.The bar ABCD in the given figure below consist of three (3) cylindrical steel segments, each with a different cross-sectional area. Axial load are applied as shown. Calculate the normal stress in each segment. 15000 Ibs 20000 Ibs D, 10000 lbs A IB

Q: The rigid bar AB shown below is supported by a steel rod AC having a diameter of 20 mm, and a block.…

A: Given data  Diameter of rod AC = 20 mm Distributed load on AB = 4 kN/m Find the axial normal stress…

Q: A 12 inches square steel bearing plate lies between an 8 inches diameter wooden post and a concrete…

A:

Q: A compression load of P = 55 kips is applied to a 3 in. by 3 in. square post, as shown. Determine…

A:

Q: hollow connecting rod has an inner diameter of 26.25 mm and is subjected to an axial tensile load of…

A:

Q: A cylindrical bar shown in the figure below has axial loads applied as illustrated Calculate the…

A:

Q: Stepped bar ABC is fabricated out of aluminum and supported by a fixed support at C as shown. The…

A:

Q: The assembly in Figure consists of a light rigid bar AB, pinned at O, that is attached to the ste…

A: Given             Deflection = 5 mm          Area of steel = 250 mm2 Area of aluminum = 300 mm2 Find…

Q: Problem 3: 4.2 m 5.0 m 200 KN 175 KN A (1) B (2) с 200 KN 175 KN A structural steel (E-220 GPa) has…

A:

Q: The part shown is made from AISI 1040 CD steel and is loaded at point C with 300 N in the positive y…

A: Given : material - AISI 1040 CD diameter of bar d = 12 mmYield strength for AISI 1040 CD is 415 MPa

Q: ximum tensil X1

A: given:length l=400mmthickness b=20mmdepth d=80mm

Q: A hook as shown in figure 2 is a symmetrical trapezium of 50 mm deep, the inner width being 60 mm…

A:

Q: + The forces are given in figure and applied as shown. 3 F,-100 KN Fq= 50KN and F3= 30 KN. The…

A: The main difference between twisting moment and bending moment is that their directions of moment.…

Q: The assembly shown in figure (5) consists of two posts AD and CF made of a steel (Ast= 1000 mm2, Est…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.