A 22-cm-long, zero-resistance slide wire moves outward, on zero-resistance rails, at a steady speed of 15 m/s in a 0.12 T magnetic field. (See Figure 30.26 in the textbook). On the opposite side, a 1.3 2 carbon resistor completes the circuit by connecting the two rails. The mass of the resistor is 61 mg. Part A What is the induced current in the circuit? Express your answer with the appropriate units. ▸ View Available Hint(s) I = Submit ▾ Part B Value μÅ Submit Part C How much force is needed to pull the wire at this speed? Express your answer with the appropriate units. ▸ View Available Hint(s) Full = Value HÅ Units P Units ? If the wire is pulled for 10 s, what is the temperature increase of the carbon? The specific heat of carbon is 710 J/(kg-K) Express your answer in kelvins.

A 22-cm-long, zero-resistance slide wire moves outward, on zero-resistance rails, at a steady speed of 15 m/s in a 0.12 T magnetic field. (See Figure 30.26 in the textbook). On the opposite side, a 1.3 2 carbon resistor completes the circuit by connecting the two rails. The mass of the resistor is 61 mg. Part A What is the induced current in the circuit? Express your answer with the appropriate units. ▸ View Available Hint(s) I = Submit ▾ Part B Value μÅ Submit Part C How much force is needed to pull the wire at this speed? Express your answer with the appropriate units. ▸ View Available Hint(s) Full = Value HÅ Units P Units ? If the wire is pulled for 10 s, what is the temperature increase of the carbon? The specific heat of carbon is 710 J/(kg-K) Express your answer in kelvins.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A circular loop of wire with a radius of 14.0 cmcm and oriented in the horizontal xy-plane is located in a region of uniform magnetic field. A field of 1.8 TT is directed along the positive z-direction, which is upward. For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Emf and current induced in a loop. Part A If the loop is removed from the field region in a time interval of 3.0 msms , find the average emf that will be induced in the wire loop during the extraction process. Express your answer in volts. Activate to select the appropriates template from the following choices. Operate up and down arrow for selection and press enter to choose the input value typeActivate to select the appropriates symbol from the following choices. Operate up and down arrow for selection and press enter to choose the input value type E = VV SubmitRequest Answer Part B If the coil is…
I decreasing In the figure above, a loop is located near a long wire with current flowing as indicated. 8The original B field penetrating the loop points the page. O If the current in the wire decreases, then the magnetic flux o in the loop 0Therefore, the loop generates an induced B field that points the page. e This induced B field is due to an induced current that flows in the loop.
a L I b L Two long, thin, parallel wires are suspended via 7 cm strings as shown in the Figure above. Each wire has a linear mass density of 55 g/cm. The wires carry identical currents in opposite directions, as shown. a. Use (make a copy) panel b of the Figure above to draw a Free Body Diagram showing the forces acting on one of the wires. b. Find the current in the wires if the system is in equilibrium when the suspending strings make a 6.5 degree angle with respect to the vertical.
