg

Q: Determine the hydrostatic force in liquid 1, 2 and 3

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: 3. Flownet shown below, dimensions in meters. Point A is located 12m below the base of the dam.…

A: Given:Total head ,H=12.9 mLocation of point A=12 m below the base of dam

Q: Figure shows below a Fluid 1 (SG = 0.88) and fluid 2 (SG = 2.93). If Pa = 98 kPa, determine the…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.