A 40 kg fan has a rotation unbalance of magnitude of 0.01 kg.m. The fan is mounted on a beam which is specially treated to have a viscous damping. By the variation of the speed of the fan, the amplitude of the vibration varies too. What is the fan's steady state amplitude when it operates at 1000 r/min? Givens: E = 200 GPa, I = 1.3 x10-6 m4, L = 1.2 m, damping ratio = 0.06 Select one: O 2 mm 13.6 mm O 3.65 mm O 9mm

A 40 kg fan has a rotation unbalance of magnitude of 0.01 kg.m. The fan is mounted on a beam which is specially treated to have a viscous damping. By the variation of the speed of the fan, the amplitude of the vibration varies too. What is the fan's steady state amplitude when it operates at 1000 r/min? Givens: E = 200 GPa, I = 1.3 x10-6 m4, L = 1.2 m, damping ratio = 0.06 Select one: O 2 mm 13.6 mm O 3.65 mm O 9mm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Solve in good image
Q2/ The measurements on a mechanical vibrating system show that it has a mass of 8 kg and that the springs can be combined to give an equivalent spring of stiffness 5.4 N/mm. If the vibrating system has a dishpot attached which exerts a force of 40 N when the mass has a velocity of 1 m/s, find (1) critical damping coefficient, (2) damping factor, (3) logarithmic decrement, and (4) ratio of two consecutive amplitudes.
The spring constant of one car's spring is 24 kN / m and one tire has a mass of 370 kg. The relative damping factor is 0.35. The unevenness of the road causes a force on the wheel at a frequency of 0.74 Hz and the amplitude describing the unevenness of the road is 22 mm. What is the vibration amplitude of the car body in whole millimeters? For damping vibration
If the vertical gap 2.2-cm wide of infinite extent contains a fluid with specific gravity of 0.9. A metallic plate 1.2m x 1.2m x 0.2cm is to be lifted up with a constant velocity of 0.65 - m/sec, through the gap. If the plate is in the middle of the gap and the total force to lift the plate up is 150-N, what is the damping coefficient of the system.
A free vibration of the mechanical system shown in Figure 3 indicates that the to after four consecutive 3. amplitude of vibration decreased to 1/3 of the xo value at t = cycles of motion (i.e. x4 at t = t4). Determine the corresponding spring constant k if m = 15 kg and the viscous friction coefficient b = 4 N-s/m in the system. m Figure 3
A free vibration of the mechanical system shown in Figure 3 indicates that the amplitude of vibration decreased to 1/3 of the xo value at t = to after four consecutive cycles of motion (i.e. x4 at t = t4). Determine the corresponding spring constant k if m = 15 kg and the viscous friction coefficient b = 4 N-s/m in the system.
2. The machine shown below, with the rotating unbalance, operates a speeds between 18 and 60 rad/sec. Determine the minimum value of damping coefficient c needed to keep the amplitude of vibration below .3 inches. M = .026 lb sec2/in m = .0026 lb sec2/in r = 2 in. K = 3.75 lb / in Rotating Unbalance ww K X₁ M C Ty
Be it a mass damping spring system where the response amplitude decreases to 25% of its valueinitial, after the five consecutive cycles as shown in the graph. Determine the system damping coefficient cconsidering k = 20N/m and m = 10kg
The spring-mass-damper system shown below has m1 = m2 = 3.4 kg and k = 97.7 N/m. In addition, a damping factor of 0.3 is given. The initial position and velocity of the system is x(t=0)=4.3 mm and x'(t=0)=0 m/s respectively. Frictionless pulley m2 Calculate the time required for the amplitude to reduce to 10% of the initial conditions.