A fixed 19.6-cm-diameter wire coil is perpendicular to a magnetic field 0.58 T pointing up. In 0.23 s, the field is changed to 0.24 T pointing down. Part A What is the average induced emf in the coil? Express your answer to two significant figures and include the appropriate units. HÅ ? E = Value Units
(Figure 1) shows a circuit with an area of 0.070 m² containing a R = 1.0 N resistor and a C = 230 µF uncharged capacitor. Pointing into the plane of the circuit is a uniform magnetic field of magnitude 0.11 T. In 1.0 × 10-2 s the magnetic field strengthens at a constant rate to become 0.80 T pointing into the plane. Part A What maximum charge (sign and magnitude) accumulates on the upper plate of the capacitor in the diagram? Express your answer to two significant figures and include appropriate units. µA ? Value Units Submit Request Answer Provide Feedback Figure 1 of 1 R
An electron travels with speed 1.3×107 m/s between the two parallel charged plates shown in the figure. The plates are separated by 1.0 cm and are charged by a 200 V battery. Part A What magnetic field strength will allow the electron to pass between the plates without being deflected?Express your answer in tesla. Part B What is the direction of the magnetic field?A UpB DownC Out of the pageD Into the page
The magnetic field B at all points within the colored circle of the figure (Figure 1)has an initial magnitude of 0.700 T. (The circle could represent approximately the space inside a long, thin solenoid.) The magnetic field is directed into the plane of the diagram and is decreasing at the rate of 0.0300 T/s. Figure X X X X X B X /b X 1 of 1 10.0 cm Part C What is the current in the ring if its resistance is 4.00 $? ΑΣΦ I = Submit Part D X Incorrect; Try Again; 5 attempts remaining What is the emf between points a and b on the ring? ε = Previous Answers Request Answer Submit Part E ΠΙΑΣΦ Request Answer ? IVE ΑΣΦ ? A If the ring is cut at some point and the ends are separated slightly, what will be the emf between the ends? ? V
▸ Part A What value of magnetic field would make a beam of electrons, traveling to the right at a speed of 5.4×100 m/s. go undeflected through a region where there is a uniform electric field of 9400 V/m pointing vertically up? Express your answer to two significant figures and include the appropriate units. B = 1.7x10-3 T Submit ✓ Correct Part B Previous Answers Part C What is the frequency of the circular orbit of the electrons if the electric field is turned off? Express your answer to two significant figures and include the appropriate units. HA f- Value Submit Request Answer Units ?
Part A You want to build a generator for a multi-day canoe trip. You have a fairly large permanent magnet, some wire, and a lightbulb. You may build it as follows. Wind the wire for about 200 turns into a coil of Suppose we need 6.0 V to light the bulb (the peak voltage). What is the required rotational speed? 15 cm radius. Tape up the coil and place it in the region between the poles of the magnet that produces a 0.10 T magnetic field. Connect a hand crank to the coil and rotate it at a rotational speed w. Express your answer with the appropriate units. HÀ W = Value Units Submit Request Answer Provide Feedback
A coil has 200 turns enclosing an area of 10.8 cm² . In a physics laboratory experiment, the coil is rotated during the time interval 0.036 s from a position in which the plane of each turn is perpendicular to Earth's magnetic field to one in which the plane of each turn is parallel to the field. The magnitude of Earth's magnetic field at the lab location is 6.00×10-5 T. Part A What is the magnitude of the magnetic flux through one turn of the coil before it is rotated? Express your answer in webers. ► View Available Hint(s) | Þinitial Submit —| ΑΣΦ Part B xa Xb 7 √x V x 2.0.10 5 Previous Answers X <४ |X| ? X.10n X www Wb X Incorrect; Try Again; 2 attempts remaining The angle between the magnetic field and the area vector of the coil is either 0 or 180 degrees. Note that you can choose to view the coil from either side, as long as you stick to using the same side for the entire calculation/experiment. This gives a factor of ±1 in the formula for flux. What is the magnitude of the…
Part A A 14 cm-diameter circular loop of wire is placed in a 1.28 T magnetic field. When the planc of the loop is perpendicular to the field lines, what is the magnetic flux through the loop? Express your answer to two significant figures and include the appropriate units HA Value Units Submit Request Answer Part B The plane of the loop is rotated until it makes a 45 ° angle with the field lines. What is the angle in the equation Pg = BA cos e for this situation? Express your answer using two significant figures. 0 = Submit Request Answer Deersen
A single loop of wire with an area of 0.0680 m? is in a uniform magnetic field that has an initial value of 3.80 T, is perpendicular to the plane of the loop, and is decreasing at a constant rate of 0.210 T/s. Part A You may want to review (Page). What emf is induced in this loop? For related problemsolving tips and strategies, you may want to view a Video Tutor Solution of Emf and current induced in a loop. Express your answer in volts. lel = V Submit Request Answer Part B If the loop has a resistance of 0.750 N, find the current induced in the loop. Express your answer in amperes. I= A Submit Request Answer