A 1900-m3 water tower has been cleaned with a chlorine solution. The vapors of chlorine in the tower exceed allowable concentrations for the work crew to enter and finish repairs. If the chlorine concentration is 15 mg · m−3 and the allowable concentration is 0.0015 mg · L−1, how long must the workers vent the tank with clean air flowing at 2.35 m3 · s−1

A 1900-m3 water tower has been cleaned with a chlorine solution. The vapors of chlorine in the tower exceed allowable concentrations for the work crew to enter and finish repairs. If the chlorine concentration is 15 mg · m−3 and the allowable concentration is 0.0015 mg · L−1, how long must the workers vent the tank with clean air flowing at 2.35 m3 · s−1

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The 1-hour National Ambient Air Quality Standard for nitrogen dioxide (NO2) is 0.10 ppmv. Calculate the corresponding concentration in mg/m3 at a temperature of 25°C? show all work
Q2): 1200 BPD of 32 ° API crude oil is fed to an atmospheric distillation unit, the following products were obtained in the presence of 567 lb/hr steam. Assume vaporization temperature = 576 °F Volume, °API Mw T Latent heat CP, CPL Percent (Btu/Lb) (Btu/Lb °F) (Btu/Lb °F) (°F) Gasoline 26.8 62.8 286 110 0.615 120 0.59 Naphtha 5.63 52.8 113 155 335 0.604 0.58 420 Kerosene 19.8 45.6 185 100 0.60 0.604 Gas oil 510 10.6 39.4 240 0.615 90 0.63 510 Reduced 36.97 0.74 31.2 crude 576 Crude 100.00 0.5 535 Steam Check the gas oil plate temperature if the dew point and bubble point of gas oil are 600 ° F and 580 ° F respectively and the pressure at the withdrawn plate is 990 mm Hg. Given: 1 BPD = 42gal, pwater 8.324 lb/gal
70 m^3 of air flows in an intake airway towards a working section. Before entering the working section 10 m^3/s is drawn off and passed through a filter leaving with a dust concentration of 120p/ml. 50 m^3 is passed through a bulk air cooler leaving with a dust concentration of 100 p/ml. After the remixing of the air streams and before the air enters the working section,the dust count of the mixture is 130p/ml. Calculate the dust concentration of the original 70 m^3/s.
An ESP is to he designed to treat 9000 m3/min of gas to remove particles at 99.8% efficiency. Using Figure 5.10, estimate the required corona power in kW.
Question - There is a small spill of a toxic material on a paved surface of a chemical plant. This spill has width 0.8 ft and a length of 2.5 ft. The wind is a 10 miles per hour in the direction parallel to the length of the spill. Estimate the rate of evaporation in grams per hour. There is no toxin in the air at time 0 and at infinite distance from the spill. Assume air to behave as an ideal gas. Assume the toxic material can be considered an ideal solution with psat = 22 mmHg. MWtoxin = 164.4 g/mol, Ptoxin =1.69 g/cm³, Pair = .001225 g/cm³, Hair= 0.0187 CP, MWair = 28.9 g/mol, Dtoxin,air = 0.0888 cm²/s.
Refrigerant-134a at 300 psia has a specific volume of 0.2235 ft³/lbm. Determine the temperature of the re- frigerant based on (a) the refrigerant tables, (b) the ideal-gas equation, and (c) the generalized compressibility chart.
For what velocity of flow of water in a new, clean 6-inch schedule 40 steel pipe would an energy loss of 20 feet of head occur over a length of 1,000 ft? Compute the volume flow rate at that velocity. Then refigure the velocity using the design value of Ch for steel pipe.
Subject is Environmental Engineering
Example A storm water drain with a flow of 40 L/s and chloride concentration of 1200 mg/L is discharging into a small stream. The stream flow is 2.0 m3/s and chloride cóncentration of 20 mg/L. Calculate the chloride concentration in the stream after the discharge point. Assume steady state with complete mixing and no reaction.
14. Bench scale aeration test was performed on a sample of water evaluated for air stripping to remove VOCs. The target VOC is present in the water sample before aeration at 890 µg/L. The test data is given in the below table. Determine the order of the reaction. Show your work. Elapsed time of aeration (s) 15 30 45 65 90 120 Target VOC Effluent concentration (µg/L) 397 191 104 53 12 3
I need the answer as soon as possible