9. For the LiBr-water machine shown below, determine: a. The heat required at the generator (BTU/min) per ton of cooling b. The COP c. The EER d. Heat Rejection Ratio, HRR = (Qstsorber + Qcondenser)/Qevaperator O Superheated water vapor Heat Q. Condenser Heat S0mm H Generator Saturated liquid Pump Saturated vapor Absorber Evaporator 10 mm He Q - 12.000 Btu/hr Heat

Q: Make a two DOF linkage with the amount of seven links. Use links that are quaternary and make sure…

A: Make a two DOF linkage with the amount of seven links.Use links that are quaternary and make sure…

Q: I have three parts that need to be answered pertaining to the print provided below.   With respect…

A: The shape of the material at the connection between the part subassembly 1 and subassembly 2 is…

Q: Consider a two-stage cascade refrigeration system operating between the pressure limits of 1.2 MPa…

A: Solution to A and B as mentioned by the student:

Q: Don't use chat gpt

A: a. mechanical advantage of hoist=3mapparent​=31−350​=14.33lbTo use momentum-impulse, max speed is…

Q: How many links are there in this mechanism? The shaded cross-sectional areas are part of the ground.…

A: Kinematic Link or element - In every part of the machine which is having some relative motion with…

Q: - 20 cm long ground link - 10 cm long

A: To create a four-bar linkage with an output link that can make complete circles, you can use the…

Q: Consider a two-stage cascade refrigeration system operating between the pressure limits of 1.2 MPa…

A:

Q: Put in ternary links without changing its mobility. Sketch linkage.

A: Given drawing of the ternary link mechanism or  four bar mechanism

Q: Match the symbol to the component: а. Pump b. Motor c. Cylinder with retract cushion d. Pressure…

A:

Q: Draw the kinematic diagrams of the following mechanisms and compute the number of Degrees of Freedom…

A: A typical foot pump along with its joints and links is shown below.

Q: What are two things that gear boxes typically used for?

A: The gearbox is used to increase the torque of the main shaft while the speed of  the shaft is…

Q: Which of the followings is NOT a reason of mesh incompatibility.

A: This question is based on the concept of meshing from finite element analysis.