A 2.0-m-high box with a 1.0-m-square base is moved across a rough floor as in Fig. 9–89. The uniform box weighs 250N and has a coefficient of static friction with the floor of 0.60. What minimum force must be 1.0 m exerted on the box to make it slide? What is the maximum height h above the floor that this force can be applied without tip- ping the box over? Note that as the box tips, the normal force CG 2.0 m FN and the friction force will act at the lowest corner. Fir FIGURE 9-89 Problem 74.

A 2.0-m-high box with a 1.0-m-square base is moved across a rough floor as in Fig. 9–89. The uniform box weighs 250N and has a coefficient of static friction with the floor of 0.60. What minimum force must be 1.0 m exerted on the box to make it slide? What is the maximum height h above the floor that this force can be applied without tip- ping the box over? Note that as the box tips, the normal force CG 2.0 m FN and the friction force will act at the lowest corner. Fir FIGURE 9-89 Problem 74.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 12.8CYU: Check Your Understanding A 400.0-N sign hangs from the end of a uniform strut. The strut is 4.0 m...

See similar textbooks

Related questions

Q: In the figure, suppose the length L of the uniform bar is 3.3 m and its weight is 200 N. Also, let…

A: Given L = 3.3 m W = 200N W1(W of block) = 280 N Angle = 43° Maximum tension = T = 410 N

Q: How high can a 150N man climb up the ladder before it begin to slip?

A: Newton's Second Law of motion According to Newton's Second Law of motion, the rate of change of…

Q: When body is an equilibrium ,the net force is vanish

A: Given Statement: "When body is an equilibrium, the net force is vanish"

Q: (II) Figure 9–50 shows a pair of forceps used to hold a thin plastic rod firmly. If the thumb and…

Q: As an oil well is drilled, each new section of drill pipe support its oun weight crel that of the…

A: Given, L∘=6.0 mL∘=length of the pipeγ=1.6×1010 N/m2

Q: 8-15. The pipe is hoisted using the tongs. If the coefficient of static friction at A and B is ,…

Q: When you lift an object by moving only your forearm, the main lifting muscle in your arm is the…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: When you lift an object by moving only your forearm, the main lifting muscle in your arm is the…

Q: The mine car and its contents have a total mass of 5 kg and a center of gravity at G. If th…

Q: Why must you bend forward while carrying a heavy load on your back?

A: It is very much advisable to bend forward while carrying a heavy load.

Q: The mobile in Fig. 9–90 is in equilibrium. Object B has mass of 0.748 kg. Determine the masses of…

A: Condition for equilibrium for D and C

Q: Assuming your feet are not held down, which is more difficult: doing sit-ups with your knees bent or…

Q: Two identical, uniform beams are symmetrically set up against each other (Fig. 9–87) on a floor with…

A: Given The coefficient of static friction μs = 0.50

Q: (3) The angle of uniform slip is that angle of the plane which causes the free block to slide down…

A: The free-body diagram of a free block on an inclined is shown below. Here, m denotes the mass and N…

Q: The upside-down screw jack shown in Fig. often used as a foot leveler on refrigerators and other…

A: Given The load carried by the thread W = 800 N The radius of the screw r = 3 mm The lead of the…

Q: In a mountain-climbing technique called the "Tyrolean tra- verse," a rope is anchored on both ends…

Q: A pair of wedges is used to lift a crate as shown in The crate weighs 4000 lb, the wedge angle e is…

A: Given that,Weight of the Crate w=4000 lbInclination of the angle, θ=18°Coefficient of friction at…

Q: model for the elbow joint models the bicep muscle connecting to the horizontal forearm by a vertical…

A: Here we will use the concept of moment of force or torque . Clockwise moment must be equal to…

Q: A uniform meter stick supported at the 25-cm mark is in equilibrium when a 1-kg rock is suspended at…

A: The weight of the meter stick acts downwards at its center of mass (50 cm), that is, 25 cm away from…

Q: A 1.2-m plank of mass 3 kg rests on two joists. Knowing that the coefficient of static friction…

A: Part-a The length of the plank l = 1.2 m. The mass of the plank m = 3 kg. The coefficient of static…

Question

A 2.0-m-high box with a 1.0-m-square base is moved across
a rough floor as in Fig. 9–89. The uniform box weighs 250N
and has a coefficient of static friction with the floor of 0.60.
What minimum force must be
1.0 m
exerted on the box to make it
slide? What is the maximum
height h above the floor that this
force can be applied without tip-
ping the box over? Note that as
the box tips, the normal force
CG
2.0 m
FN
and the friction force will act at
the lowest corner.
Fir
FIGURE 9-89
Problem 74.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

