a 4-pole, 415V/60Hz three-phase squirrel-cage induction motor is Y-connected and has a rated speed of 1470rpm and R2=0.28N R°2= 0.210, X;=X'2= 0.422 Xm= 552. 1. If the motor is operated at speed of 2058rpm and Volt-per-Hertz control is used: 1. What would be the voltage? 2. What would be the frequency of the supply? (in Hz) 3. In this case, the motor is operating in what region? Oa. Constant speed Ob. Constant Power Oc. Constant power and torque Od. Constant Torque Oe. Cannot be specified. More information is needed

a 4-pole, 415V/60Hz three-phase squirrel-cage induction motor is Y-connected and has a rated speed of 1470rpm and R2=0.28N R°2= 0.210, X;=X'2= 0.422 Xm= 552. 1. If the motor is operated at speed of 2058rpm and Volt-per-Hertz control is used: 1. What would be the voltage? 2. What would be the frequency of the supply? (in Hz) 3. In this case, the motor is operating in what region? Oa. Constant speed Ob. Constant Power Oc. Constant power and torque Od. Constant Torque Oe. Cannot be specified. More information is needed

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

None
The rotor of the 4-pole three-phase squirrel cage induction motor has been replaced with the rotor of the three-phase 4-pole rotor wound induction motor. When the motor is fed with normal supply, the machine will a) Does not work b) Runs at a very slow pace c) Runs at slightly lower speed than normal speed d) Runs at a slightly higher speed than normal speed e) none
Mention the techniques used to start 1-Φ induction motor.
Q2] Fill in the blank (9 Marks) 1-The current drwan by the armature of D.C. motor is directly proportional to 2- The speed of a D.C. shunt-wound motor will shunt field regulator is increased. 3- The synchronous speed of a three-phase induction motor is number of pairs of poles. Rotor copper losses Rotor input power in induction motor = 5- A 4-pole three-phase induction motor has a synchronous speed of 25 r.p.s. The frequency of the supply to the stator is_ Hz. 6- The power input to a mains transformer is 200VA. If the primary current is 2.5A, the secondary voltage is 2V and assuming no losses in the transformer, the turns ratio step down. is 7- A 200kVA transformer has an iron loss of 1 kW and full load cu loss of 2 kW. Its load kVA corresponding to maximum efficiency is kVA. 8- If cu loss of a transformer at 7/8th full load is 4900 W, then its full-load cu loss would be watt. 4- if the value of resistance of the proportional to the 9- The slight curvature at the lower end of the open…
A 400 V, 50 Hz 30 hp, three-phase induction motor is drawing 50 A current at 0.8 power factor lagging. The stator and rotor copper losses are 1.5 kW and 900 W respectively. The friction and windage losses are 1050 W and the core losses are 1200 W. The air-gap power of the motor will be
A three-phase induction motor used for a commercial application in Oman 50HZ runs at 584 rpm at no load and at 546 rpm at full load. a) How many poles do this motor have? b) What is the percentage slip at full load? c) The frequency of the rotor currents when slip is 7 % d) The frequency of the rotor currents at standstill.
Hury up pleaaaaaaase
A synchronous machine is a three-phase, two-pole machine with 36 stator slots and 5/6 full-pitched balanced armature windings. Each phase winding is made up of eight identical coils connected in sequence. Balanced three-phase 66 Hz currents with a peak amplitude of 16 A are used to drive the stator phases. a) What is the basic stator space mmf's maximum amplitude? (A.turns) b) How fast does the fundamental stator space mmf rotate mechanically? (rpm) c) What is the third-harmonic stator space mmf's maximum amplitude? (A.turns) d) What is the fifth-harmonic stator space mmf's maximum amplitude? (A.turns) e) How fast does the fifth-harmonic stator space mmf rotate mechanically? (rpm)
I need the answer quickly
S1) please hury up its late