A 3.5 m-diameter tank is initially filled with water 2.25 m above the center of a sharp-edged 8-cm-diameter orifice. The tank water surface is open to the atmosphere, and the orifice drains to the atmosphere through a 110-m-long pipe. The friction coefficient of the pipe is taken to be 0.015 and the effect of the kinetic energy correction factor can be neglected. Determine (a) the initial velocity from the tank and (b) the time required to empty the tank.

A 3.5 m-diameter tank is initially filled with water 2.25 m above the center of a sharp-edged 8-cm-diameter orifice. The tank water surface is open to the atmosphere, and the orifice drains to the atmosphere through a 110-m-long pipe. The friction coefficient of the pipe is taken to be 0.015 and the effect of the kinetic energy correction factor can be neglected. Determine (a) the initial velocity from the tank and (b) the time required to empty the tank.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1-A mold with dimensions of 30 cm x 15 cm x 8 cm is intended in a sand plumbing through an estuary of length 8 cm Find the time required to fill the mold cavity if you know that the area of the entrance section is 3 cm?
What is an inflection point?
The final answer must be correct otherwise leave . Don't provide wrong answer ,It will be downvoted.
Question 4 a) Each cylinder in a four-cylinder car engine has a bore diameter of 63.53 mm and the stroke for each piston is 175.00 mm. Calculate the cubic capacity of the engine in cm? and calculate the clearance volume per cylinder for a compression ratio, r, of 6.25. b) The bore diameter of each cylinder in a six-cylinder four-stroke internal combustion engine is 32 mm and the stroke of each piston is 125 mm. During testing., the engine runs at 1450 revolutions per minute (rpm) with a pressure-volume indicator diagram showing a mean net area of 2.90 cm and a diagram length of 0.85 cm. The pressure scale on the indicator diagram is set to 165 kN/m per cm. Calculate the mean effective pressure (m.e.p) and the indicated power in kilowatts (kW) developed by this six-cylinder four-stroke engine. Give your answer to 2 decimal c) A hollow connecting rod has an inner diameter of 26.25 mm and is subjected to an axial tensile load of 500 MN. If the maximum allowable stress for this hollow rod…
PLEASE WRITE LEGIBLY, COMPLETE SOLUTIONS WITH DRAWING THANK YOU! A car weighing 9 kN travels at 80 km/hr. At the foot of an incline of 10%, the engine stops. Determine: a – acceleration. b – time for the car before it stops. c – distance traveled by the car before it stops.
*NOTE ON INSTRTUCTUONS AND HINTS
The first diagram is wrong, line AB should be longer since its length is equal to 580mm than line P2B which is equal to 360mm, please revise.
help[
It is still saying that is not correct. I have tried this practice problem over and over and that is the only part that it keeps saying is incorrect. the negative and units are correct. I appreciate your help.
When do the actual dimensions occur?
i need clear ans and solve very very fast in 20 min and thank you | DYBALA A part under forming force showed that 15% decrease in thickness and 10% increase in width, find the change in length (sign and value) if initial length is 200 mm?
With complete and clear units/conversion factors. Box your final answer and round to the nearest 2 decimal places. Thank you