9.automatically Swings open to drain the marsh B. For thereactions developed at the hinge C and stop block D. Thecondition of high tide shown, determine the horizontal*9-120. When the tide water A subsides, the tide gate9-123. The factor of safdefined as the ratio of theweight divided by the cthe water pressure. Det-density of peone = 2.5 Mleneth of the gate is 6 m and its height is 4 m. p= 1.0 Mg/m³.a distributeddefined by5), wherePoof the plate.e resultant4 m3 m2 m

Given: The length of the gate is 6 m. Height of the gate is 4 m. The arrangement is shown below:

*9-120. When the tide water A subsides, the tide gate automatically swings open to drain the marsh B. For the condition of high tide shown, determine the horizontal reactions developed at the hinge C and stop block D. The leneth of the gate is 6 m and its height is 4 m. pw = 1.0 Mg/m. 4 m 3 m 2 m

*9-120. When the tide water A subsides, the tide gate automatically swings open to drain the marsh B. For the condition of high tide shown, determine the horizontal reactions developed at the hinge C and stop block D. The leneth of the gate is 6 m and its height is 4 m. pw = 1.0 Mg/m. 4 m 3 m 2 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A tank contains a liquid of relative density 0.80. The height of the tank is 4, and the width of the…

A: The relative density, RD = 0.8 The height of tank, H = 4 m The width of tank, b = 2 m The…

Q: Determine the surface tension of liquid in contact with air and a glass tube. If the capillary tube…

Q: A large vertical dam in the shape of a symmetric trapezoid has a height of 30 m, a width of 20 m at…

A: Given data: The height of the symmetric trapezoid is: h = 30 m. The width of the symmetric…

Q: Surface AB is a circular arc with a radius of 4 m and a width of 4 m into the paper. Determine the…

Q: 5-85* The width of the rectangular gate shown in Fig. P5-85 is 8 ft. Determine the magnitude of the…

A: Given Data: The width of the rectangular gate is w = 8 ft. The density of the water is γ = 62.4…

Q: reactions developed at the hinge C and stop block D.

A: Given data,the length of the gate L = 6 mthe height of the gate h = 4 mthe density of the water Find…

Q: A 4-m-long quarter-circular gate of radius 2 m and of negligible weight is hinged about its upper…

A: The problem can be sketched as follows, The free-body diagram of this problem will be as follows,

Q: F2-16. The tank has a width of 2 mand is filled with water. Determine the horizontal and vertical…

A: For solution refer below images.

Q: 9-102. The elevated water storage tank has a conical top and hemispherical bottom and is fabricated…

Q: Pl6-1. Set up the relative velodity equalion between points A and . 1m ()

A: Given: The angular velocity of smallest member, ω = 6 rad/s The length of the smallest member, x = 1…

Q: The 500-kg load on the hydraulic lift shown is to be raised by pouring oil (? = 780 kg/m3) into a…

A: Given data To determine the height of the column in the right side to lift the weight in left…

Q: The water flows to the nozzle through a 180-degree elbow. The pipe diameter D-75mm, the nozzle…

Q: The curved surface given in the figure is defined by y = 3 x−−√x . Determine the horizontal force…

Q: Q2 The truck dumps water on the ground such that it flows from the truck through a 100-mm-wide…

A: PAρg+VA22g+ZA=PBρg+VB22g+ZB0+0+1.75=0+VB22×9.81+0VB=5.85 m/sDischarge at BQB=ABVBQB=2×0.15.85QB=1.17…

Q: *5-16. The level of mercury in the manometer has the reading shown. Determine the veloci- ty of the…

Q: *10-24. A-in.-diameter hose is used to fill the reservoir with water. If the pressure at the supply…

Q: A 4-m-long quarter-circular gate of radius 3 m and of negligible weight is hinged about its upper…

Q: 4. An upright tank, full of water, has a height of 2m and a triangular base (cross section). If the…

Q: A cast iron pipe (roughness =0.26 mm or 0.010 inches) having a diameter of 100 mm is used to fill…

Q: 5-87* The width of the rectangular gate shown in Fig. P5-87 is 4 ft. Determine the magnitude of the…

A: Consider the diagram shown below for the given dam.

Q: An open cylinder tank, D= 1.0m, h=1.5m, contain water at depth 1.0m. If this tank rotate about its…

A: Write the given values with suitable variables. D=1 mR=D2=1 m2=0.5 mh=1.5 my=1 m Here, D denotes the…

Q: Determine the resultant force acting on the 0.7-m-highand 0.7-m-wide triangular gate and itsline of…

A: Write the expression of the angle β. Write the expression of the area of the triangular section.

Q: 5-90 The width of the cylindrical gate shown in Fig. P5-90 is 4 ft. Determine the magnitude and the…

A: Draw the pressure points on the gate. Draw the free-body diagram of the gate.

Q: )The sied Shown slides along a thin horizontul layer of water between the ice and the runner. Ihe…

Q: What is the minimum Block mass (kg) that is required to open the gate A-B? The density of water is…

A: we need to calculate the mass of the block

Q: 18. If the truck has a constant acceleration of 2 m/s, determine the water pressure at the bottom…

Q: Q3) An inclined rectangular gate AB (3m wide and 1.5m height), is installed to control the discharge…

Q: e la a a g. agua h A 0 2,1 m 2,8 m

Q: The gate AB is 8 m wide. Determine the hori- zontal and vertical components of force acting on the…

A: Given data: Width of the gate, b=8 m The density of the water, ρ=1 Mg/m3 Pascal's Law: According to…

Q: the water in a reservoir is controlled by a hinged gate. Determine the width of the gate in meters,…

Q: Oxygen in a tank has an absolute pressure of 130 kPa. Determine the pressure head in mm of…

Q: 2-69. The tapered settling tank is filled with oil. Determine the resultant force the oil ex- erts…

Q: The 5 m high and 6 m wide rectangular cover is hinged from point A on its upper edge and is…

Q: The field storage tank is filled with oil to the level shown. The stand pipe is connected to the…

A: For solution refer below images.

