A 240-volt battery has an internal resistance of 1.2 ohms is connected through a line with resistance of 8.8 ohms. What power that can be transmitted to the load at maximum condition?

Q: Q1 (a) Determine the transfer function Ø2(s)/T(s) for the rotational mechanical system with gears…

A:

Q: Q3. Design a composite low-pass filter to have a cutoff frequency of 2KHZ and a design impedance of…

A:

Q: a- A 50-Hz transformer is operated from a 60 Hz supply. Assume that the load does not change-…

A: Transformer: A transformer is a device that converts electrical energy from one circuit to another,…

Q: 3. Determine the voltage across R2 for the first and second diode approximations. Diode: Si, r = 10…

A:

Q: 1. Solve for all the currents in different branches.

A: Since you have asked multiple questions we will solve the first question for you, If you want any…

Q: 50 www Answer= 100 ww 200 Use the node voltage method to find the power dissipated in the 10 ohm…

A:

Q: Vin ( + D₁ H RL Vout The rectifier above drives a 640-2 load with a peak voltage of 3.75V. For a…

A: In this question We need to determine the ripple voltage.  We know Ripple voltage for half wave…

Q: Q4- For the network in Fig. 3: a. Determine RT. b. Find Is, II, and 12. c. Find voltage V4. 14 101…

A:

Q: Q1. It is desired to run the motor at 1000 rpm, Find the value of the field resistance that to be…

A: 1)Given Desired speed N2=1000 rpmV=220 vRa=0.5 ΩRf=200 ΩT=constantArmature current Ia=20 Aspeed…

Q: for cht 2 Date: It It jov det It Cesmpenion 8 gmail.com VICTORY

A: Find the current iT  in the circuit.

Q: A single-phase 400 kVA transformer has an efficiency of 99.13% at half load unity power factor…

A:

Q: A power transformer has 1000 primary turns and 100 secondary turns. The cross-sectioal area of the…

A:

Q: A 3-phase, 2200-V, delta-connected, 12-pole 60-Hz induction motor runs at no load with rated voltage…

A:

Q: Question 4 Design a filter that has the transfer function H(s) 1) Please determine the filter type,…

A: The transfer function of a second-order filter is given asTo find:(i) filter type, its gain,…

Q: The currents in a 3- phase unbalanced system are: IR = (12 + j6) A ly (12 – j12) A IB = (-15 + j10)…

A: The solution is given below

Q: 1. Find the voltage vo in the circuit shown using nodal analysis. 2Ω + Vo 15 A 2Ω + C

A: Note: As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: The no-load speed of a 240 V Dc shunt motor is 800 r/min and the armature current is 2A. Determine…

A: In this question,  Find the additional shunt resistance to increase the speed of the motor from…

Q: Find the highest voltage to which the base can be raised while keeping the BJT in active mode.…

A:

Q: 500 a A/m. Q26. Determine the total current on a circular wire of radius 2mm and J = 3.14 A 6.28 A…

A: It is given that: radius of wire=r=2 mm=2×10-3 mand current density=J=500 azρA/m2 The given current…

Q: Q: I need an Introduction for my report about this experiment : Speed control of seperately Excilted…

A:

Q: A 50 MVA, 60 Hz, single-phase transformer indicates that it has a voltage rating of 8 kV/78 kV. Open…

A:

Q: Answer the following questions about complex waveforms: A. Define the complex waveforms. B. How can…

A: As per Bartleby policy we can not answer all parts at a time. I am answering first two parts for…

Q: Solve Using Thevenin's Theorem, Find V drop and I Drop at 25 ohms

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: A motor developing the starting torque of 15 Nm, and load torque of 7Nm on shaft. If the…

A: From the given question: The accelerating torque is the difference of the starting torque and the…

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A: Given: Critical frequency, fc=12.5 MHz Angle of incidence,i=650

Q: R, ww- Problem 3: Find an expression for the closed loop voltage gain G. R, R. R, 두

A: To find the closed loop voltage gain G

Q: 5. Given below is an electrical network where v(t) = 390 cos t volts with initial conditions i (0) 0…

A: Given, v(t)= 390cost i1(0)=i2(0)=0

Q: A circuit has voltage equation of e = 141 sin(wt -60°) - 56 sin(3wt - 30°), V and current equation,…

A: Given,Voltage,e=141 sinωt-60°-56 sin3ωt-30° VandCurrent,i=28 sinωt-30°+17 sin3ωt-90° A

Q: Problem 5: Find the output voltage v, when the source v, -6u(t) V and v(0)=1 V. Recall that u(1)…

A: The source voltage is function of unit step function which means the source voltage is zero when…

Q: Find the Norton equivalent with respect to the terminals a,b for the circuit seen in (Figure 1).…

A: Need to find Norton equivalent resistance

Q: A single phase 50 Hz core type transformer has rectangular cores 30 x 20 cm. and the maximum…

A:

Q: A 40 kVA, 6,600/250V, 50 Hz transformer is having total reactance of 35 ohms when referred to…

A: Given Data: Rating = 40 kVA R1 = 10 ohm R2 = 0.2 ohm E1 = 6600 V E2 = 250 V

Q: Three series capacitors of equal capacitances has an equivalent capacitance of 1,250 pF. What is the…

A:

Q: For each of the 3 circuits below, draw small signal model and calculate Vout/Vin. M₂h VDD Vout o…

A:

Q: For each of the 3 circuits below, draw small signal model and calculate Vout/Vin. M₂h Vout o Vino-…

A:

Q: A three-phase induction motor develops 20 kW when running at 90% efficiency, at a power factor of…

A: Given: In three phase induction motor, Output power, P0=20 kW. Efficiency, η=90%=0.9. Power factor,…

Q: 1. For the given circuit, write down the system of equations and find out the following parameters.…

A: The circuit diagram is given by,We have to determine the -parameters.

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.