9-21. Determine the slope and displacement at point C. Use the principle of virtual work. El is constant. 9-22. Solve Prob. 9-21 using Castigliano's theorem. A 6 kN/m 3 m C 15 kN Probs. 9-21/22 3 m B

Q: 15-3. The brick wall exerts a uniform distributed load of 20 kN/m on the beam. If the allowable…

A: draw FBD

Q: Don't use chat gpt It Chatgpt means downvote

A: The shear force at section C is Vc = 3.5kipThe moment at Point C is Mc = - 47.5kip The shear force…

Q: 12-83. The W250 x 22 cantilevered beam is made of A-36 steel and is subjected to the loading shown.…

A:

Q: Determine the slope of the shaft at the bearing support A. EI is constant.

A: Find Reactions at A and B by resolving UVL into point loads.

Q: Determine reaction of hinge and roller support bearing of over hanging beam as shown in Fig. 8 kN/m…

A: Determine reaction of hinge and roller support bearing of over hanging beam as shown in Fig.

Q: 7-6. Determine the distance a as a fraction of the beam's length L for locating the roller support…

A: Determine the distance a as a fraction of the beam's length L. for locating the roller support so…

Q: With the following modifications: Change the first 3m length to 5m (the second 3m length stays the…

A:

Q: * Find the Resultant ? orce 1.5mm If You know 8- ⇒Fr55-30₂ F₁ = 1/3 F₂, F3 = 25₁ 0₂ F2 Fi PX

A:

Q: Determine the shape factor for the wide-lange beam.

A: The shape factor is dimensionless and depends upon the shape and is used to enhance the efficiency…

Q: 9-22 Solve Prob. 9-21 using Castigliano's theorem. Internal Moment Function M(x): The internal…

A: For the solution refer below images.

Q: Determine the slope and displacement at point A. EI is constant. Use the principle of virtual work.…

A: Now draw the free body diagram for the above problem and apply the dummy moment at point A.

Q: 1- The vertical reaction at B is given (16.5 to upward). () Determine the vertical reaction at…

A:

Q: Determine the components of the support reaction at the fixed support A of the beam shown. You must…

A: Given Data The uniform distributed load acting on the beam is: w1=0.5 kN/m The uniform varying load…

Q: 12-23. Determine the moments acting at the ends of each member of the frame. El is the constant.

A: Given    Load = 1.5 /ft Length = 24 ft Height = 20 ft Find   Moment at each end

Q: Determine the slope of the shaft at the bearing support A. EI is constant.

A: Given data: load = wo Total length of beam = L EI=constant Determine the slope of the shaft

Q: 7-58 Plot shear and moment diagrams for the beams shown in the figure.

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.