A 2.41-uF and a 4.25-µF capacitor are connected in series across a 35.0-V battery. A 9.98-µF capacitor is then connected in parallel across the 2.41-µF capacitor. Determine the voltage across the 9.98-uF capacitor. Number 8.976 Units V
Q: 2..Express the following in V, using powers of ten: 32 SYSTEMS OF UNITS OF MEASUREMENT (a) 24 mV (b)…
A: Answer We have to convert the following values into volt
Q: What does this negative result mean? -8 cm u = 4 cm
A: Negative sign is assigned using Cartesian cordinate system.
Q: The length and width of a rectangular room are measured to be 3.764 ± 0.005 m and 4.030 + 0.005 m.…
A:
Q: The figure shows two infinite wires perpendicular to the xy-plane with identical currents I = 30 A.…
A: given,currenti=30 Ar1=1 mr2=2 m
Q: A boat takes 3.00 hourshours to travel 50.0 kmkm down a river, then 6.10 hourshours to return. How…
A:
Q: Measure the slope of the line of best fit. Since D = kgd, the slope will equal Va so multiply by Va…
A:
Q: 1. A student is using a track photogate to determine the time it takes her to run 50 meters. She…
A: Given information: The mean value of the time taken (Tavg) = 5.583714 sec Absolute uncertainty given…
Q: Which of the equation(s) are dimensionally compatible? E i. = v2 + 2aAx m 3 il. y = /rg (urgp) ii.…
A:
Q: how did you get 1.98 from 7.85 x 10^-27? There are no steps to show that.
A:
Q: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…
A: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…
Q: The reading of the micrometer shown in the figure is: 45 9$10 15 40 35 30 a. 17.37 mm O b. 12.5194…
A: Solution: The reading of the micrometer is calculated as follows: Micrometer Reading=Sleeve…
Q: ㅋ multiplying through out by 7. 18.2 (11.9 13 + 15) + 7×11.2 1₂ = 7x9 294.98 13 - 210 13 - 210…
A:
Q: A variable x changes in value from 4.96 to 8.62. The "scaling factor" associated with this change…
A: The objective of the question is to calculate the scaling factor associated with the change in the…
Q: Which of the following expressions accurately describes how these two distinct waves will combine?…
A:
Q: [2.1] Question: a. How many significant digits are in each of the following numbers? 26000 i. ii.…
A:
Q: From t = d/v, where the speed of light is in 3.00x108 m/s, 1 ft = 0.3048 m. Convert 1.00 ft to m and…
A:
Q: convert a measurement in pixels to a measurement in centimeters or millimeters?
A: 1 cm = 10 mm 1 pixel = 0.0264583333 cm
Q: Write the exponential form of the following: 5. 4670000000 6. 0.000893 7. 344500 8. 230000
A:
Q: the value the speed of light is now known to be 2.997 924 58 * 10^8m/s. Express the speed of light…
A:
Q: A traffic patrol officer uses a UAV with a camera to measure the transit time of vehicles between…
A:
Q: Given that 1in = 2.54 cm, then 10in is equal to how many cm?
A:
Q: Uncertainty Height y (m) Transit time Transit time Transit time Average transit time (s) Average…
A: Given: A table is provided having columns of height and transit time. To find: a) Graph of height vs…
Q: What is the SI equivalent of 34 rad? a. 0.008772 Gy O b.0.34 Sv O c. 0.34 Gy Od. 37,000,000,000 or…
A:
Q: An infant’s pulse rate is measured to be (130.0 + 5.0) beats/min. What is the absolute uncertainty…
A: Given that:- Infant pulse rate=(130+5) beat/min
Q: ive any analyzation about this uncertainty measurement in physics
A: Error in measurement done using ruler is greater than that of vernier
Q: H.W //2 Determine the estimated error in the length of AE, which was measured in sections as…
A: Estimated error in length of AE is, Estimated error=∆AB2+∆BC2+∆CD2+∆DE2
Q: ) Express the speed of light, 3.00 x 108 m/s in: a) Feet per nanosecond b) millimeters…
A: speed of light= 3×108 m/s 1 m= 3.28 ft (a) speed in Feet per nanosecond : 3×108ms=3×108 3.28 ft109…
Q: Match the following: measured in meters Time for one cycle measured in Hertz (or cycles per second)…
A:
Q: Applying the rules of significant figures and calculate 1. 123.4 + 120 + 4.822 -21 2.…
A: To calculate : using the rules of significant figures
Q: figure below. The +- 5.00 µC charges form a dipole. Find the force (magnitude and direction) the-…
A:
Q: State how many significant figures are proper in the results of the following calculations. (a)…
A: Given Data: (a) (36.84)(265)(46.210)(1.8618)(b). (20.0)2(c). (2.9×10-19)(3712) To Determine: (a).…
Q: A patient’s temperature was 97.0 °F at 8:05 A.M. and 102.0 °F at 12:05 P.M. If the temperature…
A: As the patient’s temperature change with respect to elapsed time was linear throughout the day so…
Q: How did we get 1.72 here?
A: From the given solution force between the charges is F=940 N. F=940 Nkq1q2d2=940 N
Q: Given a set of length measurements: 62.1, 62.5, 61.7, 62.6, 62.7, 61.9 cm. Find the standard error…
A: The formula for Standard Deviation: Standard Deviation, σ=∑i=1n(xi-x)2(n-1)where: xi = Value of…
Q: 132 9.8M/s x 3,72m/s?
A:
Q: If a radar unit measures that speed of an object 3 times and the results of 300km/hr, 297 km/hr, 302…
A:
Q: Determine the following: 1. Sleeve Reading on the micrometer 2. Thimble Reading on the micrometer
A: A screw gauge is a device that is used to calculate the dimension of the small objects. It consist…
Q: There are 2.54 cm per inch. 3.1 cm is the same distance as
A: Given, 2.54cm = 1 inch 1cm =1/2.54inch = 0.393inch
Q: Problem 1: Convert to Sl and write in scientific notation: a) 55 mph (miles per hour) to m/s b) 6.0…
A:
Q: State how many significant figures are proper in the results of the following calculations. (a)…
A: To determine the number of significant figures in the results of the given calculations, we must…
Step by step
Solved in 2 steps with 2 images