8 The following data are obtained from the current meter gauging of a stream, at a gauging sta-tion. Compute the stream discharge.Distance from oneDepth of water, dImmersion of current meterbelow water surfaceend of water surface(m)(m)depth (m)rev001.00.6102.20.44361.762064.00.80403.203088.01.6466.433104.20.84333.3629122.50.50342.0029141.20.7216160Rating equation of current meter: v = 0.2 N + 0.04, where N = rev./sec, v =ANO24sec404850575359575149525348velocity (m/sec).

Answered: Image /qna-images/answer/60fbd094-ec6a-459d-9251-1a2bc6c9f047.jpg

Answered: 8 The following data are obtained from…

8 The following data are obtained from the current meter gauging of a stream, at a gauging sta- tion. Compute the stream discharge.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Determine the discharge of a flowing fluid from a nozzle, whose specific gravity is 1.3, the nozzle…

Q: Estimate in (m/sec) se= 1572o Pa し-30.48 n = O-000045 M= 0.01 Pa.s 1: 1200

A: step 1-

Q: Assuming a steady flow through a switch. Find the time required for 30 C to flow if the current is…

Q: Problem 5.5 One field party measured the following data (Table 5.12) using the current metering…

Q: Assignment 2 Online: (CLO 2) Plot Discharge Vs Depth graph for a rectangular channel for any given…

Q: Oil (SG = 0.9) flows downward through a vertical pipe contraction as shown in the figure below. If…

A: The specific gravity of the oil = 0.9▪︎ The specific gravity of the manometric liquid i.e. mercury =…

Q: 13. A3 m wide rectangular channel conveys 12 m/s of water at a depth of 2 m. Calculate: (1) Specific…

A: Given, Width of channel (b) = 3m Normal depth = y= 2m Discharge (Q)=12 m³ /sec q= Q/b= 12/3 = 4m²/s…

Q: The Reynolds number for the current in a pipe is 10°. If the relative roughness is 2.103, using the…

A: Reynolds number, Re=100.Relative roughness = 2.103It is asked to determine the roughness coefficient…

Q: The following data were collected for two verticals in a stream at a gauging station. Compute the…

A: Stream gauging is a method for measuring a stream's discharge, or the amount of water passing…

Q: 9) Given the pump curve below and a system head curve of hp = 88 + 15.1 Q², where hp is in ft and Q…

A: pump curve is given as follows

Q: he data pertaining to a stream-gauging site are given below. The rating equation of the current…

A: For the last and first section using equation average width = W¯=w1+W22)22w1 For the rest of the…

Q: Performance data for a small commercial pump are as follows: Q. gal/min Н, й 0 | 10 | 20 30 40 50 60…

A: Given:

Q: -12/Compute the flow rate of irrigation water Q to

Q: 3) Air flows from left to right as shown. Which figure shows the correct manometer fluid level and…

Q: what diometer of new cast iron pipe to discharge 120 liters / sec of water with a of not more than I…

Q: View Policies Current Attempt in Progress Water is pumped from a tank, point (1), to the top of a…

Q: Head Loss (m) 10.0 9.0 8.0 7.0 6.0 5.0 4.0 3.0

A: The loss coefficient for a gate valve, also known as the "flow coefficient" or "resistance…

Q: * In figure, from data find the velocity in the opening (jet)? by ft/s 100 mm dia. age

A: Given, H = 750 mm or 0.75 m

Q: Compute the discharge.

A: Mean velocity is either velocity at 0.6d or average velocity of 0.2d and 0.8 d velocities. Velocity…

Q: Determine static indeterminacy

A: Given data: Number of members, (m)=13 Number of external support reaction, (R)=2+1=3 Number of…

Q: 1. Find the discharge of water flowing over a rectangular notch of 1.5 m length when the constant…

Q: Find the missing flow values in pipes 2, 7, 8; and the input and output values to the network shown.…

A: Given Data: Pipe Flow m3/s K 01 0.144 160 02 ? 185 03 0.056 752 04 0.048 1515 05 0.096…

Q: Decimal Places required in the final answer: 3 El 100m A El 82m B 1500 m, 450 mm, f 0.0225 Q.500 m,…

Q: 2 in. by 6 in., is installed in a vertical pipe line carrying water. A differential manometer…

A: Given:- 12 in by 6 in gauge levels=2.50ft Venturi coefficient =0.97 To find:- actual discharge

Q: For Slow nate 28 Lis Find EL. 60M pump Power 4ち0 El. 30M

Q: A 1⁄2-horsepower (372.85-watt) compressor motor has 3.24 amperes ofcurrent flowing through it when…

A: Given:- The power of the compressor motor = 1⁄2-horsepower = 372.85-watt The current flowing through…

Q: a detailed estirntion Per 2000 m le ngt h for the vongete drain 6i4:5) Phol Brtion having the…

Q: Q3: A) The following data were collected for a stream at a gauging station. Compute the discharge.…

A: Given-Equation for current meter-V= 0.35N+0.025where,N=rps, v= velocity (m/sec)To find-Discharge,…

Q: Problem 3. Find the manometer reading in the lossless system shown. Ans h=11u ft eft Water 25t…

A: To Determine Manometer reading in the lossless system.

