A thick cylinder of 0.5 m external diameter and 0.4 m internal diameter is subjected simultaneously to internal and external pressures. If the internal pressure is 25 MPa and hoop stress at the inside of the cylinder is 45 MPa (tensile), determine the intensity of the external pressure.

Q: The stresses shown on the left below act on horizontal and vertical planes through a point on the…

A: Principal stress is defined as the maximum or minimum value of normal stresses and they act on that…

Q: Determine the normal stress at bar AC. Use diameter of bar AC = 215 mm. B 500 N 2 m -J.- 2 m 451

A: According to the given dataThe diameter of the AC is 215mmWe need to findStress in the member AC

Q: A vertical arm pinned at A is supported by wire BC. If the arm is pulled such that it rotates…

A:

Q: A 4-ft diameter spherical tank is subjected to an internal pressure of 10 psf. If the wall thickness…

A: Given : Diameter, d = 4 ft = 48 in Internal pressure, P = 10 psf = 0.06944 psi [ 1 psi = 144 psf]…

Q: Determine approximately the principal stresses of a point whose stress states are shown below.…

A: In the above stress diagrams,  are not given with values so considered 0.

Q: y 3D The state of stress at a point is given by oxx = -93 MPa, ayy = 69 MPa, ozz = 58 MPa, oxy = 0…

A:

Q: A two-layered material is made of two metal bars, each with square cross-sectional area t² and…

A: Given: Thickness of each bar is t Increase in the temperature=∆T Let the coefficient of thermal…

Q: A spherical pressure vessel has an inside diameter of 4.8 m and a wall thickness of 9 mm. The vessel…

A:

Q: 0.4 m A 0.6 m M B 0.4 m 0.4 m Determine the magnitude of the pin force at B. Take M = 92.8 Nm. Give…

A: Step 1: Step 2:

Q: A cylindrical pressure vessel is fabricated from steel plating that has a thickness of 20 mm. The…

A:

Q: No Normal stress acts on the neutral axis. Is it true or false? How?

A: When a beam is subjected to a bending moment the beam undergoes either hogging or sagging. In both…

Q: in Fig. P2-89. U

A: given:

Q: The propane storage tank shown in Photo has an outer diameter of 3.3 m and a wall thickness of 18…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: A spherical pressure vessel of 5.7 meter diameter is subjected to an internal pressure of 3.8 MPa.…

A: Given data  d=5.7 mP=3.8 MPat=5 mm Here, d is the diameter, P is the pressure on the vessel.  Now we…

Q: The more severe the change in geometry, the larger the stress concentration. Is it true or false?…

A: Stress concentration is a location in a member under load where the magnitude of stress is…

Q: The two pistons at the ends of the cylinder gradually increase the air pressure. The circumferential…

A:

Q: A typical aluminum-alloy scuba diving tank is shown in the figure. The outside diameter of the tank…

A:

Q: A thick-walled cylinder has an outer and inner diameter of 200 and 50 mm, respectively. The…

A:

Q: nd hemispherical shells, The bol and the 25 mm diameter bo able normal stress of 150 M

A: given data  tank thickness = 50 mm no of bolt/ length = 40  dia of bolt =25 mm allowable stress for…