A 11.8-kg monkey climbs a uniform ladder with weight w = 1.27 × 102 N and length L = 3.60 m as shown in the figure below. The ladder rests against the wall and makes an angle of = 60.0° with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope that is frayed and can support a maximum tension of only 80.0 N. L 0 Rope (a) Draw a force diagram for the ladder. Choose File No file chosen (b) Find the normal force exerted on the bottom of the ladder. N (c) Find the tension in the rope when the monkey is two-thirds of the way up the ladder. N (d) Find the maximum distance d (along the ladder) that the monkey can climb up the ladder before the rope breaks. m (e) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (c) and (d)?

A 11.8-kg monkey climbs a uniform ladder with weight w = 1.27 × 102 N and length L = 3.60 m as shown in the figure below. The ladder rests against the wall and makes an angle of = 60.0° with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope that is frayed and can support a maximum tension of only 80.0 N. L 0 Rope (a) Draw a force diagram for the ladder. Choose File No file chosen (b) Find the normal force exerted on the bottom of the ladder. N (c) Find the tension in the rope when the monkey is two-thirds of the way up the ladder. N (d) Find the maximum distance d (along the ladder) that the monkey can climb up the ladder before the rope breaks. m (e) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (c) and (d)?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The drawing shows a uniform horizontal beam attached to a vertical wall by a frictionless hinge and supported from below at an angle 0 = 40° by a brace that is attached to a pin. The beam has a weight of 340 N. Three additional forces keep the beam in equilibrium. The brace applies a force P, and the hinge applies a force with a horizontal component H and a vertical component V. (a) Draw the free- body diagram showing the forces that act on the beam. Find the magnitudes of the forces (b) P, (c) H, and (d) V. Beam Hinge Pin Ꮎ Brace E
A ladder of length 12.0 m with a mass of 40.0 kg leans against a smooth wall. The ladder makes a 35.0o angle with the horizontal. Draw an adequate free body diagram of the ladder and determine the minimum coefficient of static friction between the ladder and the ground necessary to prevent the ladder from slipping.
A uniform ladder stands on a rough floor and rests against a frictionless wall as shown in the figure. Since the floor is rough, it exerts both a normal force N1 and a frictional force f1 on the ladder. However, since the wall is frictionless, it exerts only a normal force N2 on the ladder. The ladder has a length of L = 4.4 m, a weight of WL = 53.5 N, and rests against the wall a distance d = 3.75 m above the floor. If a person with a mass of m = 90kg is standing on the ladder, determine the following. (a) the forces exerted on the ladder when the person is halfway up the ladder (Enter the magnitude only.) N1 = ? N N2 = ? N f1 = ? N (b) the forces exerted on the ladder when the person is three-fourths of the way up the ladder (Enter the magnitude only.) N1 = ? N N2 = ? N f1 = ? N
A ladder of mass M and length L = 4 m on a level floor leaning against a vertical . The coefficient static friction between the ladder and floor is mus = .6 , while the friction between the ladder and the wall is negligible. The ladder is at an angle of 50 degrees above the horizontal . A man of mass 3M starts to climb the ladder. To what distance up the ladder can the man climb before the ladder starts to slip on the floor ? x= _______
A uniform beam of length L = 11.7 meters and mass of 109.3 kg is pinned at one end and is being supported by a wire as shown. The wire is connected to the beam x = 3.3 meters from the pin. A person of mass 81.6 kg is standing all the way out on the edge of the beam. If θ = 17.3 degrees and φ = 79.4 degrees, what is the tension in the wire?
A 5.2-m ladder rests against a wall as shown. The ladder has a mass of 27.6 kg. A 56.3-kg person stands on the ladder at a distance of 3.6 m from the bottom of the ladder. The foot of the ladder is 1.9 m from the bottom of the wall. Assume there is no friction between the ladder and the wall so that the force of the wall on the ladder is acting only in the horizontal direction. However, there is a friction force between the ladder and the ground. 1.) What is the force, in N, exerted by the wall on the ladder?
One end of a uniform 4.30-m-long rod of weight F is supported by a cable at an angle of = 37° with the rod. The other end rests against the wall, where it is held by friction as shown in the figure below. The coefficient of static friction between the wall and the rod is μ = 0.460. Determine the minimum distance x from point A at which an additional object, also with the same weight For can be hung without causing the rod to slip at point A. m 0 B ✪
A hiker, who weighs 659 N, is strolling through the woods and crosses a small horizontal bridge. The bridge is uniform, weighs 4280 N, and rests on two concrete supports, one on each end. He stops 1/5 of the way along the bridge. What is the magnitude of the force that a concrete support exerts on the bridge (a) at the near end and (b) at the far end?
A scaffold of mass 79 kg and length 5.0 m is supported in a horizontal position by a vertical cable at each end. A window washer of mass 84 kg stands at a point 1.1 m from one end. What is the tension in (a) the nearer (relative to the person) cable and (b) the farther (relative to the person) cable? (a) Number i Units (b) Number i Units
В 2. A 2.4 m ladder rests on a vertical wall as shown in the figure. The ladder has seven rungs and the rungs are spaced 0.30 m apart, and the top and bottom rungs are 0.30 m from their respective ends of the ladder. Surfaces at A and B both have the same coefficient of friction. If a worker weighs 630N and stands on the middle rung, determine the minimum value of the coefficient of friction so that the ladder does not slide. Neglect the weight of the ladder. ,0=60° A
+ A uniform ladder stands on a rough floor and rests against a frictionless wall as shown in the figure. Since the floor is rough, it exerts both a normal force N, and a frictional forcef, on the ladder. However, since the wall is frictionless, it exerts only a normal force N₂ on the ladder. The ladder has a length of L = 4.2 m, a weight of W, = 66.5 N, and rests against the wall a distance d = 3.75 m above the floor. If a person with a mass of m= 90 kg is standing on the ladder, determine the following. (a) the forces exerted on the ladder when the person is halfway up the ladder (Enter the magnitude only.) N₂ N₂- 4- (b) the forces exerted on the ladder when the person is three-fourths of the way up the ladder (Enter the magnitude only.) N₂ N₂ Additional Materials
A fence post of mass m = 8 kg supports a fence with three lengths of barbed wire. The bottom wire is a distance d = 0.35 m from the ground and each wire is a distance 0.35 m above the previous one. Each of these three wires has the tension on it. For this problem, assume that the force exerted by these wires is purely horizontal. An additional guy wire is used to keep the pole upright with a tension of Fa = 490 N. The guy wire attaches to the post at a point h = 0.86 m above the ground and makes an angle of θ = 45 with respect to the horizontal. Write an expression for the tension in any one of the three fence wires. What is the normal force that the ground exerts upward on the post?