A 20-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1 henry and the resistance is 70 ohms. Find the current i(t) if i(0) = 0. i(t) = Determine the current as t → co. lim i(t) = t→∞

A 20-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1 henry and the resistance is 70 ohms. Find the current i(t) if i(0) = 0. i(t) = Determine the current as t → co. lim i(t) = t→∞

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 62CP: A 1.5k resistor and 30-mH inductor are connected in series, as below, across a120-V(rms)ac power...

See similar textbooks

Related questions

Q: An RL circuit consist of a resistance of 38 Ohms and source potential of 15 V. At t = 0 the switch…

Q: is connected in series with the resistor is, A100 $2 resist inductor. The voltage across .0 V) sin…

A: Inductive reactance is the opposition offered by the inductor in an AC circuit to the flow of ac…

Q: An L-R-C series circuit has inductance 42.0 mH, capacitance C, and resistance R. Without the…

A: There are 2 types of sources ac source and dc source. When inductor, capacitor and resistor are…

Q: The switch in a series RL circuit with a re- sistance of 6.1 N , inductance of 3.1 H, and voltage of…

A: Given value--- resistance = 6.1 ohm. Inductance = 3.1 H. Voltage = 35.3 V. We have to find---…

Q: A 40-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

Q: The current in an inductor is changing at the rate of 83 A/s, and the inductor voltage is 32V. What…

Q: Three inductors are connected in parallel in an electric circuit. If the inductance of the first…

Q: An LL-RR-CC series circuit has inductance 42.0 mHmH, capacitance CC, and resistance RR. Without the…

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time nee the…

A: GivenC=20 mFL=55 H

Q: The diagram shows a simple electric circuit consisting of a power source, a resistor, and an…

A: The current flowing through the circuit at time t is given as, I = VR(1-e-Rt/L)

Q: URGENT An L-R-C series circuit has inductance 42.0 mH, capacitance C, and resistance R. Without the…

A: Given Data L = 42mh42 × 10-3 H Capacitor Along with resistors and inductors, capacitors constitute…

Q: An L-R-C series circuit has inductance 42.0 mH, capacitance C, and resistance R. Without the…

A: Given that: The inductance is L=42.0 mH=42×10-3 H The angular frequency without the resistor is…

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: URGENT An L-R-C series circuit has inductance 42.0 mH, capacitance C, and resistance R. Without the…

A: Resistance The Greek letter omega () represents the measurement unit for resistance, known as ohms.…

Q: The LC circuit has a total energy of 34 J. Find the initial charge on the capacitor, maximum…

A: Given Data : L = 907 mH C = 772 microF To Find : C , Q , f , T

Q: A simple electric circuit consisting of a resistor, a capacitor, and an inductor is depicted as…

A: Given: R=60, L=9, C=0.00005, t=0 to 0.8s, q0=10 The charge on the capacitor q(t) as a function of…

Q: a circuit having an inductance of L=2mH has a current that varies with time as I=t^3e^-t. find the…

A: Emf induced can be given by, ∈=LdIdt where L is inductance and I is current and t is time. To be…

Q: An inductor is connected to a 11 kHz oscillator. The peak current is 62 mA when the rms voltage is…

A: The expression for the inductance is,

Q: 4.30 2 3. In the circuit the emf ɛ = 190 volts and the inductance L= 34.6 mH. What will be the…

Q: A circuit is constructed with a resistor, two inductors, one capacitor, one battery and a switch as…

Q: A 10-volt electromotive force is applied to an LR-series circuit in which the inductance is 0.1…

Q: A 20-Volt power supply is connected to a series R-L circuit and the current begins flowing at t = 0.…

A: Let V be the emf of the battery, I be the current through the circuit, R be the resistance and L be…

Q: In a series RL circuit, the resistance is 135 ohms, the inductance is 120 x 10-3 H, and the source…

Q: Let I, r, c and v represent inductance, resistance, capacitance and voltage, 1. respectively. The…

Q: An L-R-C series circuit has inductance 42.0 mH, capacitanceC, and resistance R. Without the…

A: Given that:RLC series circuitL=42 mHAngular resonant frequency without resistor, ωr=624 rad/sAngular…

Q: Aseries circuit contains a resistor with R = 40Ω, an inductor with L = 2 H, a capacitor with 0.0025…

A: Given : Resistor, R = 40 Ω Inductor, L = 2 H Capacitor, C = 0.0025 F Voltage, V(t) =…

