A 20 m thick clay layer is sandwiched between a silty sand layer and a gravelly sand layer. The layer experiences 30 mm settlement in 2 years. Given : 2 U for Us 60% TO Tv 4 100, %3D 1.784-0.933log,o (100 - U) for U> 60% where Ty is the time factor an U is the degree of consolidation in % If the coefficient of consolidation of the layer is 0.003 cm2/s, the deposit will experience a total o 50 mm settlement in the next years.

A 20 m thick clay layer is sandwiched between a silty sand layer and a gravelly sand layer. The layer experiences 30 mm settlement in 2 years. Given : 2 U for Us 60% TO Tv 4 100, %3D 1.784-0.933log,o (100 - U) for U> 60% where Ty is the time factor an U is the degree of consolidation in % If the coefficient of consolidation of the layer is 0.003 cm2/s, the deposit will experience a total o 50 mm settlement in the next years.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

10. Which one of the following is an assumption made by Coulomb in the development of his earth pressure theory for sand and for active state? (a) The rupture surface is non-uniform surface (b) There is a wall friction on the pressure surface (c) Failure is three dimensional (d) The soil is cohesive
The layer is subjected to a uniform vertical stress increase of 100 kPa. The singly-drained clay layer has a coefficient of consolidation of 20 ft2 /yr. Determine the value of the excess pore pressure at point A 2 years after the application of the load. Also given is the chart giving the local degree of consolidation. a)4.4 kPa b)44 kPa c)88 kPa d)96 kPa
7.12 A sand specimen was subjected to a drained shear test using hollow cylin- der test equipment. Failure was caused by increasing the inside pressure while keeping the outside pressure constant. At failure, o, = 193 kN/m² and o; = 264 kN/m². The inside and outside radii of the specimen were 40 and 60 mm, respectively. (a) Calculate the soil friction angle. (b) Calculate the axial stress on the specimen at failure.
Determine shear strength of clay having value of cohesion 31 KPa Normal stress 100 KPa and angle of internal is 31 degree
A consolidated undrained triaxial test was performed on a normally consolidated clay with a critical state friction angle of 230. After an initial isotropic consolidation at a cell pressure of 50 kPa, drainage was turned off, the cell pressure was increased to 85 kPa, and the sample was loaded to ultimate conditions. A pore pressure of 55 kPa was measured at ultimate state. What value of major principal total stress was measured at the ultimate state?
A certain saturated sand (S = 100%) has a moisture content of 27.9% and a specific gravity of solids of 2.61. It also has a maximum index void ratio of 0.90 and a minimum index void ratio of 0.33. Compute its relative density and classify its consistency. (Table on the right) Solution: Given the values of mmoisture content, specific gravity and degree of saturation, the void ratio can be estiamted as: e = Thus the relative density is found to be Dr = • According to the table, the soil is classified as %; soil. TABLE 3.3 CONSISTENCY OF COARSE-GRAINED SOILS AT VARIOUS RELATIVE DENSITIES (data from Lambe and Whitman, 1969) Relative Density, D,(%) 0-15 15-35 35-65 65-85 85-100 Classification Very loose Loose Medium denseª Dense Very dense "Lambe and Whitman used the term "medium," but "medium dense" is better because "medium" usually refers to the particle size distribution.
A consolidated-undrained test determines that the shear strength of a normally consolidated clay is given by τf = σ’tan 27o. The confining pressure is 150 kPa, and deviator stress at failure is 120 kPa.• Find the consolidated-undrained friction angle• Pore water pressure developed in the specimen at failureFinal answer should be in 3 decimal places.
4) In a oedometer test a specimen of a saturated clay 21 mm thíck reaches 50% consolidation in 10 minutes. How long would it take a layer of this clay 6 m thíck under the same drainage conditions to reach 90% f consolidation under the same stress and drainage conditions? Use the following relationships between the average degree of consolidation, U and time factor, T,: U =T, for Us 50% U =1-- for U>50% No need for calculation, please write only the results.
11.5 Following are the results of a laboratory consolidation test on a sample of undis- turbed clay obtained from the field. Pressure, o' (kg/cm?) Final helght of specimen (cm) 2.540 0.5 2.519 1.0 2.5 2.0 2.428 4.0 2.322 8.0 2.206 16.0 2.09 © Cengage laeming 2014
The ground conditions at a site are shown in the figure below GL Sand Water table is at ground level = 20% 5 m %3D Water content Specific gravity of solids = 2.7 Unit weight of water = 10kN/m a) The saturated unit weight of the sand (kN/m³) is (a) 15 (b) 18 (c) 21 (d) 24 B) The total stress, pore water pressure and effective stress (kN/m2) at the point P (a) 75, 50 and 25 (b) 90, 50 and 40 (c) 105, 50 and 55 (d) 120, 50 and 70 a0081
The water table in a deposit of uniform sand is located at 2m below the ground level. Assuming the soil above the water table be dry N and the void ratio is 0.75. The effective stress (in k- rounded off to nearest integer) at a depth of 5m below the ground level is N =9.81k-2 Take G = 2.65 and yw W m m 2'
A CID TXC test was performed on a sample of sand. At the end of consolidation, the back pressure was 140 kPa, and the cell pressure was 340 kPa. At failure, the deviator stress was (ơ1 – 03)f = 200 kPa. a. What was the total pore water pressure, u, at failure? b. Calculate the principle effective stresses, ơi' and os', at failure. c. Calculate the friction angle, d', for this soil.