A 10m long beam is supported by a steel rod and a hinge shown below. The rod is 20mm in diameter and the beam supports a uniform load of 1a kN/m. The weight of the beam is (11 x 1000) kg. A. Find the stress on the steel rod in Mpa B. Find the diameter in mm of the pin at B to if the allowable stress in the pin is 210 MPa C. Find the maximum force (kN) that can be applied to a steel pipe attached vertically to a rigid support if the allowable stress in the pipe is 10MPa. The outside diameter is 155mm and a thickness of 12mm.

Q: Cônnecting Ród óf å Diesel Engine cross section. It is subjected to a force of 85KN. Calculate the…

A: area of the I cross section is =2×21×6   +   5×35=427mm2=427×10-6m2

Q: Stepped bar ABC is fabricated out of aluminum and supported by a fixed support at C as shown. The…

A:

Q: The assembly in Figure consists of a light rigid bar AB, pinned at O, that is attached to the ste…

A: Given             Deflection = 5 mm          Area of steel = 250 mm2 Area of aluminum = 300 mm2 Find…

Q: A single-piece bicycle crank is shown below under the following load: the rider pedals forward with…

A:

Q: Problem: Figure shows a frame subjected to a load of 3.4 kN, find the resultant stress at A and B.

A:

Q: 2. A hollow generator shaft of 180-mm outer diameter and 120-mm inner diameter carries a torque T 40…

A:

Q: 10 kN В B y 6 m

A:

Q: The figure below shown that the three bars are supported a rigid beam ACE. ar CD is made of steel…

A: Given data, d= diameter of each bar =10 mm σAl=allowable stress for aluminum=120 MPa σsteel=…

Q: Find the tensile stress in MPa in member AB shown in the figure. All connection bars have square…

A:

Q: For the rigid bar (AB) and rod (BC) system, the normal stress in rod BC can't exceed 30 ksi. The…

A:

Q: Q6 A spherical vessel of 1.6m inner diameter is constructed by joining two hemispheres with equally…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.