Q: Water is pumped from a tank, point (1), to the top of a water plant aerator, point (2), as shown in…

Q: Question 3 Calculate the critical depth corresponding to a discharge of 8.5m³/sec in a rectangular…

Q: Rainwater flows through the galvanized iron downspout shown in the figure below at a rate of 0.009…

A: To determine:The value of D

Q: (a) (b) (c) Write the equation of motion Determine the natural frequencies Determine the modes for…

Q: The following figure and table contains the water levels of the reservoirs in the system and the…

Q: Water flows steadly from the large open tank shown below. if viscous effects are negigble, determine…

A: We know velocity from tank filled with water is given byv=2gz1-z2so,z1-z2=4m

Q: (67) The water tank shown is filled by pumping water from the well where the water level is located…

Q: Find the distance between the property shown in the figure below and the road right of way. EP ROW…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

8 The following data are obtained from the current meter gauging of a stream, at a gauging sta-
tion. Compute the stream discharge.
Distance from one
Depth of water, d
Immersion of current meter
below water surface
end of water surface
(m)
(m)
depth (m)
rev
0
0
1.0
0.6
10
2.2
0.44
36
1.76
20
6
4.0
0.80
40
3.20
30
8
8.0
1.6
46
6.4
33
10
4.2
0.84
33
3.36
29
12
2.5
0.50
34
2.00
29
14
1.2
0.72
16
16
0
Rating equation of current meter: v = 0.2 N + 0.04, where N = rev./sec, v =
ANO
2
4
sec
40
48
50
57
53
59
57
51
49
52
53
48
velocity (m/sec).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

table T represents the vertical coordinates of the 12-hour standard hydrograph, Muhammad the coordinates vertical for 6 hour standard hydrograph then select 1- The value of the vertical coordinate for 6 hours of standard hydro fortuner at 12 hours of elevation 2-The value of the vertical coordinate of 6 hours standard hydrograph at the time of 30 hours -The value of the vertical coordinate for the 6-hour meter and the standard fortune teller at the 48-hour time. for atme 42 36 30 24 18 12 6 0 153 150 136 111 76 37 10 0 48 146 ace) The court 12 UH (m3/s)
Jane 3
2. A venturimeter is used to determine the flow of water through the reading of a manometer connected through it (Figure 1). Figure 1: Schematic diagram of a venturimeter. 15p7 The relationship between the pressure drop and flow rate is as follows: P – P, = - 24 Where, V = Volumetric flow rate of water. P1, P2= Pressure at point 1 and point 2 respectively. p= Density of the fluid, and Ai= Area at point 1. Data: Density of water = 1000 kg/m³. Diameter if inlet pipe = 2 m.
The Best Efficiency Point is the point in a pump curve that coincides with its maximum flow rate. True False
9.99. Calculate magnitude and direction of manometer reading. CC14 0.25 m & Problem 9.99 -0.75 m- -V 3 m/s 25 mm d f 0.020 Mercury-
Problem-7. The head over a V-notch at the end of a channel is 75 cm. If an error of 0.15cm is possible in the measurement of the head, then the percentage error in computing the discharge is.
Other than current Meter method what other method can be used to measure Discharge. Explain the method
The following are the data obtained in a stream gauging operation. A current meter with a calibration equation V = (0.32 N + 0.032) m/sec was used to measure the velocity at 0.6 depth. Using the mid-section method, calculate the discharge in stream. Distance from the right bank Depth 0 2 4 6 9 12 15 18 20 22 23 24 0 0.5 1.10 1.95 2.25 1.85 1.75 1.65 1.50 1.25 0.75 0 No. of revolutions 0 80 83 131 139 121 114 109 92 85 70 0 Time (Sec) 0 180 120 120 120 120 120 120 120 120 150 0
Pls answer within 10 mins. Ty
Asap plzzz
Convert 1.25 kg,/cm? abs to psig. O 3.04 :3.08 03.11 3.02
Question- The head over a V-notch at the end of a channel is 75cm. If an error of 0.15cm is possible in the measurement of the head then percentage error in computing discharge is