A 3-phase 100OKVA, 11000/416 transformer is delta-connected on the primary and star connected on the secondary. The primary resistance / phase is 1.45 Q and secondary resistance/phase is 0.0006 Q. determine the efficiency on full-load at 0.85 power factor lagging if the iron loss is 1770 W. * 1 Add file

A 3-phase 100OKVA, 11000/416 transformer is delta-connected on the primary and star connected on the secondary. The primary resistance / phase is 1.45 Q and secondary resistance/phase is 0.0006 Q. determine the efficiency on full-load at 0.85 power factor lagging if the iron loss is 1770 W. * 1 Add file

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Tansformers
Determine the peak-to-peak ripple and dc output voltages. The transformer has a 36 Vrms secondary voltage rating, and the line voltage has a frequency of 60 Hz. Use germanium diodes. 110 Vrms 00000 lllll Rsurge www 10 Ω C 100 μF ww RL 3.3 ΚΩ
Q10) For the transformer shown in Figure below, determine (i) The turns ratio of the transformer (ii) The secondary current (iii) The voltage across the load R = 10k2 (iv) The voltage across the primary winding Ip = 3A Is = ? Ns = 20 turns RL Np = 60 turns 10k2 ellle lelll
If the transformer in the shown figure has Req-500, Xeq=500, RC=10000, and XM-10000, then the losses in the transformer equal Watt. Lood auno 502 200V(N 2:1 Select one: O 70.769 O 68.769 O 74.769 O 78.769 O 72.769
A Buck Converter converts 24Vdc to 12Vdc with losses of 70W, and a load of 60Ohms. What is the current drawn from the power supply?
Name the test that you could perform on the transformer to calculate the copper winding loss Elaborate on this test to explain how you could find the copper loss
In transformer, the hysteresis loss can be minimized by O using magnetic material with high permeability O using magnetic material with low permeability O laminating the core O using thin size copper conductors
A 2/0.4 kV, single-phase transformer takes a no-load current of 1 A and the core losses is 500 W. Find the magnetizing component current 0.35 A 0.15 A O 0.25 A 0.45 A
The table below shows some performance parameters of a certain power transformer. Full-load voltage regulation Full-load copper loss Load power factor 0.5 Lagging 5% The Maximum noccihle voltage regulation of the trane former is: 5.033 96 5.385 9 3 96 4.134 % 21 21