Q: An inductor with inductance L is connected to an AC source. If the AC source provides a voltage…

A: Voltage across inductor

Q: The current in an Series RL circuit is described by the following differential equation: R i(t) + L…

Q: The charge on the capacitor of an LC circuit with capacitance C and inductance L obeys the following…

Q: An inductor with inductance L is connected to an AC source. If the AC source provides a voltage…

A: The objective of the question is to find the current through an inductor as a function of time when…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

**Problem Statement:**

A 20-volt electromotive force is applied to an $ LR $-series circuit in which the inductance is 0.1 henry and the resistance is 70 ohms. Find the current $ i(t) $ if $ i(0) = 0 $.

\[ i(t) = \quad \boxed{} \]

Determine the current as $ t \to \infty $.

\[ \lim_{t \to \infty} i(t) = \quad \boxed{} \]

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data :

VIEW

Step 2: Calculation :

VIEW

Step 3: Calculation :

VIEW

Step 4: Calculation :

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Do Kirchhoff’s rules apply to circuits that contain inductors and Capacitors?
In an oscillating RLC circuit, R = 7.0 L. = 10 mH. And C = 3.0 F. Initially, the capacitor has a charge of 8.0 C and the current is zero. Calculate the charge on the capacitor (a) five cycles later and (b) 50 cycles later.
In a series RLC circuit with a maximum current of 0.250 A, an AC source with Vmax= 115 V operating at 60.0 Hz is connected to a 325-mH inductor, a 7.50-F capacitor, and a resistor with unknown resistance R. Draw a phasor diagram for this circuit, including the current, the potential difference across each of the circuit elements, and the source emf. Draw your diagram with the current phasor pointing upward along the vertical axis.
In Figure OQ32.4, the switch is left in position a for a long lime interval and is then quickly thrown to position b. Rank the magnitudes of the voltages across the Four circuit elements a short time thereafter from the largest to the smallest.
Calculate the reactance of a 5.0F capacitor at (a) 60 Hz, (b) 600 Hz, and (c) 6000 Hz.
Find the reactances of the following capacitors and inductors in ac circuits with the given frequencies in each case: (a) 2-mH inductor with a frequency 60-Hz of the ac circuit; (b) 2-mM Inductor with a frequency 600-Hz of the ac circuit; (C) 20-mM inductor with a frequency 6-Hz of the ac circuit; (d) 20-mM inductor with a frequency 60-Hz of the ac circuit; (e) 2-mF capacitor with a frequency 60-Hz of the ac circuit; and (f) 2-mF capacitor with a frequency 600-Hz of the AC circuit.
In this chapter, most examples and problems involved direct current (DC). DC circuits have the current flowing in one direction, from positive to negative. When the current was changing, it was changed linearly from I=ImaxtoI=+Imax and the voltage changed linearly from V=Vmax to V=+Vmax where Vmax=ImaxR .Suppose a voltage source is placed in series with a resistor of R = 10 that supplied a current that alternated as a sine wave, for example, I(t)=(3.00A)sin(24.00st) . (a) What would a graph of the voltage drop across the resistor V(t) versus time look like? (b) What would a plot of V(t) versus I(t) for one period look like? (Hint: If you are not sure, try plotting V(t) versus I(t) using a spreadsheet.)
What is the resistance R in the circuit shown below if the amplitude of the ac through the inductor is 4.24 A?
An AC generator with an rms emf of 15.0 V is connected in series with a 0.54-H inductor. The frequency of the source emf is 70.0 Hz. Draw a phasor diagram for this circuit, including the current, the potential difference across the inductor, and the source emf. Draw your diagram with the current phasor pointing toward the right along the horizontal axis.
(a) What is the resonant frequency of a resistor, capacitor, and inductor connected in series if R = 100 . L = 2.0 H, and C = 5.0 F ? (b) If this combination is connected to a 100-V source operating at the resonant frequency, what is the power output of die source? (c) What is the Q of the circuit? (d) What is die bandwidth of the circuit?
Review. The voltage phasor diagram for a certain series RLC circuit is shown in Figure P33.59. The resistance of the circuit is 75.0 , and the frequency is 60.0 Hz. Find (a) the maximum voltage Vmax, (b) the phase angle , (c) the maximum current, (d) the impedance, (e) the capacitance and (f) the inductance of the circuit, and (g) the average power delivered to the circuit.
Can a circuit e1eent have both capacitance and inductance?