A 30 cm diameter pipe is connected by a reducer to a 10 cm diameter pipe. Points 1 (on the 30 cm diam.) and 2 (on the 10 cm diam.) are along the same elevation. The pressure at 1 is 250 KPa. The flow is 50 liters per second and the energy lost between 1 and 2 is equivalent to 20 KPa. Compute the pressure at 2 if the liquid flowing has a specific gravity of 1.30.

Q: The discharge flowing down the pipe is 0.03 m3/s and the pressure at 2 is 20kPa. Assuming the losses…

A:

Q: Water at 40°C (p=62.42 lbm/ft³ and u=1.038×10 diameter 30-ft-long horizontal pipe at an averag (b)…

A:

Q: Water flows from the tank shown in the figure below. At a depth of 1.5 ft the rate of change of…

A:

Q: Water flows steadily downward through the pipe shown in the figure below. Viscous effects are…

A:

Q: 1. What is the hydraulic radius of a rectangular air duct 300mm by 500mm?

A: There are multiple questions. So as per guidelines,  only first question is being solved.

Q: The mercury manometer indicates a differential reading of 0.30 m when the pressure in pipe A is…

A: Pressure diffrence has to calcluated

Q: In a pipeline with a diameter of 500mm, a venturi meter is installed. The ratio of the throat pipe…

A:

Q: Ex. For the square loop shown: 1. find the discharge in all the pipes. All pipes are 1 km long and…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: 1. Water flows through a horizontal, 0.5-m-diameter pipe at a rate of 0.9 m³/s (Figure below). It is…

A:

Q: Water flows from the ground floor to the third floor in a 4-storey building through a pipe 50 mm in…

A: Discharge, Q=2 L/s Diameter of the pipe, D=50 mm Roughness coefficient, k=0.03 mm Opening diameter…

Q: The figure shows a portion of a hydraulic circuit. The pressure at point B must be 250psig. When the…

A: Given data: Pressure at point B, PB=200 psig   Volume flow rate, Q=80galmin   Specific gravity…

Q: Figure Q1 (a) shows the tank attached with piezometer tubes. The pressure gauge A is 2.3 kPa. The…

A:

Q: For the pipe enlargement shown, the pressure at sections (1) and (2) are 56.3 and 58.2 psi,…

A:

Q: taining air and water is shown. At the closed end of the manometer the air pressure is 16…

A:

Q: El 2 m Liquid A (s.g = 0.72) Figure 1 %3D El 0.3 m Liquid B (s.g 2.36) El %3D .0m

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?