A 5 kg object is pressed against the spring which has an undeformed length of 0.5 m (springstiffness is 500 Nim) by 0.35 m and released at an instant shown in the figure below. After theobject is released, it vertically falls through a circular pipeline located at 4.4 m below the baselineof the smooth ramp. After travelling through the pipeline, the object moves on a straight-line pathon a rough surface that has friction coefficients of u-0.25 and ja-0.10.Undelomedsping lngth of 05m0.6mwww0.8m4.4 m3m3 mD.Please answer the folklowing questions,(a) Determine the velocity that the object releases from the inclined ramp at B.(6) Determine the vertical velocity component at C.(e) If the object enters the pipeline at C with the above velocity when s-0, and the object's velocityincreases at a rate of = 0.1s m/sec (s is in meters), determine the velocity of the object thatexits the pipeline at D.(4) Using the appropriate friction coefficients given above, determine the distance that the objectstops measured from D.

Answered: Image /qna-images/answer/a09d922d-0815-478d-9ba0-3cae27492e73.jpg

Answered: A 5 kg object is pressed against the…

Similar questions

In the figure, a 3.8 kg block slides along a track from one level to a higher level after passing through an intermediate valley. The track is frictionless until the block reaches the higher level. There a frictional force stops the block in a distance d. The block's initial speed is v = 6.3 m/s, the height difference is h = 0.98 m, and uk = 0.632. Find d. μ= 0 Number i Units
A particle can slide along a track with elevated ends and a flat central part, as shown in the figure. The flat part has length L = 45.0 cm. The curved portions of the track are frictionless, but for the flat part the coefficient of kinetic friction is μk = 0.2 . The particle is released from rest at point A, which is at height h = L/ 2 . How far from the left edge of the flat part does the particle finally stop?
A 1.10-kg object slides to the right on a surface having a coefficient of kinetic friction 0.250 (Figure a). The object has a speed of vi = 2.60 m/s when it makes contact with a light spring (Figure b) that has a force constant of 50.0 N/m. The object comes to rest after the spring has been compressed a distance d (Figure c). The object is then forced toward the left by the spring (Figure d) and continues to move in that direction beyond the spring's unstretched position. Finally, the object comes to rest a distance D to the left of the unstretched spring (Figure e). a b d e m V=0 DMM m k (a) Find the distance of compression d (in m). (b) Find the speed v (in m/s) at the unstretched position when the object is moving to the left (Figure d). m/s
A pendulum consists of a small object hanging from the ceiling at the end of a string of negligible mass. The string has a length of 0.80m. With the string hanging vertically, the object is given an initial velocity of 1.9 m/s parallel to the ground and swings upward in a circular arc. Eventually, the object comes to a momentary halt at a point where the string makes an angle with with it's initial vertical orientation and then swings back downward. Find the angle.
A mass is an initial speed of v down a ramp inclined at an angle of θ to the horizontal. The coefficient of kinetic friction between the ramp and the mass is μ. After sliding a distance d down the ramp, the mass slides onto a frictionless horizontal surface and encounter a spring which it compresses a distance x. determine the spring constant, in term of given quantities
The cable of the 1800.0-kg elevator cab in the figure below snaps when the cab is at rest at the first floor where the cab bottom is a distance d = 3.70 m above a spring of spring constant k = 150,000 N/m. A safety device clamps the cab against guide rails so that a constant frictional force of 4,400 N opposes the cab's motion. Find the maximum distance that the spring is compressed. Assume that the frictional force still acts during this compression.
A block of mass, m 3.30 kg, slides along a frictionless surface. It starts with a velocity, vo = 8.50 m/s. It then encounters a rough surface for a distance, d 2.65 m, where there is a coefficient of kinetic friction, µk = 0.620. At the end, it hits a spring, which it compresses by a displacement, Ax = 10.5 cm, until it comes to a stop. Assume the spring itself is massless. Ax -> a) How much kinetic energy (in joules) does the block have initially? b) How much work (in joules) does the friction from the rough surface do on the block? c) After leaving the rough patch, the block slides without friction again. With what speed (in m/s) does the block hit the spring? d) What is the spring constant (in N/m)? e) When the spring pushes the block back in the opposite direction, will it be able to slide all the way to the opposite end of the rough patch? Justify your answer numerically. Upload Choose a File
A 4.50 ✕ 105 kg subway train is brought to a stop from a speed of 0.500 m/s in 0.600 m by a large spring bumper at the end of its track. What is the force constant k of the spring (in N/m)? (Enter a number.) ___N/m
The problem uses the ideal spring force, in one dimension. F = -kx, where x is the deviation from equilibrium, and k is the spring constant. Calculate the particle's maximum speed (vmax), with these numbers: k = 2000 N/m = 2000 kg/s2 m = 5 kg (the mass of the particle) x0 = 0.2 m (the initial position) v0 = 5 m/s (the initial velocity) The all-too-common erroneous solution: v max = A ω = x 0 k / m = 0.2 m ⋅ 20 / s = 4 m/s . Your problem: You may not understand this problem fully, and may not be able to solve it. Nevertheless, spot the egregious wrongness of the answer.
A 0.230 kg potato is tied to a string with length 1.70 m, and the other end of the string is tied to a rigid support. The potato is held straight out horizontally from the point of support, with the string pulled taut, and is then released. 1) What is the speed of the potato at the lowest point of its motion? 2) What is the tension in the string at this point?
In the figure, a 3.9 kg block slides along a track from one level to a higher level after passing through an intermediate valley. The track is frictionless until the block reaches the higher level. There a frictional force stops the block in a distance d. The block's initial speed is vo = 6.0 m/s, the height difference is h = 1.1 m, and uk = 0.560. Find d. Number i Units
A block of mass m is attached to a spring (constant k), sliding on a frictionless incline (angle theta), with respect to the horizontal. The spring begins compressed at a distance x and is released from rest. The block travels past an equilibrium point (point B) and has speed v, traveling up the plane. What equation is used to calculate the speed, v, up the plane?

SEE MORE QUESTIONS