9). The conditions u (0, t) = u (1, t) = 0 and ôu/ôt = 0 are necessary conditions for.... a). ID heat flow b). 2D heat flow c). vibrating string d). ID steady heat flow
Q: 4. We are heating water in a closed pot 30Kj of heat is given to the pot while 5kJ is wasted through…
A: Given Initial energy of system = U1 = 10 kJ Net amount of heat system takes Q = 30 - 5 = 25 KJ…
Q: A scientist adds 193 g of water at 51°C to ice at 0°C. If the final temperature of this closed…
A:
Q: A sample of an ideal gas is held in a container that cannot change in size. If 10 J of heat energy…
A: The first law of thermodynamics states that the change in internal energy (ΔU) of a closed system is…
Q: P 4m 3m 6m IF q=64C. what is the E at point P Select one: O a. E= 108X109 N/C O b. E= 216X109 N/C…
A:
Q: 2. For gases it is easiest to use the temperature as the quantity to analyse stability. An air…
A: Given: A U.S standard temperature at 100 m height is T = 288.15 K The rise in temperature of the air…
Q: A small container full of water is isolated from its surrounding. The water is then vigorously…
A: We have container in an isolated system i.e., it can't exchange heat with its surrounding so it is…
Q: 4m/s 450 300 a) What is the speed of ball A after the oollision? VA- b) What is the speed of ball B…
A: Given, mass of ball A mA=5 kgvA=4 m/smB=5 kg
Q: The thermal energy in 8.0 kg of water at 30°C increases by 8000 J. What is its new temperature?
A:
Q: 2. The brakes in a car increase in temperature by ΔT when bringing the car to rest from a speed v.…
A: In this problem, part b is not the part of the question but it is the suggestion. (a) Write the…
Q: Object 1 has three times the specific heat capacity and four times the mass of Object 2. The two…
A:
Q: Heat(Q) depends on ..............choose one correct answer A. Mass of the objects, change in…
A: The specific heat is the measure of heat per unit mass required to increase the temperature by one…
Q: What force needed to stretch a spring with k = 100 N/m a total of 20 mm? А. 1 N В. 3 N C. 2 N D. 100…
A:
Q: (a)If Ideal gas molecules do not collide,these molecules will do [] A. uniform motion in A straight…
A: (a) Ideal gas molecules which are not under influence of external forces will never exhibit simple…
Q: 2.) Air is both a good thermal insulator and conductor. a. True b. False
A: The given statement is False. Air is a good thermal insulator but not a good conductor.
Q: A. Mechanical equivalenta of heat ן"ד"M'u) B. Water equivalent C. Rate of evaporation measurement of…
A: We are allowed to give the explanation of first three subparts of a question only which is given…
Q: When the temperature of an ideal gas is doubled, the average kinetic energy... a. remains the same…
A: Average kinetic energy: The average kinetic energy of gas particles is directly proportional to the…
Q: A) System: N oscillators and q = 1. Calculate the number of microstates. B) System: N = 3; q = 4.…
A:
Q: 3. Suppose that 150 J of work is done on a system and 35.0 cal is extracted from the system as heat.…
A:
Q: Which of the following statements is TRUE regarding a thermodynamic system? * A. It must be isolated…
A: Thermodynamical system is the system in which all the thermodynamical variable thermodynamical…
Q: 36) During an isothermal process, 5.0 J of heat is removed from an ideal gas. What is the change in…
A: The change in the internal energy of n mole of an ideal gas is ΔU=nCvΔT .....(1)where Cv is…
Q: Pressure B C ЗР Po = 1.0 atm Vo = 100 L Po A Volume Vo 3Vo
A: Apply the thermodynamic relation of ideal gas equation between points A and B.
Q: Is this one of the four special thermodynamic process we studied? If yes, which one? If no, say so.
A: The curve for the isobaric process follows the following equation : P=constant That means the curve…
Q: A cyclic process involving one mole of an ideal gas is shown below. a. Determine the work done on…
A:
Q: Thermal energy of the water in a bathtub is ________ than in a freshly brewed coffee pot because of…
A: The given statement : Thermal energy of the water in a bathtub is ________ than in a freshly brewed…
Q: An iron block weighs 5N and has a volume of 200 cm^3. What is the density of the block in kg/m^3?…
A: Density of any material is defined as the mass per unit volume and it is given by the expression ρ =…
Q: 5. A Cycle consists of : heat transfer into the system of 20kJ, work transfer into the system of…
A:
Q: 4.) A material of mass m is heated using 5.00 calories of heat and its temperature rises by one…
A:
Q: 1 K calorie is approximately equal to: a. 41.86 J b. 418.6 J c. 4.186 J
A: Required : 1 K cal in joules.
Q: Which of the following statement best describe absolute zero temperature? a. Highest possible…
A: 1.Absolute zero temperature is the lowest possible temperature that we could think of.b. Lowest…
Q: When an ideal gas confined to a rigid glass container is heated, its pressure and temperature both…
A:
Q: Determine the temperature at which the average kinetic energy of an ideal gas is 8.7x10-21 J A. 307…
A:
Q: Heat is added to a sample of an ideal monatomic gas. Which one of the following statements is…
A:
Q: The specific heat capacity of metals are normally much smaller than that of water. If we should…
A: It is given that specific heat capacity of water is much more than specific heat capacity of metals…
Q: An ideal diatomic gas follows the thermodynamic cycle illustrated in the given PV-diagram. The…
A:
Q: 15. (Application of the 1st Law of Thermodynamics in a closed system) A person weighing 90 kg eats 2…
A: Given, 2 hamburger, one packet of french fires and 200 ml of soda for lunch
Q: 2. As an example of microscopic thermodynamic analysis based on thermal-energy microstates, the…
A:
Q: Make a table to differentiate the characteristics of pressure, volume, temperature, change internal…
A: isothermal adiabatic
Q: How much heat must be added to 120 g of water at an ini- tial temperature of 60°C to a. heat it to…
A: Note :- Standard values are approximate Values so answer is also comes in approximate value. Units…
Q: 11) When a perfect gas undergoes a reversible isobaric process, the change in entropy is b. nCy In…
A:
Q: If the temperature of the surface of the object is 511.9 °F, then calculate its value in K. O a.…
A: Given that, The temperature of the surface of the object is 511.90F. We need to write the…
Q: A piece of steel having mass 3 kg, heat capacity of 844 J/K. Calculate; a. specific heat capacity b.…
A:
Q: Steam enters a turbine with an enthalpy of 3300 KJ/kg and leaves with an enthalpy of 2400 kJ/kg. The…
A: Given , Steam enters a turbine with an enthalpy of 3300 KJ/kg and leaves with an enthalpy of 2400…
Q: 2. As an example of microscopic thermodynamic analysis based on thermal-energy microstates, the…
A: In both Conditions, 1st Calculate number of microstate of both system. Then put into entropy formula…
Step by step
Solved in 2 steps