A 3.5-kg block is pushed 2.9 m up a vertical wall with constant speed by a constant force of magnitude F applied at an angle of 0 = 30° with the horizontal, as shown in the figure below. If the coefficient of kinetic friction between block and wall is 0.30, determine the following. (a) the work done by F J (b) the work done by the force of gravity ] (c) the work done by the normal force between block and wall J (d) By how much does the gravitational potential energy increase during the block's motion? ]

A 3.5-kg block is pushed 2.9 m up a vertical wall with constant speed by a constant force of magnitude F applied at an angle of 0 = 30° with the horizontal, as shown in the figure below. If the coefficient of kinetic friction between block and wall is 0.30, determine the following. (a) the work done by F J (b) the work done by the force of gravity ] (c) the work done by the normal force between block and wall J (d) By how much does the gravitational potential energy increase during the block's motion? ]

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter7: Energy Of A System

Section: Chapter Questions

Problem 7.11P: A force F = (6i 2j) N acts on a panicle that under-goes a displacement r = (3i + j) m. Find (a) the...

See similar textbooks

Similar questions

Coal is lifted out of a mine a vertical distance of 50 m by an engine that supplies 500 W to a conveyer belt. How much coal per minute can be brought to the surface? Ignore the effects of friction.
Suppose you are jogging at constant velocity. Are you doing any work on the environment and vice versa?
Repeat the preceding problem, but this time, suppose that the work done by air resistance cannot be ignored. Let the work done by the air resistance when the skier goes from A to B along the given hilly path be —2000 J. The work done by air resistance is negative since the air resistance acts in the opposite direction to the displacement. Supposing the mass of the skier is 50 kg, what is the speed of the skier at point B ?
The surface of the preceding problem is modified so that the coefficient of kinetic friction is decreased. The same horizontal force is applied to the crate, and after being pushed 8.0 m, its speed is 5.0 m/s. How much work is now done by the force of friction? Assume that the crate starts at rest.
The force exerted by a diving board is conservative, provided the internal friction is negligible. Assuming friction is negligible, describe changes in the potential energy of a diving board as a swimmer drives from it, starting just before the swimmer steps on the board until just after his feet leave it.
A particle of mass 2.0 kg moves under the influence of the force F(x)=(5x2=7x)N . Suppose a frictional force also acts on the particle. If the particle’s speed when it starts at x=4.0 m is 0.0 m/s and when it arrives at x=4.0 m is 9.0 m/s, how much work is done on it by the frictional force between x=4.0 m and x=4.0 m?
Cite two examples in which a force is exerted on an object without doing any work on the object.
When jogging at 13 km/h on a level surface, a 70-kg man uses energy at a rate of approximately 850 W. Using the facts that the “human engine” is approximately 25 efficient, determine the rate at which this man uses energy when jogging up a 5.0 slope at this same speed. Assume that the frictional retarding force is the same in both cases.
Check Your Understanding The spring Example 7.5 is compressed 6 cm from its equilibrium length. (a) Does the spring force do positive or negative work and (b) what is the magnitude?
A 500-kg dragster accelerates from rest to a final speed of 110 m/s in 400 m (about a quarter of a mile) and encounters an average frictional force of 1200 N. What is its average power output in watts and horsepower if this takes 7.30s?
A cart is pulled a distance D on a flat, horizontal surface by a constant farce F that acts at an angle with the horizontal direction. The other forces on the object during this time are gravity (Fw) , normal forces (FN1) and (FN2) , and rolling frictions Fr1 and Fr2 , as shown below What is the work done by each force?
Consider a particle on which several forces act, one of which is known to be constant in time: . As a result, the particle moves along the x-axis from x=0 to x=5 m in some time interval. What is the work done by ?