Answered: * A 213V 60Hz supply drives a load with…

* A 213V 60Hz supply drives a load with an impedance of 28<45°ohms. What is the real power in watts? Note: answer value to be in integer form, (approximation to zero decimal point)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q3/A) A 1500 kVA, 6600V, three phase star connected alternator with Ra=0.502/phase and Xs-52/phase delivers a full load current at 0.8 lagging power factor load. Find the induced emf per phase. If this induced emf is maintained constant but load is changed to full load unity power factor estimate terminal voltage per phase. B) Answer the following:
= Q3. (a) Two circuits have impedances Z₁ 1000237⁰ and Z₂ = 500253⁰ N. Showing all calculations, determine the total impedance, and the current drawn from a 230 V, 50 Hz supply, in a ±jb form, when these impedances are connected: (i) in series across the voltage terminals. (ii) in parallel across the voltage terminals.
The theoretical maximum efficiency of wind turbines is limited by the velocity of air leaving the turbine preventing air from entering the turbine. TRUE OR FALSE?
Question: In commutation method the charged capacitor momentarily reverse biases the conducting SCR and hence the chopper gets turned off. Option 1: Both current and voltage Option 2: Voltage Option 3: Current Option 4: lone of the above
I need help with this homework question.
Can someone help me try to understand the effect of Capacitance Multiplier Design Parameters on Power Supply Noise Reduction? Please also provide mathematical equation and make it computerized so I can unnderstand it better. PLEASE JUST REJECT IT IF YOU CAN'T HELP ME. THANKS!
a) Write down the expression of instantaneous voltage for an AC voltage having a Peak value of 220 Volts and a frequency of 50 Hz provided at time t=0, the instantaneous voltage is 220 Volts. What is the instantaneous voltage of the source at time “t = 5 seconds” What is its RMS voltage? b) Two 200Ω resistances are connected in series with one 0.5 H Inductance and two 100μF Capacitance with the power supply of part (a). (i)Draw the circuit diagram of the above network (ii)What is the total impedance of the circuit (iii)What is the max current that flows through the Inductance? (iv)What is the max current that flows through each of the Capacitance? (v)What is the power dissipated in the circuit (vi)What is the power factor of the circuit (vii)What is the resonance frequency of the circuit? (viii) What is the maximum power dissipated by the circuit when it is in resonance
Electrical load that draws current whose impedance varies throughout the cycle of the input ac voltage waveform is known as nonlinear load. True False
I need the answer as soon as possible
A high-voltage direct-current generating station delivers 5 MW of power at 178 kV to a city, as depicted in Figure below. The city is represented by resistance R₁ and each of the two wires of the transmission line between the generating station and the city is represented by resistance RTL. The distance between the two locations is 1752 km and the transmission lines are made of 7 cm diameter copper wire. Determine how much power is consumed by the transmission line. Please enter your answer 2 decimal places and in terms of Watt. (for copper-1.72 x 10-8) Vo Station RTL RTL ww RL (city)
a) Explain why root mean square (RMS) is used to quantify the strength of an AC signal. b) If SI units are Meter (m), Kilogram (kg), Second (s), Ampere (A), Kelvin (K), Mole (M) and Candela (C), then express Voltage, Resistance, Capacitance, Inductance, Power and Energy in terms of SI units.
The rms current in a 33.0-0 resistor connected to an AC source is 2.80 A. (a) What is the rms voltage across this resistor? V (b) What is the peak voltage of the AC source? V (c) What is the average power dissipated by the resistor? W (d) What is the maximum current across this resistor? A