A 10 cm x 25 cm printed circuit board whose components are not allowed to come into direct contact with air for reliability reasons is to be cooled by passing cool air through a 25 cm long channel of rectangular cross section 2.5 mm x 90 mm drilled into the board. The heat generated by the electronic components is conducted across the thin layer of the board to the channel, where it is removed by air that enters the channel at 20 °C. The heat flux at the top surface of the channel can be considered to be uniform. If the velocity of the air at the inlet of the channel is not to exceed 5 m/s and the surface temperature of the channel is to remain under 55 °C, determine the maximum total power of the electronic components that can safely be mounted on this circuit board.

A 10 cm x 25 cm printed circuit board whose components are not allowed to come into direct contact with air for reliability reasons is to be cooled by passing cool air through a 25 cm long channel of rectangular cross section 2.5 mm x 90 mm drilled into the board. The heat generated by the electronic components is conducted across the thin layer of the board to the channel, where it is removed by air that enters the channel at 20 °C. The heat flux at the top surface of the channel can be considered to be uniform. If the velocity of the air at the inlet of the channel is not to exceed 5 m/s and the surface temperature of the channel is to remain under 55 °C, determine the maximum total power of the electronic components that can safely be mounted on this circuit board.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

kindly Solve it with detail . Graph of Cross section is also given below the question this is complete question . Thanks
Part c
How did you arrive at the 115?
For step one, I got the same values but negative
Jncct or pupci. 1. What is your mechanical advantage if you are using a 35 cm wrench on a bolt that has a diameter of 3 cm?
how can i see the rest of the answers
Choose one of the airplane part and based on that part answer the following questions for example the wing
i think question 1 and 8 us True. what do you think ?
skating is an example of Select one: O rotating friction O slipping friction O Rolling friction O sliding friction