8. a). What are the values of the inductor voltage and current and the capacitor voltage and current assuming the switch has been closed for a very long time. VL= IL = Vc= Ic 10 V 1H V₁ 000 502 202 Ic↓ 1F

8. a). What are the values of the inductor voltage and current and the capacitor voltage and current assuming the switch has been closed for a very long time. VL= IL = Vc= Ic 10 V 1H V₁ 000 502 202 Ic↓ 1F

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: At 0-, no currrent flows through the capacitors because they are open, how did you combine the…

Q: certain machine is a defective capacitor. The capacitor is connected to a 240-V AC circuit. The…

A: Given that Capacitor(old) has a capacitance C=10micro Faraday. Voltage rating of capacitor = 240AC…

Q: For the inductor group below, determine the equivalent inductance: L1 L2 12mH OmH L3 OmH

A: In this question, find the equivalent inductance across the terminal. We are solving this problem…

Q: Show that (а) Ifx() even, then S",x(1) dt = 2 f, x(t) dt II а

A: Since the function xt is even, the following relation is valid: xt=x-t--->(1) In this case, the…

Q: capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its…

Q: An inductor is "charged" to some value, then connected in series with a 1002 resistor and allowed to…

A: Step 1:

Q: Determine the total capacitance, total charge, ndividual voltage drop and charges across each…

A: Given C1 =34C2 =46C3 =28C4 =43 C5 =24C6 =29C7 =38C8 =23 C9 =32C10 =23V=110 V

Q: A capacitor C with 1 mF is charged by a constant voltage source (U). Source and capacitor are…

A: Given Data:A series RC circuit with,A current source To Find:The sketch of the capacitor voltage.

Q: 1. Series RL Given: E -12V Complete the table below t 0 Ιτ 2t = 3t = 4t= 5t= = I R 50 L 1mH ER EL…

A: Here RL series circuit is given.R=5ΩL=1mHV=12vis given.and we have to find Current through the…

Q: In the figure ɛ = = 1.00 N. The inductor is ideal. If the switch is closed for a long time, what is…

A: The response due to long time DC indicates steady state value. In steady state, inductor acts as…

Q: What are the voltage and current polarities in an inductor when the inductor is switched from being…

A: For the given RL and RC circuit the value of voltage and inductor needs to be calculated based on…

Q: A 20-ohm resistor and a capacitor are connected in series with a battery of 60 volts. At t = 0,…

A: for RC circuit, Initially capacitor voltage is 0

Q: A 40 micro-farad capacitor is connected in series with a 40 ohm resistor. If the voltage is 220-V,…

A: Series circuit consists of Voltage, V = 220 V Capacitance, C = 40microF Resistor, R = 40 ohm…

Q: In an L-R-C series circuit, the source has a voltage ampli- tude of 120 V, R 80.0 l, and the…

A: "Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: . Voltage across capacitor is ve. With ve and it as a set of state variables derive the state model.…

Q: What is the value of the induced voltage of the self-inductance when the rate of current is from 200…

A: First, find the rate of change of current, didt=20μ-200μ5u=-36 A/s Let the self-inductance of the…

Q: A parallel plate capacitor has an electrode area of 100 mm2 , with spacing of 0.1 mm between the…

A: Given, A parallel plate capacitor has An electrode area, A= 100 mm2 Spacing, d= 0.1 mm The…

Q: 5. What is an inductor and what are its types? Explain the terms in detail. 1. Self inductance 2.…

A: As per the guidelines I have to do a maximum of 1 question so I request you to submit the remaining…

Q: Vp = Vs 5 = 1 D, D2 Vin = 80 V out Fin = 50 Hz %3D DA D3 RL = 330 2

Q: The two capacitors shown in the figure have been connected for some time and have reached their…

A: A capacitor is a passive element that store energy in an electric field. If n number of capacitor…

Q: Find the equivalent capacitance Ceq seen by the terminals A and B in Figure A1 as a function of C…

A: The solution is

Q: A resistor and a capacitor are connected in series with a variable inductor. When the circuit is…

Q: (c) For the circuit in Figure Q1(c), under DC condition: (i) Determine the voltage across the…

A: In steady state capacitor acts as open circuit and inductor acts as short circuit. So, using kcl,…

Q: The figure displays two circuits with a charged capacitor that is to be discharged through a…

Q: 1. What impedance vector 0 – j22 represents: A. A pure resistance. B. A pure inductance. C. A pure…

Q: 3. A 10ohms resistor and an unknown inductance is connected in series. The series combination is…

A: Transient analysis:

Q: In the figure R1 When the switch is opened after having been closed for a long time, the current in…

A: Given circuit is shown below. Given data is R1=4Ω, R2=1Ω. When switch is opened inductor current…

Q: 4.0 10.0 |3.0 a 2.0 Figure 2

A: The given circuit diagram is:

Q: 10.0 V, R1 = 4.00 N , and R2 = 1.00 N. The In the figure ɛ = inductor is ideal. If the switch is…

A: The storage elements such as capacitors & inductors have the property to store energy across…

Q: The value of the Inductance can be determined by 2El, if 'E' is energy stored in inductor and T' is…

Q: What will happen to the current in the PURE CAPACITOR if the frequency is adjusted higher? and What…

Q: 4. The current through a 10-mH inductor is 10-2A. Find the voltage and the power at t= 3s.…

A: we need to determine voltage and power at t = 3sec.

Q: Determine the current through the 260mH inductor in the circuit shown in the figure and choose the…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

8. a). What are the values of the inductor voltage and current and the capacitor voltage
and current assuming the switch has been closed for a very long time.
VL=
IL =
Vc =
Ic=
10 v
1H
V₁
000
502
HI
292
Ic↓
1F
Vc

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
List the five capacitor replacement rules.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Do all questions
12
The following figure represents an RC-Circuit with the switch. In Figure A, the capacitor is initially uncharged. In Figure B, the capacitor is initially fully charged. 1) Draw and label the current direction immediately after the switch is closed for each figure. 2) Consider Figure A. What is the voltage across the capacitor as t → 0? Explain. 3) Consider Figure B. Is the voltage across the resistor increasing, decreasing or staying the same as t → 0? Explain. A) B) R C
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
Electric Circuits / Mutual Induction Topic: I need the solution to the question
1.
For the circuit below assuming an ideal switch, preform transient analysis to predict the voltage across resistor, R2 and plot the results. The inductor will have zero current as initial condition. L1 0.005 2 U1 100mH R1 1k V1 20Vdc R2 100