A 1.25 in.-square steel punch is to push through an aluminum plate that is supported on a die, thus forming a square opening in the plate. a. If the allowable compressive stress in the plate is 24 ksi, what is the maximum punching force, in pounds, that this die can exert on the plate? b. If the aluminum has an ultimate shear strength of 6500 psi, find the maximum thickness t, in inches, through which a hole may be punched. Write to three decimal places. Punch force Steel punch Aluminum plate, Die Punched piece

A 1.25 in.-square steel punch is to push through an aluminum plate that is supported on a die, thus forming a square opening in the plate. a. If the allowable compressive stress in the plate is 24 ksi, what is the maximum punching force, in pounds, that this die can exert on the plate? b. If the aluminum has an ultimate shear strength of 6500 psi, find the maximum thickness t, in inches, through which a hole may be punched. Write to three decimal places. Punch force Steel punch Aluminum plate, Die Punched piece

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Solve
Q5: At a point in a strained material the stresses acting on planes at right angles to each other are o, 30, MN/m² tensile, together with associated shear stresses which assumed clockwise in effect on oy plane. If the maximum principal stress is limited to 1002 MN/m² tensile, and xy-60 MN/m², calculate: (a) the magnitude of the o, and oy; (b) the values of the maximum and minimum principal stresses; (c) the directions of the principal planes; (d) the maximum shear stress.
What force is required in Newton to punch a 30-mm diameter hole in a plate that is 15 mm thick? The shear strength is 350 MN/m^2. question 2: A type of stress that acts coplanar with cross section of material.
A bandsaw manufacturer uses 10 inch diameter drums. If the allowable stress in the sawblade is 72 ksi, what is the blade thickeness? (Final answer in inches) +
Two plates are held together by 4, 28 mm diameter bolts. If a 25 kN load is applied to the plates in shear, what is the shear stress in the bolts in MPa?
Write answer