8. The drawing shows a top view of a square box lying on a frictionless floor. Three forces, which are drawn to scale, F, act on the box. Consider an angular acceleration with respect to an axis through the center of the box (perpendicular to the page). Which one of the following state- ments is correct? (a) The box will have a F F2 translational acceleration but not an angular acceleration. (b) The box will have both a translational and an angular acceleration. (c) The box will have an angu- lar acceleration but not a translational acceleration. (d) The box will have neither a translational nor an angular acceleration. (e) It is not possible to determine whether the box will have a translational or an angular acceleration.

8. The drawing shows a top view of a square box lying on a frictionless floor. Three forces, which are drawn to scale, F, act on the box. Consider an angular acceleration with respect to an axis through the center of the box (perpendicular to the page). Which one of the following state- ments is correct? (a) The box will have a F F2 translational acceleration but not an angular acceleration. (b) The box will have both a translational and an angular acceleration. (c) The box will have an angu- lar acceleration but not a translational acceleration. (d) The box will have neither a translational nor an angular acceleration. (e) It is not possible to determine whether the box will have a translational or an angular acceleration.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A gymnast on the uneven parallel bars is at rest, tipped at a 45° angle from the vertical. The distance from her hands to her feet is 1.8 m. If we model her body as having a uniform cross section and assume that her center of gravity is midway between her hands and her feet, what is her initial angular acceleration?
A uniform drawbridge must be held at a 37° angle abovethe horizontal to allow ships to pass underneath. The drawbridge weighs45,000 N and is 14.0 m long. A cable is connected 3.5 m from thehinge where the bridge pivots (measured along the bridge) and pullshorizontally on the bridge to hold it in place. What is the angular speed of the drawbridge as it becomes horizontal?
A circular disk has a rotational inertia of 8.9 kg.m² and a constant angular acceleration of1.9 rad/s². If it starts from rest the work done during the first 7.5 s by the net torque acting on it is:
Suppose you exert a force of 185N tangential to the outer edge of a grindstone (which is a solid disk) with a radius of 1.56m and a mass of 74kg. What is the angular acceleration of the grindstone αf, in radians per square second, if there is an opposing frictional force of 22.5 N exerted 0.45 m from the axis?
A car is undergoing an emissions test. The car is stationary on rollers while the gas pedal is depressed until the speedometer reads 60 km/h. The wheels are 54 cm in diameter. Find their angular speed.
An automobile engine can produce 253 Nm of torque. Calculate the angular acceleration (in rad/s2) produced if 80.2% of this torque is applied to the drive shaft, axle, and rear wheels of a car, given the following information. The car is suspended so that the wheels can turn freely. Each wheel acts like a 15.0 kg disk that has a 0.180 m radius. The walls of each tire act like a 2.00 kg annular ring that has inside radius of 0.180 m and outside radius of 0.320 m. The tread of each tire acts like a 10.0 kg hoop of radius 0.330 m. The 12.1 kg axle acts like a rod that has a 2.00 cm radius. The 29.7 kg drive shaft acts like a rod that has a 3.20 cm radius. rad/s² t Additional Materials Reading
To prepare a weaving loom, you wind a length 2.8 m of yarn onto a reel of radius 3.0 cm. This takes a time of 9.3 s. What is the angular speed of the reel.
Consider the 13 kg motorcycle wheel shown in the figure. Assume it to be approximately a ring with an inner radius of 0.285 m and an outer radius of 0.325 m. The motorcycle is on its center stand, so that the wheel can spin freely. If the drive chain exerts a force of 2200 N at a radius of 4.95 cm, what is the angular acceleration of the wheel, in radians per square second? What is the tangential acceleration, in meters per square second, of a point on the outer edge of the tire? How long, in seconds, starting from rest, does it take to reach an angular velocity of 89.5 rad/s?
The tires on a car have a diameter of 0.70 m. If the car moves in a straight line with a speed of 25.2 km/h through a level parking lot, what is the angular speed of the tires?
A bowling ball encounters a 0.760-m vertical rise on the way back to the ball rack, as the drawing illustrates. Ignore frictional losses and assume that the mass of the ball is distributed uniformly. The translational speed of the ball is 7.95 m/s at the bottom of the rise. Find the translational speed at the top. Number i Units + 0.760 m
Consider the 15.0 kg motorcycle wheel shown in the figure. Assume it to be approximately an annular ring with an inner radius of R1 = 0.280 m and an outer radius of R2 = 0.480 m. The motorcycle is on its center stand, so that the wheel can spin freely. a)If the drive chain exerts a force of 2450 N at a radius of 5.00 cm, what is the angular acceleration of the wheel in rad/s2? _____rad/s2 (b)What is the tangential acceleration, in m/s2, of a point on the outer edge of the tire? ______m/s2 (c)How long in seconds, starting from rest, does it take to reach an angular velocity of 80.0 rad/s? _______s
The figure below shows a human arm that weighs 41.10 N. The arm is extended outward and is motionless. The gravitational force Fg on the arm acts at point A, a distance of 0.2900 m from the shoulder joint, which is represented by point O. The shoulder pushes down and to the right on the humerus bone of the arm with a force Fs at point O, at an angle ? as shown. The deltoid muscle pulls back on the arm toward the shoulder with a tension force Ft. This tension force acts at a point 0.08000 m to the right of point O, and it is directed up and to the left, at a 12.00° angle with respect to the horizontal. An arm is extending horizontally to the right with a cutout that shows muscles in the upper arm. A horizontal dashed line extends along the bottom of the muscles and another along the top. Point O is labeled at the left end of the arm on the lower horizontal line. An unlabeled point lies 0.080 m horizontally to the right of point O. Point A lies 0.290 m horizontally to the right of point…