A 1.5-m-diameter cylindrical tank is formed of 6-mm-thick sheet steel (E = 200 Gpa, ν = 0.3). The maximum shear strain occurring in this tank when the contents pressure is 1 MPa, is:

Q: A rubber pad is sandwiched between two steel plates subjected to shear force V = 400kN. The…

A:

Q: The normal strain measured on the outside surface of a spherical pressure vessel is 670 με. The…

A: μ=670 μ mm/mmd=1.20mt=10 mmE=73GPaν=0.33

Q: A pressurized steel tank has inner radius r = 0.5 m and wall thickness t = 20 mm. The steel has…

A: Given data: Before proceeding with the solution check whether it is a thin or thick pressure…

Q: A thick cylinder of 0.5 m external diameter and 0.4 m internal diameter is subjected simultaneously…

A: A cylinder whose diameter to thickness ratio is less than 20 is termed as thick cylinder.

Q: The more severe the change in geometry, the larger the stress concentration. Is it true or false?…

A: Stress concentration is a location in a member under load where the magnitude of stress is…

Q: The problem I am solving shows a point B on the OD of the pipe that lies on the z-axis.  When using…

A: Given: Outer diameter of the shaft: →Do=50 mm Inner diameter of the shaft: →Di=40 mm Because point B…

Q: For a thin-walled cylindrical pressure vessel with hemispherical end caps, constructed uniform…

A:

Q: The ring, with dimensions shown, is placed over a flexible membrane which is pumped up with a…

A: (a) To find: The axial force F in the ring in terms of p, w and r; Calculation: Consider a FBD by…

Q: A cylindrical rod has initial dimensions of length ? = 4 m and radius ? = 1 cm. When the rod is…

A: Given data: The external force, P = 200 kN. The change in length, L'=4.024 m. The change in radius,…