'A model for the elbow joint models the bicep muscle connecting to the horizontal forearm by a vertical tendon 4cm from the elbow joint. A mass m is held in the hand 30cm from the elbow joint. If the maximum tension that can be exerted by the tendon before injury occurs is 2250N, find the maximum mass that can be held in this way.' Im stuck on this question
In a mountain-climbing technique called the "Tyrolean tra- verse," a rope is anchored on both ends (to rocks or strong trees) across a deep chasm, and then a climber traverses the rope while attached by a sling as in Fig. 9–91. This technique generates tremendous forces in the rope and anchors, so a basic understanding of physics is crucial for safety. A typical climbing rope can undergo a tension force of perhaps 29 kN before breaking, and a “safety factor" of 10 is usually recom- mended. The length of rope used in the Tyrolean traverse must allow for some “sag" to remain in the recommended safety range. Consider a 75-kg climber at the center of a Tyrolean traverse, spanning a 25-m chasm. (a) To be within its recommended safety range, what minimum distance x must the rope sag? (b) If the Tyrolean traverse is set up incorrectly so that the rope sags by only one-fourth the distance found in (a), determine the tension in the rope. Ignore stretching of the rope. Will the rope break? 25 m…
A 23.0-kg backpack is suspended midway between two trees by a light cord as in Fig. 9–51. A bear grabs the backpack and pulls vertically downward with a constant force, so that each section of cord makes an angle of 27° belowthe horizontal. Initially, without the bear pulling, the angle was 15°; the tension in the cord with the bear pulling is double what it was when he was not. Calculate the force the bear is exerting on the backpack.
(I) Assume that your proportions are the same as those inTable 7–1, and calculate the mass of one of your legs.
A cube of side l rests on a rough floor. It is subjected to a steady horizontal pull F, exerted a distance h above the floor as shown in Fig. 9-79. As Fis increased, the block will either begin to slide, or begin to tip over. Determine the coefficient of static friction us so that (a) the block begins to slide rather than tip; (b) the block begins to tip. [Hint: Where will the normal force on the block act if it tips?] h FIGURE 9–79 Problem 60.
(II) Figure 9–50 shows a pair of forceps used to hold a thin plastic rod firmly. If the thumb and finger each squeeze with a force Fr = FF = 11.0 N, what force do the forceps jaws exert on the plastic rod? Jaws Rod Fr P FIGURE 9-50 8.50 cm 2.70 cm Problem 6.
A piano wighing 600 N is to be raised to a platform 4 m high by a plank 10 m long. if the coefficient of friction is 0.30,what force parallel to tge plank will be needed?
A vehicle is accelerating from rest, on snow and ice. If the vehicle has a weight of 2100 lbs with the center of mass located at 40 in. above the ground, a wheelbase of 102 in., a length from the center of mass to the rear wheel of 60 in. What is the Fmax for the vehicle? Will it peel out if the Fnet = 500 lbs.?
'A model for the elbow joint models the bicep muscle connecting to the horizontal forearm by a vertical tendon 4cm from the elbow joint. A mass m is held in the hand 30cm from the elbow joint. If the maximum tension that can be exerted by the tendon before injury occurs is 2250N, find the maximum mass that can be held in this way.' Im stuck on this question
20) A uniform wood beam (Wwood = 2,000 N and L=6 meter) has a load of bricks (Wbricks = 5,000 N) placed on the beam raricks 4 meters from the end, Bob (Waob = 1,000 N) is standing on the wood beam raob Im from the end. At what positions (d) measured from the far-left end of the board would the triangle be placed so that the system is balanced? Tricks
1.Four identical textbooks, each of length L, are stacked near the edge of a table, as shown in Figure 9–28. The books are stacked in such a way that the distance they overhang the edge of the table, d, is maximized. Find the maximum overhang distance d in terms of L. In particular, show that d > L; that is, the top book is completely to the right of the table edge. (In principle, the overhang distance d can be made as large as desired simply by increasing the number of books in the stack.
(II) A man doing push-ups pauses in the position shown in Fig. 9–65. His mass m = 68 kg. Determine the normal force exerted by the floor (a) on each hand; (b) on each foot. 28 cm mg 42 cm 95 cm FIGURE 9-65 Problem 25.