(3) The angle of uniform slip is that angle of the plane which causes the free block to slide down the plane with constant velocity. Show that this angle is given by tane = µk [6] %3D where uk is the coefficient of kinetic friction.

Q: In the figure below, a uniform plank, with a length L of 6.20 m and a weight of 460 N, rests on the…

A: The coefficient of static friction between the plank and the ground. given,angle of…

Q: (10%) Problem 6: A uniform stationary ladder of length L = 3.9 m and mass M= 16 kg leans against a…

A: Step 1:Step 2:Step 3:

Q: The system shown in the figure is in static equilibrium and the angle 30 degrees. The surface of the…

A: Since the system of the two masses is in static equilibrium, it means that the masses are such that…

Q: In the figure, suppose the length L of the uniform bar is 3.3 m and its weight is 250 N. Also, let…

A: (a) The net torque acting on the bar at point A is,…

Q: In the figure, suppose the length L of the uniform bar is 3.3 m and its weight is 200 N. Also, let…

A: Given  L = 3.3 m  W = 200N  W1(W of block) = 280 N  Angle = 43°  Maximum tension = T = 410 N

Q: (A-(/2) (A-/2)(ptq)L)202 be 2. In engineering, the modulus of elasticity Is a way to measure how…

A: The expression for the modulus of elasticity is: E=F2-F1L0δ2-δ1A Multiply by A on both sides of the…

Q: Why must the change in the wire's length be measured so accurately although the wire's original…

A: Write the expression for the strain and stress, respectively.

Q: The mine car and its contents have a total mass of 5 kg and a center of gravity at G. If th…

A:

Q: A disk between vertebrae in the spine is subjected to a shearing force of 600 N. Find its shear…

A:

Q: No Chatgpt,Only Handwritten solutions. Mechanical engineering (The free body diagram is mandatory)

A: If you have any doubt please comment

Q: A 10 m long ladder with mass of 20 kg rests against a smooth wall at height of 8 m at an inclination…

A: Given:- The length of the ladder L = 10 m  The height of the wall is h = 8 m  The mass of the ladder…

Q: FD For the glenohumeral joint shown above, there are two muscle force: F, (deltoid) and Fs…

A: Given:- FD=400 N  at the angle of 10 ° with the vertical Fs=200 N at the angle of 25° with the…

Q: A metal weight of mass 15 kg rests on a smooth (that is, slope that makes an angle of 25° with the…

A: The forces acting on the metal bock are:N= Normal force due from the inclined plane, T= Tension in…

Q: Structural member AB is to be supported by a strut CD. Determine the smallest length CD may have,…

A: Solution: The given diagram is redrawn as given below.

Q: A 1.2-m plank of mass 3 kg rests on two joists. Knowing that the coefficient of static friction…

A: Part-a The length of the plank l = 1.2 m. The mass of the plank m = 3 kg. The coefficient of static…

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics. 

Equilibrium of Forces

The tension created on one body during push or pull is known as force.