8. A sample of dry ice (solid CO2) is cooled to -100 °C, and is set on a table at room temperature (25 °C). At what temperature is the rate of sublimation and deposition the same? (Assume pressure is held constant at 1 atm). Given the following data about CO2: Triple point - 57°C, 5.11 atm Critical point - 31°C, 73 atm Sublimes at -78.5°C, 1 atm The solid is the denser phase Construct a simplified phase diagram for CO2 а. b. Estimate the vapor pressure of CO2 at 0°C At 10 atm pressure and -50°C, is CO2 a liquid? Explain. С.

8. A sample of dry ice (solid CO2) is cooled to -100 °C, and is set on a table at room temperature (25 °C). At what temperature is the rate of sublimation and deposition the same? (Assume pressure is held constant at 1 atm). Given the following data about CO2: Triple point - 57°C, 5.11 atm Critical point - 31°C, 73 atm Sublimes at -78.5°C, 1 atm The solid is the denser phase Construct a simplified phase diagram for CO2 а. b. Estimate the vapor pressure of CO2 at 0°C At 10 atm pressure and -50°C, is CO2 a liquid? Explain. С.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

The rate of vaporization depends on the surface area of the liquid. However, the vapor pressure of a liquid does not depend on the surface area. Explain.
Practice Example A: With as much detail as possible, describe the phase changes that would occur if a sample of water represented by point R in Figure 12-30 were brought first to point P and then to point Q.
Molecular Solid: A solid material primarily held in this phase by intermolecular forces causing attraction between the molecules. True False
REFER TO IMAGE
The pressure above a pure sample of solid Substance X at -5. °C is lowered. At what pressure will the sample melt? Use the phase diagram of X below to find your answer. 0.8- solid ol liquid 0.4 18 Ar gas 0. 200 400 600 temperature (K) Note: your answer must be within 0.05 atm of the exact answer to be graded correct. D atm pressure (atm)
Which property of a liquid increases with increases temperature? vapor pressure surface tension O viscosity
REFER TO IMAGE
What phase changes will take place when water is subjected to increasing pressure at a constant temperature of 0.0 °C? Pressure (kPa) 22,089 101 0.6 Ice (solid) A I D O deposition and condensation O freezing and deposition O boiling and freezing O deposition and melting T 1 Triple point B 0 0.01 Water (liquid) Water vapor (gas) 100 Temperature (°C) Critical point C I 374
List four distinctions between crystalline and amorphous solids with one example of each.
Consider the following data for a substance: Critical point: 119.1 atm and 567°C Triple point: 0.101 atm and 112°C Normal melting point: 1.00 atm and 123°C What is the normal boiling point of the substance? Enter your answer in units of °C three significant figures.