8. (a) An angle modulated signal with carrierfrequency w. = 2n x 10° rad/sec is givenas follow :OpM () = 10cos (w̟t +5sin(3000t) +10sin (2000t)}:(i) Find power of modulated signal.fii) Find the maximum frequencydeviation.(iii) Finddeviation. ..maximum phase(iv) Estimate the bandwidth of FMsignal.

The solution can be achieved as follows.

8. (a) An angle modulated signal with carrier frequency w. = 2a x10° rad/sec is given as follow : OrM () = 10 cos (w.t + 5sin(3000t) + 10sin (2000t)) (i) Find power of modulated signal. (ii) Find the maximum deviation: frequency (iii) Find the maximum phase deviation. (iv) Estimate the bandwidth of FM signal.

8. (a) An angle modulated signal with carrier frequency w. = 2a x10° rad/sec is given as follow : OrM () = 10 cos (w.t + 5sin(3000t) + 10sin (2000t)) (i) Find power of modulated signal. (ii) Find the maximum deviation: frequency (iii) Find the maximum phase deviation. (iv) Estimate the bandwidth of FM signal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

a modulating signal has a PSO of -W² 202 S,(w) . lwl, e7o. the effective bandwidth B of mct) is that band width which Contains. n% of its total power. Determine which of the angle modultons is superior if 2=98% .
A. Suppose that a modulated signal x(t) is created by taking a baseband signal and mixing it with a 250 Hz cosine signal, resulting in the passband spectrum X(f) shown below. Suppose that the modulated signal x(t) is mixed with a 200 Hz cosine signal c(t). The spectrum of the 200 Hz cosine is shown below as C(f). (Please look at the picture.) Which of the spectra above is the spectrum of the after mixing x(t) and c(t)? (Please pick among the choices in the picture) ============================================= B. Please look at the 2nd picture. Need help. Thank you.
Given that the maximum and minimum values of the envelope of an AM modulated sinusoidal signal are 3.5 V and 0.9 V, respectively, what would be the modulation index? Note that there is no over-modulation in this case.
digital communicationA signal was represented using Bipolar RZ with a bandwidth of 40 kHz, then thebandwidth will be …………. If Bipolar NRZ was used.
all 4
1. The CT signal x(1)-6cos (800zt) + 8cos² (mæt) is eritically sampled (Nyquist rate) by f-8000 Hz. Find: i. The value of m. ii. The frequency components of the signal. The frequency resolution (A) of the output spectrum if the sampled signal is processed by 32point-DFT. iii. iv. Define frequency resolution.
(B) The signal Vin(t)-2Cos(2nfit)+2Cs (2nfat), passes through a square-law device where the output signal Voft) is given by V-(Vin)2 and fi-2 KHz and f-6KHz. Calculate the average power at the output of the square-law device.
(1-4) A sinusoid of the frequency 2100 Hz is sampled at the rate 8/7 samples per baseband cycle. (a) In time domain, draw one cycle of this sinusoid, the corresponding samples, and the reconstructed signal. What is the frequency of the reconstructed signal? (b) In frequency domain, draw this sinusoid, the corresponding samples, and the reconstructed signal. ?. (1-5) The signal r(t) = 100 sin(100)+75c(100m) in
Discuss in detail about the narrowband noise and analyze the properties of in- phase and quadrature components of narrow band noise.