Q: 9-127. The 2-m-wide rectangular gate is pinned at its center A and is prevented from rotating by the…

Q: Determine the capillary rise of the water in the glass tube of diameter 0.68cm, which is immersed…

A: In capillary rise and fall, the main cause is the dominance of one force over another. If adhesion…

Q: The rectangular panel, which is 4 m wide, 3 m high block the end of a 3 m deep water channel. The…

A: Given, width of the rectangular panel , B = 4m Height of the rectangular panel , H = 4m Height of…

Q: 2=z01)“ as shown. he dam has ae 20=3m and the height of water reta >7-3. The ffluid is weter,…

Q: 36-45. A study shows that the average volume flow rate of water at Matuno river located at Nueva…

A: Volume flow rate Q=2 m3/secPower plant cost =45 million pesosEstimated breakeven life =15 yearEnergy…

Q: If the wall is 3.5 m, determine an show the resultant force that water exert on the overhang sea…

A: Draw the cross section of the sea wall as shown in figure (1). Determine the location of centroid…

Q: t force acting on the 0.7m high and 0.7m wide triangular gate and its line of action?

Q: 9.30 f -7.50 A Oil Ng=0.85 Longitud: 8ft

A: To Find: The force acting on the curved surface. Given: The specific gravity of oil is SG=0.85. The…

Q: The system shown is carrying a fluid with specific gravity 0.70 and is in a horizontal plane. If…

Q: A barrier is made from a homogeneous material and consists of one quarter of a circular cylinder…

Q: 4 ft 30 ft

A: Here, tank volume can be divided in to two parts. (i) Volume of cylindrical portion having 30 ft…

Q: Neglecting viscous resistance determine the force of the water per unit of width acting on a sluice…

A: given data: upstream depth=5ft downstream depth=0.6ft force(F)=?

Q: Determine the magnitude and location of the resultant force acting onthe triangular end plates of…

A: Given: The density of the water, ρ = 1000 kg/m^3 The height of the triangular plate, h = 1 m The…

Concept explainers

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.

Question

9.
automatically Swings open to drain the marsh B. For the
reactions developed at the hinge C and stop block D. The
condition of high tide shown, determine the horizontal
*9-120. When the tide water A subsides, the tide gate
9-123. The factor of saf
defined as the ratio of the
weight divided by the c
the water pressure. Det-
density of peone = 2.5 M
leneth of the gate is 6 m and its height is 4 m. p
= 1.0 Mg/m³.
a distributed
defined by
5), where
Po
of the plate.
e resultant
4 m
3 m
2 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A tank contains a liquid of relative density 0.80. The height of the tank is 4, and the width of the tank is 2m. The tank is subjected to the acceleration of 5m/s^2 along a 30o inclined plane in the upward direction. Under this condition, there is no loss of liquid. determine the slope of free surface determine the pressure at point A and point B
5-89 The width of the rectangular gate shown in Fig. P5-89 is 3 ft. Determine the magnitude of the resultant force R exerted on the gate by the water (y = 62.4 lb/ft) pres- sure and the location of the center of pressure with respect to the hinge at the bottom of the gate. B 8 ft 5 ft 60° 45°
Determine the horizontal force required to hold the plate stationary against the water jet. Plate Q=0.05m²³/ Water D=0.3m +F
Determine the upward thrust F on the .5 semi-cylindrical top of the container shown below. The container is full of oil under a pressure of 2 × 105 Pa Oil Y= 8.15 kN / m32 5 m Greater than 2000 kN Less than 1000 kN Greater than 1000 kN R= 0.75 m 2 m
The canal shown, which is in a form of a quarter circle, runs 9.3 m. into the paper. Determine the depth of the center of pressure (in meters). Use R = 15. Answer : 12.65m.
Assuming non-viscous flow, determine the traction force on the flange's bolts shown. We have y=1.8 m; d1=50 mm; d2=100 mm; d3=25 mm. The specific gravity of the manometric liquid is SG= 0.80. Express the result in N.
.
A 6-m-high, 5-m-wide rectangular plate blocks the end of a 5-m-deep freshwater channel, as shown . The plate is hinged about a horizontal axis along its upper edge through a point A and is restrained from opening by a fixed ridge at point B. Using appropriate software, investigate the effect of water depth on the force exerted on the plate by the ridge. Let the water depth vary from 0 to 5 m in increments of 0.5 m. Tabulate and plot your results.
A 11-m-high, 5-m-wide rectangular plate blocks the end of a 10- m-deep freshwater channel, as shown in the figure. The plate is hinged about a horizontal axis along its upper edge through a point A and is restrained from opening by a fixed ridge at point B. Determine the force exerted on the plate by the ridge. 1 m 10 m В DI
Q1. Find the horizontal thrust of the water on each foot of width of the sluice gate, given y₁ = 7 ft, y2 = 1.2 ft, and y3 = 1.4 ft. Neglect friction Water Y3 Gate 17
3. Determine the weight per meter of length of the semi-circular gate shown below that would maintain the water depth at 4m. Pt Answer hint 64,4 kN
5 Consider a two-port tank as shown in the figure given below with D₁ = 4 cm, V₁ = 18 m/s, D2 = 7 cm, and V2 = 8 m/s as shown. If the tank surface rises at 130 mm/s, determine the tank diameter. Tank area A₁ ----· Fixed CS m Pa Pw