77. Asketch of a manufactured part is given below the drawing. Sketch the planes of a datum reference frame in all of the views of the manufactured part. Label each of the datum planes that make up the datum reference frame and note the number of points of contact required with the feature surface. Complete the sketch based on a feature control frame that references datum feature A primary, B secondary, and C tertiary. 스028시 HB Drawing Manufactured part

Q: ·50 70- 1.80 .60 .60 .8 .40 4.00 1.00 1.00 1.80 ANGLE STOP .50 40 1.60 .50 2.20 .50 1.20 .60 .80…

A: Draw the top, front and the right side view of the given figure.

Q: QUESTION 10 0 1 m 0.3 m 70° 1 m 4 kN 0.5 m 1.5 m 15 kN m 10 KN 6 kN 0.3 m Replace the three…

A: Given Data The Force acting at the point 1 m from O A is: FA=4 kN The force acting at the point B 2…

Q: 13. User tool frame UT[3] was set up by the programmer with three-point method for UT setup provided…

A: Given: User tool frame with 3 point method is setup To find: correct statements

Q: 00

A: Given data

Q: 1. Sketch the CAVALIER OBLIQUE of the given object. Use corner "A" for orientation.

A: according to the details provided in the question, we need to draw a cavalier view of the given…

Q: The three planes of 'orthographic' projection of an object are presented in Figure 1.1 below. Draw…

A: Draw the isometric block according to dimensions of the object as shown in the image:

Q: Galileo's first telescope used the arrange- ment shown in the figure to the right, with a…

A: The given lens arrangement is that of galileo telescopic lens. the ray diagram depicting that final…

Q: 21. The programmer uses three-point method for UT[2] setup for a sharp-tip pointer. If the…

A: Given: User frame setup using 3 point method To find: correct option

Q: 21 - A new piece of production machinery has the following costs: Investment cost = $35,000 Annual…

A: Given:To find:Calculate the marginal cost.

Q: 9. A Coordinate frame, {A} is located at the base of a robot manipulator. Frame {B} describes the…

A: There are two operations done here.First operation is translation/displacment.Second operation is…

Q: A datum reference frame consists of three mutually perpendicular [Select] and three mutually…

A: A datum reference frame is a coordinate reference system, It is used define tolerance and dimensions…

Q: Feature orientation is controlled by the O tertiary O primary O secondary O final datum feature.

A:

Q: Don't use chatgpt will upvote

A:

Q: On the part shown, specify a geometric control to make the left surface in the front view…

A: