A 200-lb block is initially at rest on a flat surface that is inclined a 30°. If the coefficient of kinetic friction is 0.20 and a coefficient of static friction is 0.40. Find the force required to start a block moving at the plane? .

Q: 1. Normal benchtop digital multimeters (DMMs), such as pictured below, can only measure resistances…

A: Electrical resistance is measured with an ohmmeter, a device that uses that unit of measurement. The…

Q: ! Required information Consider vs(t) = 9.00 - 2u( V for the circuit given and the 15- resistor is…

A: Given:a circuit,with, we need to determine:, the voltage across capacitance at 4 ms.

Q: What is the required resolution of an instrument if the product characteristic specification is 10.0…

A: The number of bits or portions that the output or displayed reading from a sensor or measuring…

Q: A correct ordering from lowest to highest cost for types of power plants is: Capital Investment…

A: As per the guidelines given to us, we can only provide the solution of one question in multiple type…

Q: 1. As we saw in class, the range of a 4-bit binary number is 0000 to 1111 or in decimal, 0 to 15.…

A: As per our policy we can provide solution to first question only. As we have given , The range of 4…

Q: MUI ULTIPLE SELECTIO With respect to the following figures, which of the following statement(s)…

A: Given Data:A E vs k curve is given in the question.Required Data:Here, we need to mark the correct…

Q: 120 V Computer (500 W) Lights (500 W) Fridge (500 W) Fuse T.V. (500 W) 20 A A) What is the current…

A: Nodal Analysis - It is used to find node voltage using Kirchhoff's current law. Kirchhoff's current…

Q: Using superposition to consider each source one at a time, compute ix. (Round the final answer to…

A: For the given circuits the value of the unknown current in the circuit needs to be calculated by…

Q: The circuit displayed below is comprised of resistors, a battery,  capacitors and a single pole…

A:

Q: In the circuit below I = 3245° mA. What is the KCL expression at node a following the %3D…

A:

Q: (1) In the circuit below, the two meters are digital multimeters (DMMs), with one set to the ammeter…

A: As asked in the question, we need to solve only part (c) and (d). Given figure is,In the above…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.